Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Average tablet weight

Grind or mill 20 tablets into a fine powder and transfer the powder equivalent to the average tablet weight into a 100-mL volumetric flask. [Pg.140]

Specifications used by quality control to release drug A are found in a laboratory procedure. In addition to the previously discussed hardness and disintegration time requirements, the procedure calls for determining the average tablet weight by the United States Pharmacopeia (USP) procedure that is, 20 individual tablets are weighed. [Pg.80]

Drying time and method Average tablet weight (ATW)... [Pg.80]

Figure 7 (A) x-control chart of drug B average tablet weight (core stage). (B) X-control chart of average coated tablet weight for drug B. Figure 7 (A) x-control chart of drug B average tablet weight (core stage). (B) X-control chart of average coated tablet weight for drug B.
UTL Upper tolerance limit of average tablet weight 103.0... [Pg.3625]

UCL Upper control limit of average tablet weight 101.5... [Pg.3625]

Increase or decrease the force control setpoint to increase or decrease the tablet weight, respectively. The new force control set point is calculated by means of the machine manufacturer s control algorithm. Typically after adjustment to the new force control set point, the weight control system should resample and verify that the average tablet weight is now within the average control limits. [Pg.3627]

If during any check the average tablet weight exceeds the average tolerance limits (below 97 mg and above 103 mg) or an individual tablet exceeds the individual tolerance limits (below 95 mg and above 105 mg), the machine will shut off and reject the tablets. It is important to note that individual tablet weights exceeding the tolerance limits indicate that the tablet rejection system is not functioning properly. [Pg.3627]

ATW = average tablet weight, QS = fill to volume, extraction solvent = 50% ACN in 0.1NHC1, MPA = mobile phase A. [Pg.270]

See other pages where Average tablet weight is mentioned: [Pg.126]    [Pg.84]    [Pg.89]    [Pg.111]    [Pg.167]    [Pg.167]    [Pg.169]    [Pg.3625]    [Pg.3625]    [Pg.3625]    [Pg.3627]    [Pg.3627]    [Pg.140]    [Pg.408]    [Pg.223]    [Pg.491]   


SEARCH



© 2024 chempedia.info