Diols asymmetric

Asymmetric diols synthesis from olefins over the hybrid catalyst of TI-MCM4I and Co(lll) Salen complexes. 

A new development is that electrochemical oxidation of ferrocyanide to ferricyanide can be coupled with AD to give a very efficient electrocatalytic process [37]. Under these conditions, the amount of potassium ferricyanide needed for the reaction becomes catalytic and Eqs. 6D.6 and 7 can be added following Eq. 6D.4. Summation of Eq. 6D.1-6D.4, 6D.6, and 6D.7 gives 6D.8, showing that only water in addition to electricity is needed for the conversion of olefins to asymmetric diols and that hydrogen gas, released at the cathode, is the only byproduct of this process. In practice, sodium ferrocyanide is used in the reaction and the amount of this reagent used in comparison with the potassium ferricyanide method mentioned above has been reduced from 3.0 equiv. to 0.15 equiv. (relative to an equivalent of olefin). 

Scheme 2. Representation of positional isomerism in polyesters of symmetric diacid HO—(HTH)—OH and asymmetric diol.

The first practical method for asymmetric epoxidation of primary and secondary allylic alcohols was developed by K.B. Sharpless in 1980 (T. Katsuki, 1980 K.B. Sharpless, 1983 A, B, 1986 see also D. Hoppe, 1982). Tartaric esters, e.g., DET and DIPT" ( = diethyl and diisopropyl ( + )- or (— )-tartrates), are applied as chiral auxiliaries, titanium tetrakis(2-pro-panolate) as a catalyst and tert-butyl hydroperoxide (= TBHP, Bu OOH) as the oxidant. If the reaction mixture is kept absolutely dry, catalytic amounts of the dialkyl tartrate-titanium(IV) complex are suflicient, which largely facilitates work-up procedures (Y. Gao, 1987). Depending on the tartrate enantiomer used, either one of the 2,3-epoxy alcohols may be obtained with high enantioselectivity. The titanium probably binds to the diol grouping of one tartrate molecule and to the hydroxy groups of the bulky hydroperoxide and of the allylic alcohol... 

The reaction of a halide with 2-butene-1,4-diol (104) affords the aldehyde 105, which is converted into the 4-substituted 2-hydroxytetrahydrofuran 106, and oxidized to the 3-aryl-7-butyrolactone 107[94], Asymmetric arylation of the cyclic acetal 108 with phenyl triflate[95] using Pd-BINAP afforded 109, which was converted into the 3-phenyllactone 110 in 72% ee[96]. Addition of a molecular sieve (MS3A) shows a favorable effect on this arylation. The reaction of the 3-siloxycyclopentene 111 with an alkenyl iodide affords the. silyl... 

Meyers has also reported the use of chiral oxazolines in asymmetric copper-catalyzed Ullmann coupling reactions. For example, treatment of bromooxazoline 50 with activated copper powder in refluxing DMF afforded binaphthyl oxazoline 51 as a 93 7 mixture of atropisomers diastereomerically pure material was obtained in 57% yield after a single recrystallization. Reductive cleavage of the oxazoline groups as described above afforded diol 52 in 88% yield. This methodology has also been applied to the synthesis of biaryl derivatives. 

Asymmetric bias generated by protected vicinal diol controller and its application to asymmetric nitrone-olefin cycloaddition reactions 98YGK86. 

Trost and co-workers have explored asymmetric transidon metal-catalyzed allylic alkyla-dons. Details on this subject have been well reviewed by Trost and others. With the use of asymmetric palladium-catalyzed desymmetrizadon of meso-2-ene-l,4-diols, cii -l,4-dibenzoy-loxy-2-cyclopentene can be converted to the enandometrically pure cii -4-rfirr-butoxycar-bamoyl-l-methoxycarbonyl-2-cyclopentene. The product is a usefid and general building block for synthesis of carbocyclic analogs of nucleosides as presented in Scheme 5.12. 

The synthesis of the polyol glycoside subunit 7 commences with an asymmetric aldol condensation between the boron enolate derived from imide 21 and a-(benzyloxy)acetaldehyde (24) to give syn adduct 39 in 87 % yield and in greater than 99 % diastereomeric purity (see Scheme 8a). Treatment of the Weinreb amide,20 derived in one step through transamination of 39, with 2-lithiopropene furnishes enone 23 in an overall yield of 92 %. To accomplish the formation of the syn 1,3-diol, enone 23 is reduced in a chemo- and... 

The interest in asymmetric synthesis that began at the end of the 1970s did not ignore the dihydroxylation reaction. The stoichiometric osmylation had always been more reliable than the catalytic version, and it was clear that this should be the appropriate starting point. Criegee had shown that amines, pyridine in particular, accelerated the rate of the stoichiometric dihydroxylation, so it was understandable that the first attempt at nonenzymatic asymmetric dihydroxylation was to utilize a chiral, enantiomerically pure pyridine and determine if this induced asymmetry in the diol. This principle was verified by Sharpless (Scheme 7).20 The pyridine 25, derived from menthol, induced ee s of 3-18% in the dihydroxylation of /rcms-stilbene (23). Nonetheless, the ee s were too low and clearly had to be improved. 

To extend the scope of asymmetric transannular C-H insertions, more highly functionalized medium-sized cyclic epoxides have been investigated. A triad of cydooctene oxides 34, 36, and 38, possessing protected diol units, gave the expected alcohols 35, 37, and 39 (Scheme 5.10) [17, 18] an asymmetric synthesis of (-)-xialenon A has been achieved starting from alcohol 39 [19]. In comparison,... 

An alternative method for generating enriched 1,2-diols from meso-epoxides consists of asymmetric copolymerization with carbon dioxide. Nozaki demonstrated that a zinc complex formed in situ from diethylzinc and diphenylprolinol catalyzed the copolymerization with cyclohexene oxide in high yield. Alkaline hydrolysis of the isotactic polymer then liberated the trans diol in 94% yield and 70% ee (Scheme 7.20) [40]. Coates later found that other zinc complexes such as 12 are also effective in forming isotactic polymers [41-42]. 

Following Uskokovic s seminal quinine synthesis [40], Jacobsen has very recently reported the first catalytic asymmetric synthesis of quinine and quinidine. The stereospecific construction of the bicyclic framework, introducing the relative and absolute stereochemistry at the Cg- and expositions, was achieved by way of the enantiomerically enriched trans epoxide 87, prepared from olefin 86 by SAD (AD-mix (3) and subsequent one-pot cyclization of the corresponding diol [2b], The key intramolecular SN2 reaction between the Ni- and the Cg-positions was accomplished by removal of the benzyl carbamate with Et2AlCl/thioanisole and subsequent thermal cyclization to give the desired quinudidine skeleton (Scheme 8.22) [41],... 

When asymmetric epoxidation of a diene is not feasible, an indirect route based on asymmetric dihydroxylation can be employed. The alkene is converted into the corresponding syn-diol with high enantioselectivity, and the diol is subsequently transformed into the corresponding trans-epoxide in a high-yielding one-pot procedure (Scheme 9.5) [20]. No cpirricrizalion occurs, and the procedure has successfully been applied to natural product syntheses when direct epoxidation strategies have failed [21]. Alternative methods for conversion of vicinal diols into epoxides have also been reported [22, 23]. 

This strategy can be applied to the synthesis of vinylepoxides, since high enantioselectivity and good regioselectivity can often be obtained in asymmetric dihydroxylation of dienes, resulting in vinylic diols [24, 25], Transformation of the diols into epoxides thus represents an alternative route to vinylepoxides. This strategy was recently employed in the synthesis of (+)-posticlure (Scheme 9.6) [26]. 

The cyclohexyloxy(dimethyl)silyl unit in 8 serves as a hydroxy surrogate and is converted into an alcohol via the Tamao oxidation after the allylboration reaction. The allylsilane products of asymmetric allylboration reactions of the dimethylphenylsilyl reagent 7 are readily converted into optically active 2-butene-l, 4-diols via epoxidation with dimethyl dioxirane followed by acid-catalyzed Peterson elimination of the intermediate epoxysilane. Although several chiral (Z)-y-alkoxyallylboron reagents were described in Section 1.3.3.3.3.1.4., relatively few applications in double asymmetric reactions with chiral aldehydes have been reported. One notable example involves the matched double asymmetric reaction of the diisopinocampheyl [(Z)-methoxy-2-propenyl]boron reagent with a chiral x/ -dialkoxyaldehyde87. 

---