Allylic alcohols homoallylic

TABLE 11.1. KINETIC DATA IN THE FORM OF RELATIVE REACTION RATES Terminal Allylic Alcohols Internal Allylic Alcohols Homoallylic Alcohols... 

Finally, the regio- and stereoselectivities of the intramolecular hydrosilylation of allyl alcohols, homoallyl alcohols, and allylamlnes are summarized in Scheme 1. While these results have been obtained with the dimethylsilyl (HMe2Si) group in the presence of a platinum catalyst, stereoselectivity, but not regioselectivity, can be controlled by other silyl groups such as the diphenyl (HPh2Si) or di(isopropyl)silyl [H(i-Pr)2Si] groups. 

A major limitation to the Sharpless-Katsuki epoxidation is that its utility is largely confined to oxidation of allylic alcohols. Homoallylic alcohols are oxidized less cleanly and the oxidation of simple olefins shows little enantio-selectivity. This is presumably because the stereochemical control depends on anchoring the substrate to a particular site on the metal by means of an auxiliary coordinating function. 

The reaction has been investigated with MeOH, - z-PrOH, - t-BuOH, " phenols, " cyclic allylic alcohols, - homoallylic alcohols, 3,4-hydroxybenzoate, and mono Z-butyldimethyl-silyl protected diols. A subsequent Homer-Wadsworth-Emmons olefination with a range of aldehydes affords the corresponding enol ethers. ... 

The zinc-based Simmons-Smith type procedures frequently require rather harsh conditions in order to provide acceptable cyclopropane yields. Also, the discrimination between allylic alcohols, homoallylic alcohols and olefins without a hydroxyl group is often not very pronounced. These drawbacks are avoided by a new method which substitutes samarium metal (or samarium amalgam) for zinc (Table 4)43. This cnahlcs only allylic alcohols to be cyclo-propanated under very mild conditions, even for highly crowded substrates. The hydroxy-directed diastereofacial selectivity is good to excellent for cyclic olefins. Due to this property, the method has been applied to the stereoselective synthesis of 1,25-dihydroxycholecalciferol44. 

Beller and coworkers [142] broadened these investigations to include several other terminal-functionalized and nonfunctionalized olefins as substrates (allyl alcohols, homoallyl alcohols, allylamines, homoallylamines, vinyl cyclohexane, 3-arylprop-l-enes). For example, in a basic medium, Fe3(CO)j2 converted 1-octene cleanly into 2-octene (Scheme 5.31). Moreover, Z-2-octene was converted into the corresponding -isomer. Temperatures of80-100 °C were required to achieve nearly quantitative yields. 

Regioselective Hydrogenation- allylic and homoallylic alcohols are hydrogenated faster than isolated double bonds... 

The alkenyloxirane 126 in excess reacts with aryl and alkenyl halides or triflates in the presence of sodium formate to afford the allylic alcohol 127[104], Similarly, the reaction of the alkenyloxetane 128 gives the homo-allylic alcohol 130[105]. These reactions can be explained by insertion of the double bond in the Ar—Pd bond, followed by ring opening (or /3-eliraination) to form the allylic or homoallylic alkoxypalladium 129, which is converted into the allylic 127 or homoallylic alcohol 130 by the reaction of formate. The 3-alkenamide 132 was obtained by the reaction of the 4-alkenyl-2-azetizinone 131 with aryl iodide and sodium formate [106]. 

Furthei-more, the cyclization of the iododiene 225 affords the si.x-membered product 228. In this case too, complete inversion of the alkene stereochemistry is observed. The (Z)-allylic alcohol 229 is not the product. Therefore, the cyclization cannot be explained by a simple endo mode cyclization to form 229. This cyclization is explained by a sequence of (i) e.vo-mode carbopallada-tion to form the intermediate 226, (ii) cydopropanation to form 227. and (iii) cyclopropylcarbinyl to homoallyl rearrangement to afford the (F3-allylic alcohol 228[166]. (For further examples of cydopropanation and endo versus e o cyclization. see Section 1.1.2.2.)... 

The four-membered vinyloxetane 280 is cleaved with Pd(0j and used for allylation a homoallylic alcohol unit can be introduced into the keto ester 281 as a nucleophile with this reagent to form 282[168],... 

Organoboranes are reactive compounds for cross-coupling[277]. The synthesis of humulene (83) by the intramolecular cross-coupling of allylic bromide with alkenylborane is an example[278]. The reaction of vinyiborane with vinyl-oxirane (425) affords the homoallylic alcohol 426 by 1,2-addition as main products and the allylic alcohol 427 by 1,4-addition as a minor product[279]. Two phenyl groups in sodium tetraphenylborate (428) are used for the coupling with allylic acetate[280] or allyl chloride[33,28l]. 

The Pd-catalyzed hydrogenolysis of vinyloxiranes with formate affords homoallyl alcohols, rather than allylic alcohols regioselectively. The reaction is stereospecific and proceeds by inversion of the stereochemistry of the C—O bond[394,395]. The stereochemistry of the products is controlled by the geometry of the alkene group in vinyloxiranes. The stereoselective formation of stereoisomers of the syn hydroxy group in 630 and the ami in 632 from the ( )-epoxide 629 and the (Z)-epoxide 631 respectively is an example. 

Employing protocol V with the methanesulfonamide catalyst 122, a 93 7 er can be obtained in the cyclopropanation of cinnamyl alcohol. This high selectivity translates well into a number of allylic alcohols (Table 3.12) [82]. Di- and tri-substi-tuted alkenes perform well under the conditions of protocol V. However, introduction of substituents on the 2 position leads to a considerable decrease in rate and selectivity (Table 3.12, entry 5). The major failing of this method is its inability to perform selective cyclopropanations of other hydroxyl-containing molecules, most notably homoallylic alcohols. 

Pineschi and Feringa reported that chiral copper phosphoramidite catalysts mediate a regiodivergent kinetic resolution (RKR) of cyclic unsaturated epoxides with dialkylzinc reagents, in which epoxide enantiomers are selectively transformed into different regioisomers (allylic and homoallylic alcohols) [90]. The method was also applied to both s-cis and s-trans cyclic allylic epoxides (Schemes 7.45 and 7.46,... 

Sulfonic peracids (66) have also been applied recently to the preparation of acid sensitive oxiranes and for the epoxidation of allylic and homoallylic alcohols, as well as relatively unreactive a, p - unsaturated ketones. These reagents, prepared in situ from the corresponding sulfonyl imidazolides 65, promote the same sense of diastereoselectivity as the conventional peracids, but often to a higher degree. In particular, the epoxidation of certain A -3-ketosteroids (e.g., 67) with sulfonic peracids 66 resulted in the formation of oxirane products (e.g., 68) in remarkably high diastereomeric excess. This increased selectivity is most likely the result of the considerable steric requirements about the sulfur atom, which enhances non-bonded interactions believed to be operative in the diastereoselection mechanism <96TET2957>. 

Ruthenium complexes containing this ligand are able to reduce a variety of double bonds with e.e. above 95%. In order to achieve high enantioselectivity, the reactant must show a strong preference for a specific orientation when complexed with the catalyst. This ordinarily requires the presence of a functional group that can coordinate with the metal. The ruthenium-BINAP catalyst has been used successfully with unsaturated amides,23 allylic and homoallylic alcohols,24 and unsaturated carboxylic acids.25... 

Several strategies have been proposed to improve the regioselectivity of nitrile oxide cycloaddition. Kanemasa and coworkers have reported high-rate acceleration and regioselectivity in nitrile oxide cycloadditions to the magnesium alkoxides of allylic and homoallylic alcohols (Eq. 8.64)."... 

Scheme 11). This kind of catalyst is regioselective, the remote C=C being unaffected, thus indicating that the allylic alcohol group provides a necessary secondary coordination during the cycle. Further confirmation comes from the evidence that extension of the carbon chain by just one more carbon, with respect to homoallylic alcohols, results in no reaction. 

Ti-DAT catalyst is not very efficient for the epoxidation of homoallylic alcohols40 and /-allylic alcohols.4""8 The epoxidation of some of such substrates has been effected by using a Zr-tartramide41 or Zr-tartrate42 complex as catalyst (Scheme 5). 

The grem-dibromocyclopropanes 152 bearing a hydroxyalkyl group, prepared by the addition of dibromocarbene to allylic or homoallylic alcohols, undergo an intramolecular reductive carbonylation to the bicyclic lactones 153. bicyclic lactone derived from prenyl alcohol is an important precursor for the synthesis of ris-chrysanthemic acid. (Scheme 54)... 

A more convenient, but less general, synthesis of diorganozincs from olefins is the nickel-catalyzed hydrozincation, shown in Scheme 6. The yields (40-63%) are independent of the amount of diethylzinc added, but dependent on the nature of the olefin. For allylic and homoallylic alcohols and amines, yields as high as 85-95% are possible.32,33... 

Striking examples of this phenomenon are presented for allyl and homoallyl alcohols in Eqs. (5) to (7). The stereodirection in Eq. (5) is improved by a chiral (+)-binap catalyst and decreased by using the antipodal catalyst [60]. In contrast, in Eq. (6) both antipode catalysts induced almost the same stereodirection, indicating that the effect of catalyst-control is negligible when compared with the directivity exerted by the substrate [59]. In Eq. (7), the sense of asymmetric induction was in-versed by using the antipode catalysts, where the directivity by chiral catalyst overrides the directivity of substrate [52]. In the case of chiral dehydroamino acids, where both double bond and amide coordinate to the metal, the effect of the stereogenic center of the substrate is negligibly small and diastereoface discrimination is unsuccessful with an achiral rhodium catalyst (see Table 21.1, entries 9 and 10) [9]. 

Enantioselective hydrogenation of unsaturated alcohols such as allylic and homoallylic alcohols was not very efficient until the discovery of the BINAP-Ru catalyst. With Ru(BINAP)(OAc)2 as the catalyst, geraniol and nerol are successfully hydrogenated to give (S)- or (R)-citronellol in near-quantitative yield and with 96-99% ee [3 c]. A substratexatalyst ratio (SCR) of up to 48 500 can be applied, and the other double bond at the C6 and C7 positions of the substrate is not reduced. A high hydrogen pressure is required to obtain high enantioselec-... 

Use of poly(octamethylene tartrate) in place of dialkyl tartrates offers practical utility since the branched polymers yield hetereogeneous Ti complex catalysts which can be removed by filtration. Overall the work-up procedure is considerably simplified relative to the conventional Sharpless system. In addition, significant induction is shown in the epoxidation of (Z)-allylic alcohols[7] and even with homoallylic[8] species where the dialkyltartrates give very poor results Figure 5.3. Table 5.2 is illustrative of the scope using the polymer ligand. 

Figure 5.3 Oxidation of some (Z)-allylic alcohols and some homoallylic alcohols using poly(tartrate).

---