Allyl acetates oxidation

There are also palladium-catalysed procedures for allylation. Ethyl 3-bromo-l-(4-methylphenylsulfonyl)indole-2-carboxylate is allylated at C3 upon reaction with allyl acetate and hexabutylditin[27], Ihe reaction presumably Involves a ir-allyl-Pd intermediate formed from the allyl acetate, oxidative addition, transmetallation and cross coupling. 

In contrast to oxidation in water, it has been found that 1-alkenes are directly oxidized with molecular oxygen in anhydrous, aprotic solvents, when a catalyst system of PdCl2(MeCN)2 and CuCl is used together with HMPA. In the absence of HMPA, no reaction takes place(100]. In the oxidation of 1-decene, the Oj uptake correlates with the amount of 2-decanone formed, and up to 0.5 mol of O2 is consumed for the production of 1 mol of the ketone. This result shows that both O atoms of molecular oxygen are incorporated into the product, and a bimetallic Pd(II) hydroperoxide coupled with a Cu salt is involved in oxidation of this type, and that the well known redox catalysis of PdXi and CuX is not always operalive[10 ]. The oxidation under anhydrous conditions is unique in terms of the regioselective formation of aldehyde 59 from X-allyl-A -methylbenzamide (58), whereas the use of aqueous DME results in the predominant formation of the methyl ketone 60. Similar results are obtained with allylic acetates and allylic carbonates[102]. The complete reversal of the regioselectivity in PdCli-catalyzed oxidation of alkenes is remarkable. 

With higher alkenes, three kinds of products, namely alkenyl acetates, allylic acetates and dioxygenated products are obtained[142]. The reaction of propylene gives two propenyl acetates (119 and 120) and allyl acetate (121) by the nucleophilic substitution and allylic oxidation. The chemoselective formation of allyl acetate takes place by the gas-phase reaction with the supported Pd(II) and Cu(II) catalyst. Allyl acetate (121) is produced commercially by this method[143]. Methallyl acetate (122) and 2-methylene-1,3-diacetoxypropane (123) are obtained in good yields by the gas-phase oxidation of isobutylene with the supported Pd catalyst[144]. 

Allylic acetates are widely used. The oxidative addition of allylic acetates to Pd(0) is reversible, and their reaction must be carried out in the presence of bases. An important improvement in 7r-allylpalladium chemistry has been achieved by the introduction of allylic carbonates. Carbonates are highly reactive. More importantly, their reactions can be carried out under neutral con-ditions[13,14]. Also reactions of allylic carbamates[14], allyl aryl ethers[6,15], and vinyl epoxides[16,17] proceed under neutral conditions without addition of bases. 

Wylation under neutral conditions. Reactions which proceed under neutral conditions are highly desirable, Allylation with allylic acetates and phosphates is carried out under basic conditions. Almost no reaction of these allylic Compounds takes place in the absence of bases. The useful allylation under neutral conditions is possible with some allylic compounds. Among them, allylic carbonates 218 are the most reactive and their reactions proceed under neutral conditions[13,14,134], In the mechanism shown, the oxidative addition of the allyl carbonates 218 is followed by decarboxylation as an irreversible process to afford the 7r-allylpalladium alkoxide 219. and the generated alkoxide is sufficiently basic to pick up a proton from active methylene compounds, yielding 220. This in situ formation of the alkoxide. which is a... 

The formation of an enamine from an a,a-disubstituted cyclopentanone and its reaction with methyl acrylate was used in a synthesis of clovene (JOS). In a synthetic route to aspidospermine, a cyclic enamine reacted with methyl acrylate to form an imonium salt, which regenerated a new cyclic enamine and allowed a subsequent internal enamine acylation reaction (309,310). The required cyclic enamine could not be obtained in this instance by base isomerization of the allylic amine precursor, but was obtained by mercuric acetate oxidation of its reduction product. Condensation of a dihydronaphthalene carboxylic ester with an enamine has also been reported (311). 

Oxidation of the steroidal olefin (XXVII) with thallium(III) acetate gives mainly the allylic acetates (XXXI)-(XXXIII) (Scheme 15), again indicating that trans oxythallation is the preferred reaction course (19). Addition of the electrophile takes place from the less-hindered a-side of the molecule to give the thallinium ion (XXVIII), which by loss of a proton from C-4 would give the alkylthallium diacetate (XXIX). Decomposition of this intermediate by a Type 5 process is probably favorable, as it leads to the resonance-stabilized allylic carbonium ion (XXX), from which the observed products can be derived. Evidence in support of the decomposition process shown in Scheme 15 has been obtained from a study of the exchange reaction between frawr-crotylmercuric acetate and thallium(III) acetate in acetic acid (Scheme 16) (142). 

Fukuzawa et al. reported that Pd-catalyzes the reaction of allylacetate, (PhSe)2 and Smfi to form allylselenide 71 (Eq. 7.52) [57]. The complex 72, which can be generated by the contact of (PhSe)2 with Pd(0) in the actual reaction mixture, was hardly active as a catalyst, indicating that the reaction proceeded via oxidative addition of allyl acetate to Pd(0) rather than oxidative addition of (PhSe)2 to Pd(0). 

Another route to the diol monomer is provided by hydroformylation of allyl alcohol or allyl acetate. Allyl acetate can be produced easily by the palladium-catalyzed oxidation of propylene in the presence of acetic acid in a process similar to commercial vinyl acetate production. Both cobalt-and rhodium-catalyzed hydroformylations have received much attention in recent patent literature (83-86). Hydroformylation with cobalt carbonyl at 140°C and 180-200 atm H2/CO (83) gave a mixture of three aldehydes in 85-99% total yield. 

In a stoichiometric reaction the 6jr-allyl)palladium complex 66 was isolated and characterized5815. In a subsequent reaction the jr-allyl complex was reacted with benzoquinone in acetic acid to give an allylic acetate, which was hydrolyzed and oxidized to theaspirone. Interestingly, a quite high diastereoselectivity for the turns methyl isomer was obtained in the palladium-mediated spirocyclization (equation 28). 

In 1996, Yamamoto et al. investigated the intramolecular Pd(0)-catalyzed reactions of allylic acetates with allenes and observed the isomerization of triene 261 to the cyclic diene 262 (Scheme 15.83) [156], The reaction probably proceeds via oxidative addition to Pd(0), insertion of the allene and return of the acetate. 

The mechanism of the Zn chloride-assisted, palladium-catalyzed reaction of allyl acetate (456) with carbonyl compounds (457) has been proposed [434]. The reaction involves electroreduction of a Pd(II) complex to a Pd(0) complex, oxidative addition of the allyl acetate to the Pd(0) complex, and Zn(II)/Pd(II) transmetallation leading to an allylzinc reagent, which would react with (457) to give homoallyl alcohols (458) and (459) (Scheme 157). Substituted -lactones are electrosynthesized by the Reformatsky reaction of ketones and ethyl a-bromobutyrate, using a sacrificial Zn anode in 35 92% yield [542]. The effect of cathode materials involving Zn, C, Pt, Ni, and so on, has been investigated for the electrochemical allylation of acetone [543]. 

More recently, using the cyclometallated iridium C,(7-benzoate derived from allyl acetate, 4-methoxy-3-nitrobenzoic acid and BIPHEP, catalytic carbonyl crotylation employing 1,3-butadiene from the aldehyde, or alcohol oxidation was achieved under transfer hydrogenation conditions [274]. Carbonyl addition occurs with roughly equal facility from the alcohol or aldehyde oxidation level. However, products are obtained as diastereomeric mixtures. Stereoselective variants of these processes are under development. It should be noted that under the conditions of ruthenium-catalyzed transfer hydrogenation, conjugated dienes, including butadiene, couple to alcohols or aldehydes to provide either products of carbonyl crotylation or p,y-enones (Scheme 16) [275, 276]. 

Scheme 20 Carbonyl allylation from the alcohol oxidation level employing isotopically labeled allyl acetate [R = p-(C02Me)C6H4]...

Allylic boronates with a wide variety of functional groups can also be obtained by the treatment of allylic acetates with pinacolatodiboron [(pin)2B2], although side products of oxidative homodimerization can be observed in some instances (Eq. 33). ... 

This electrochemical oxidation mediated by NHPI was applicable to benzylic carbons, allylic carbons, deprotection of acetals, oxidative cleavage of cyclic acetals and amide to afford benzoylated compounds, enones ", carbonyl compounds, -hydroxyethyl esters and imides, respectively (equations 31-35). 

---