Hydrometallation alkynes

In addition to the metallacycle-based mechanism depicted above, stepwise insertion pathways such as alkyne hydrometallation followed by aldehyde... 

The results shown in Scheme 26 are consistent with the mechanism shown in Scheme 27. Alkyne hydrometallation by catalytic intermediate A and... 

To probe the reaction mechanism of the silane-mediated reaction, EtjSiD was substituted for PMHS in the cyclization of 1,6-enyne 34a.5 The mono-deuterated reductive cyclization product 34b was obtained as a single diastereomer. This result is consistent with entry of palladium into the catalytic cycle as the hydride derived from its reaction with acetic acid. Alkyne hydrometallation provides intermediate A-7, which upon cw-carbopalladation gives rise to cyclic intermediate B-6. Delivery of deuterium to the palladium center provides C-2, which upon reductive elimination provides the mono-deuterated product 34b, along with palladium(O) to close the catalytic cycle. The relative stereochemistry of 34b was not determined but was inferred on the basis of the aforementioned mechanism (Scheme 24). 

In analogy to the mechanism of the palladium-catalyzed enyne cyclization, it is postulated that exposure of palladium(O) to acetic acid promotes in situ generation of hydridopalladium acetate LnPd"(H)(OAc). Alkyne hydrometallation affords the vinylpalladium complex A-10, which upon r-carbopalladation of the appendant alkyne provides intermediate B-7. Silane-mediated cleavage of carbon-palladium bond liberates the cyclized product along palladium(O), which reacts with acetic acid to regenerate hydridopalladium acetate to close the cycle (Scheme 33). 

As mostly discussed earlier. Type III alkenyl derivatives, that is, ( )-R CH= CHM(or X), are widely and satisfactorily generated by (i) alkyne hydrometallation (M = B, Zr or, in some cases, Al, etc.) (Table 3.2, Scheme 3.6), (ii) polar halogenation reactions ofalkynes (Eqs. (1), (2), and (7), Scheme 3.15), and additionally, (iii) anti bromoboration of ethyne [53] followed by Negishi coupling (Eq. (1), Scheme 3.12). On the other hand. Type IV alkenyl derivatives may be prepared by (i) Normant alkylcupration of ethyne [67, 68] (Eqs. (5) and (6), Scheme 3.11), (ii) Zr-catalyzed alkylalumination of ethyne, (iii) syn hydroboration of 1-halo-l-alkynes followed by hydride-induced inversion of configuration [59] (Scheme 3.9), (iv) hydroboration of 1-alkynes followed by brominolysis (but not iodinolysis) with inversion [95], and (v) syn hydrozirconation or syn hydroalumination of 1-boryl- or 1-silyl-l-alkynes followed by protonolysis of the C-Al or C-Zr bond [96-98]. 

Some hydrometalation reactions have been shown to be catalyzed by zirconocene. For instance, CpiZrCf-catalyzed hydroaluminations of alkenes [238] and alkynes [239] with BU3AI have been observed (Scheme 8-34). With alkyl-substituted internal alkynes the process is complicated by double bond migration, and with terminal alkynes double hydrometalation is observed. The reaction with "PrjAl and Cp2ZrCl2 gives simultaneously hydrometalation and C-H activation. Cp2ZrCl2/ BuIi-cat-alyzed hydrosilation of acyclic alkenes [64, 240] was also reported to involve hydrogen transfer via hydrozirconation. 

A variety of alternate methods for the reductive coupling of aldehydes and alkynes have been developed. A number of important hydrometallative strategies have been developed, although most of these methods require the stoichiometric formation of a vinyl metal species or metallacycle. A very attractive hydrogenative coupling method has recently been developed, and its scope is largely complementary to the nickel-catalyzed methods. A very brief overview of these methods is provided below. 

Similar reactivity is observed in the cyclization of enynes in the presence of the yttrium-based catalyst 70 and a silane reductant [53,54]. The 1,6- and 1,7-enynes 90 and 91 provide -E-alkylidene-cyclopentancs 92 and -cyclohexanes 93 in very good yield (Eq. 15, Scheme 20) [55]. These transformations likely proceed by syn hydrometallation of the 7r-basic alkyne, followed by insertion of the alkene and a-bond metathesis. The reaction of 1,6-enynes tolerated... 

Palladium complexes are effective catalysts for the reductive cydization of enyne substrates [53,54], The first report of catalytic cydization of 1,6- and 1,7-enynes 115a,b to cyclopentane 116a and cyclohexane 116b derivatives appeared in 1987 (Eq. 19) [70]. The authors proposed that the Pd(II) species 117 forms by oxidative addition of acetic acid to Pd(0) (Scheme 25). Complex 117 hydrometallates the alkyne to give 118, which cyclizes to provide... 

Similar intramolecular hydroarylations of alkynes and alkenes, which obviate the need for a halide or triflate group on the aryl ring, are now well established. Sames group screened over 60 potential catalysts and over 200 reaction conditions, and found that Ru(m) complexes and a silver salt were optimal. This process appears to tolerate steric hindrance and halogen substrates on the arene (Equations (175)—(177)). The reaction is thought to involve alkene-Ru coordination and an electrophilic pathway rather than a formal C-H activation of the arene followed by alkene hydrometallation, and advocates the necessary cautious approach to labeling this reaction as a C-H functionalization... 

In addition to transition metals, recent work has demonstrated that strong Lewis acids will catalyze the addition of silanes to alkynes in both an intra- and an intermolecular fashion.14,14a-14c The formation of vinylsilanes from alkynes is possible by other means as well, such as the synthetically important and useful silylcupration15,15a of alkynes followed by cuprate protonation to afford vinylsilanes. These reactions provide products which can be complementary in nature to direct hydrometallation. Alternatively, modern metathesis catalysts have made possible direct vinylsilane synthesis from terminal olefins.16,16a... 

For use of alkynes as nucleophilic partners in catalytic hydrometallative reductive couplings to aldehydes, see ... 

Two mechanisms are conceivable for the reaction. One involves the hydrometalation of the metal hydride at alkyne followed by reductive elimination.15 Alternatively, phosphinometalation followed by protiode-metalation can occur.16 To gain insight into the mechanism, a carbonylation... 

Yamamoto has proposed a mechanism for the palladium-catalyzed cyclization/hydrosilylation of enynes that accounts for the selective delivery of the silane to the more substituted C=C bond. Initial conversion of [(77 -C3H5)Pd(GOD)] [PF6] to a cationic palladium hydride species followed by complexation of the diyne could form the cationic diynylpalladium hydride intermediate Ib (Scheme 2). Hydrometallation of the less-substituted alkyne would form the palladium alkenyl alkyne complex Ilb that could undergo intramolecular carbometallation to form the palladium dienyl complex Illb. Silylative cleavage of the Pd-G bond, perhaps via cr-bond metathesis, would then release the silylated diene with regeneration of a palladium hydride species (Scheme 2). 

Hydrozincation is not as widely observable as that involving , A1 and Zr. This is one of the main reasons why the indirect hydrometallation-transmetallation procedures shown in Schemes 8 and 12 have been developed and used. It is nevertheless highly desirable to directly generate organozincs to be used for the Pd- or Ni-catalyzed cross-coupling from alkenes and alkynes via hydrozincation. Indeed, such reactions have been developed, as shown in Scheme 17. However, further developments are clearly desirable. 

The addition of HBr to alkynes via hydrometallation-halogenation is another important approach to vinylic halides which will be discussed elsewhere in this series (see Volume 8, Chapters 3.9-3.12). 

---