Adsorbed polymer weight, method

It is worth noting that the grafting to method is indeed experimentally simpler compared with the graft from method, but it has some limitations. It is difficult to form a stretched, dense polymer brush conformation on the substrate because of steric crowding of the surface reactive sites by the already adsorbed polymer chains. Furthermore, the thickness of the graft polymer brushes is limited by the prefixed molecular weight of the polymer in solution. 

Polyacrylamide, whether charged or not, can be detected by reactions of the amide group (67,68) however, a number of substances can interfere with the determination. If the molecular weight is high enough, flocculation of a standard slurry of clay or other substrate is a sensitive method for detecting low levels of polyacrylamide (69). Once polymers are adsorbed on a surface, many of these methods caimot be used. One exception is the use of a labeled polymer. 

Effect of PVA Molecular Weight on Adsorbed Layer Thickness. Figure 4 shows the variation of reduced viscosity with volume fraction for the bare and PVA-covered 190nm-size PS latex particles. For the bare particles, nre(j/ is independent of and the value of the Einstein coefficient is ca. 3.0. For the covered particles, rired/ t increases linearly with tp. Table IV gives the adsorbed layer thicknesses calculated from the differences in the intercepts for the bare and covered particles and determined by photon correlation spectroscopy, as well as the root-mean-square radii of gyration of the free polymer coil in solution. The agreement of the adsorbed layer thicknesses determined by two independent methods is remarkable. The increase in adsorbed layer thickness follows the same dependence on molecular weight as the adsorption density, i.e., for the fully hydrolyzed PVA s and... 

This publication arranges the published papers on adsorption of polymers with special regard to experiment and theory. A summary of all investigated systems is given. The experimental methods are outlined and the amounts adsorbed are discussed as a function of the system and experimental parameters (polymer, adsorbent, solvent, molecular, concentration, time, weight and temperature). Calculated and experimental amounts of saturation, the number of contact points per molecule adsorbed, the thickness of the adsorbed layer, the adsorption isotherms, the heats of adsorption, the effects of desorption are compared. Assumptions on the structur of the adsorbed layer and the mechanism of polymer adsorption are made and discussed. 

Surface tension measurement. Adsorption titration, also called soap titration, (2.3) was carried out by the drop volume method at different polymer concentrations. The equivalent concentration of salt was held constant. The amount of emulsifier necessary to reach the critical micelle concentration (CMC) in the latex was determined by each titration. The total weight of emulsifier present in the latex is the weight of emulsifier in the water plus the weight of emulsifier adsorbed. The linear plot of emulsifier concentration (total amount of emulsifier corresponding to the end-point of each titration) versus polymer concentration gives the CMC as the intercept and the slope determines the amount of emulsifier adsorbed on the polymer surface in equilibrium with emulsifier in solution at the CMC (E ). 

---