Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Adjustment Region

Note 1 Adjustment region corresponds to weight control system. Force adjustment typically occurs within a very narrow band width as shown in the shaded region. [Pg.3626]

The Adjustment Region, arising in the region immediately downstream of the leading edge of the canopy, throughout which the velocity prohles within and immediately above the canopy continuously evolve... [Pg.47]

In this stretched regime, the shape of the curve of the segment density distance from the surface is essentially flat, except for two adjustment regions at each end of the chains (see Fig. 4.16b). In the region within each blob (lstill applicable. For x>D, which is constant. [Pg.90]

This basic model was augmented in order to be more comprehensive than the traditional basic model by closing it with respect to households. This extension assumes that changes in exports from North Karelia would alter salaries, wages and capital incomes in the region and adjust regional consumption as a fixed ratio of the gross output of each industry. Hence both the inputs and household consumption... [Pg.517]

Some binary systems show a minimum at a lower eritieal-sohition temperature a few systems show elosed-loop two-phase regions with a maximum and a minimum.) As the temperature is inereased at any eomposition other than the eritieal eomposition v = the eompositions of the two eoexisting phases adjust themselves to keep the total mole fraetion unehanged until the eoexistenee eurve is reaehed, above whieh only one phase... [Pg.615]

Thus die increase of particles in our region due to restituting collisions with an impact parameter between b and b + Ab and azimuthal angle between e and e + de (see figure A3.1.7 can be obtained by adjusting the expression for the decrease of particles due to a small collision cylinder ... [Pg.681]

FIGURE 15 7 Electrostatic potential maps of (a) methanol and (b) methanethiol The color scales were adjusted to be the same for both molecules to allow for direct comparison The development of charge is more pronounced in the region surrounding the —OH group in methanol than it is for the —SH group in methanethiol... [Pg.649]

The determination of an analyte s concentration based on its absorption of ultraviolet or visible radiation is one of the most frequently encountered quantitative analytical methods. One reason for its popularity is that many organic and inorganic compounds have strong absorption bands in the UV/Vis region of the electromagnetic spectrum. In addition, analytes that do not absorb UV/Vis radiation, or that absorb such radiation only weakly, frequently can be chemically coupled to a species that does. For example, nonabsorbing solutions of Pb + can be reacted with dithizone to form the red Pb-dithizonate complex. An additional advantage to UV/Vis absorption is that in most cases it is relatively easy to adjust experimental and instrumental conditions so that Beer s law is obeyed. [Pg.394]

After the skimmer, the ions must be prepared for mass analysis, and electronic lenses in front of the analyzer are used to adjust ion velocities and flight paths. The skimmer can be considered to be the end of the interface region stretching from the end of the plasma flame. Some sort of light stop must be used to prevent emitted light from the plasma reaching the ion collector in the mass analyzer (Figure 14.2). [Pg.95]

Moreover, where i r-acetjldi- -xyljlene [10029-00-2]( is pyroly2ed, by adjusting temperatures in the deposition region, it is possible to isolate two different polymeric products, ie, poly(acetyl-/)-xylylene) [67076-72-6] (8) and poly(p-xylylene) (PPX) (2). This of course requires the cleavage of the original dimer into two fragments. [Pg.428]

Effect of Fiber Properties. Acid dyes are attracted to the accessible amine ends of the nylon chains located in the amorphous regions of the fiber. Acid dye affinity of nylon can be adjusted by a dding excess diamine or diacid to the polymer salt or by changing the molecular weight in polymerization. A light acid-dyeable nylon-6,6 is spun with 15—20 amine ends, expressed in terms of gram equivalents per 10 g of polymer. A medium or... [Pg.257]


See other pages where Adjustment Region is mentioned: [Pg.65]    [Pg.65]    [Pg.3626]    [Pg.3626]    [Pg.47]    [Pg.65]    [Pg.101]    [Pg.72]    [Pg.65]    [Pg.65]    [Pg.3626]    [Pg.3626]    [Pg.47]    [Pg.65]    [Pg.101]    [Pg.72]    [Pg.286]    [Pg.672]    [Pg.1314]    [Pg.1949]    [Pg.2861]    [Pg.296]    [Pg.227]    [Pg.707]    [Pg.707]    [Pg.438]    [Pg.88]    [Pg.240]    [Pg.241]    [Pg.92]    [Pg.421]    [Pg.257]    [Pg.99]    [Pg.469]    [Pg.287]    [Pg.512]    [Pg.192]    [Pg.199]    [Pg.543]    [Pg.468]    [Pg.355]    [Pg.34]    [Pg.350]    [Pg.375]    [Pg.296]    [Pg.309]    [Pg.536]   
See also in sourсe #XX -- [ Pg.47 ]




SEARCH



© 2024 chempedia.info