Addition complexes, formation, phosphine, tris

The beneficial effect of added phosphine on the chemo- and stereoselectivity of the Sn2 substitution of propargyl oxiranes is demonstrated in the reaction of substrate 27 with lithium dimethylcyanocuprate in diethyl ether (Scheme 2.9). In the absence of the phosphine ligand, reduction of the substrate prevailed and attempts to shift the product ratio in favor of 29 by addition of methyl iodide (which should alkylate the presumable intermediate 24 [8k]) had almost no effect. In contrast, the desired substitution product 29 was formed with good chemo- and anti-stereoselectivity when tri-n-butylphosphine was present in the reaction mixture [25, 31]. Interestingly, this effect is strongly solvent dependent, since a complex product mixture was formed when THF was used instead of diethyl ether. With sulfur-containing copper sources such as copper bromide-dimethyl sulfide complex or copper 2-thiophenecarboxylate, however, addition of the phosphine caused the opposite effect, i.e. exclusive formation of the reduced allene 28. Hence the course and outcome of the SN2 substitution show a rather complex dependence on the reaction partners and conditions, which needs to be further elucidated. 

Scheme 22 Interplay between formally Rh(III) and Rh(V) boryl complexes formation of bis- and tris(boryl) complexes 9.17 and 9.18 via B-H oxidative addition, and their subsequent reactions with phosphine via B-H reductive elimination...

Complexes 79 show several types of chemical reactions (87CCR229). Nucleophilic addition may proceed at the C2 and S atoms. In excess potassium cyanide, 79 (R = R = R" = R = H) forms mainly the allyl sulfide complex 82 (R = H, Nu = CN) (84JA2901). The reaction of sodium methylate, phenyl-, and 2-thienyllithium with 79 (R = R = r" = R = H) follows the same route. The fragment consisting of three coplanar carbon atoms is described as the allyl system over which the Tr-electron density is delocalized. The sulfur atom may participate in delocalization to some extent. Complex 82 (R = H, Nu = CN) may be proto-nated by hydrochloric acid to yield the product where the 2-cyanothiophene has been converted into 2,3-dihydro-2-cyanothiophene. The initial thiophene complex 79 (R = R = r" = R = H) reacts reversibly with tri-n-butylphosphine followed by the formation of 82 [R = H, Nu = P(n-Bu)3]. Less basic phosphines, such as methyldiphenylphosphine, add with much greater difficulty. The reaction of 79 (r2 = r3 = r4 = r5 = h) with the hydride anion [BH4, HFe(CO)4, HW(CO)J] followed by the formation of 82 (R = Nu, H) has also been studied in detail. When the hydride anion originates from HFe(CO)4, the process is complicated by the formation of side products 83 and 84. The 2-methylthiophene complex 79... 

The formation of cationic nickel hydride complexes by the oxidative addition of Brdnsted acids (HY) to zero-valent nickel phosphine or phosphite complexes (method C,) has already been discussed in Section II. Interesting in this connection is a recent H NMR study of the reaction of bis[tri(o-tolyl)phosphite]nickelethylene and trifluoroacetic acid which leads to the formation of a square-planar bis[tri(o-tolyl)phosphite] hydridonickel trifluoroacetate (30) (see below) having a cis arrangement of the phosphite ligands (82). 

In the case of phosphine, especially tri-n-butyl and triphenyl phosphines, an active phosphine complex is formed in the reaction medium via reaction with nickel carbonyl. This complex is a very active species provided that the optimum concentration of phosphine is used. Low phosphine concentration results in a loss of the effective nickel concentration through the formation of nickel tetra-carbonyl, nickel metal or nickel iodide. The absolute concentration of phosphine is less important than the P/Ni ratio. In addition to form the stable Ni-P catalyst, the phosphine has to compete with other ligands in the reaction mixture for nickel. With high carbon monoxide partial pressure, there is more CO in solution to compete with phosphine favoring the formation of the carbonyl, which is inactive under the reaction conditions. Hence with high carbon mon-... 

For the case of tri(o-tolyl)phosphine-ligated catalysts, the upper pathway appears to predominate. Oxidative addition occurs first via loss of a ligand from the bisphosphine precursor to form the oxidative adduct, which exists as a dimer bridged through the halogen atoms (equation 33). This dimer is broken up by amine, the coordination of which to palladium renders its proton acidic. Subsequent deprotonation by base leads to the amido complex, which can then reductively eliminate to form the product. When tert-butoxide is used as the base, the rate is limited by formation of and reductive elimination from the amido complex, while for the stronger hexamethyldisilazide, the rate-determining step appears to be oxidative addition. ... 

---