Acids absorption bands

Band 8, 7-lOy. (1408 cm. ). This is a characteristic carboxybc acid absorption band and it arises from a C—0 vibration coupled with an... 

Water has been analyzed in glycerol, hydrazine. Freon, organic films, acetone, and fuming nitric acid. Absorption bands at 2.76, 1.90, and 1.40 pm are used, depending on the concentration of the test substanee. When interferences from other absorption bands are severe or very low coneentrations of water are being studied, water can be extracted with glycerol or ethylene glycol. 

On the basis of the studies described in the preceding chapters, we anticipated that chelation is a requirement for efficient Lewis-acid catalysis. This notion was confirmed by an investigation of the coordination behaviour of dienophiles 4.11 and 4.12 (Scheme 4.4). In contrast to 4.10, these compounds failed to reveal a significant shift in the UV absorption band maxima in the presence of concentrations up to one molar of copper(ir)nitrate in water. Also the rate of the reaction of these dienophiles with cyclopentadiene was not significantly increased upon addition of copper(II)nitrate or y tterbium(III)triflate. 

The Raman spectrum of nitric acid shows two weak bands at 1050 and 1400 cm. By comparison with the spectra of isolated nitronium salts ( 2.3.1), these bonds were attributed to the nitrate and nitronium ion respectively. Solutions of dinitrogen pentoxide in nitric acid show these bands , but not those characteristic of the covalent anhydride , indicating that the self-dehydration of nitric acid does not lead to molecular dinitrogen pentoxide. Later work on the Raman spectrum indicates that at —15 °C the concentrations of nitrate and nitronium ion are 0-37 mol 1 and 0 34 mol 1 , respectively. The infra-red spectrum of nitric acid shows absorption bands characteristic of the nitronium ion. The equivalence of the concentrations of nitronium and nitrate ions argues against the importance of the following equilibrium ... 

The infra-red absorption bands of molecular nitric acid do not change as the medium is varied beween 100% and 70% of acid on further dilution the nitrate ion becomes the dominant species. ... 

The two absorption bands, at 1050 and 1400 cm , which appear in the Raman spectra of solutions of nitric acid in concentrated sulphuric acid are not attributable to either of the acid molecules. In oleum the lower band appears at 1075-1095 cm. That these bands seemed to correspond to those in the spectra of anhydrous nitric acid and solid dinitrogen pentoxide caused some confusion in the assignment of the spectrum. The situation was resolved by examining the Raman spectra of solutions of nitric acid in perchloric or selenic acids , in which the strong absorption at 1400 cm is not accompanied by absorption at about 1050 cm . Thus, the band at 1400 cm arises from the nitronium ion, and the band at about 1050 cm can be attributed in the cases of nitric acid and solid dinitrogen pentoxide to the nitrate ion formed according to the following schemes ... 

The most recent work indicates that in anhydrous sulphuric acid the above conversion is complete. The slightly modified absorption band in oleum arises from the hydrogen pyrosulphate ion formed in the following way ... 

THE STATE OF NITRIC ACID IN INERT ORGANIC SOLVENTS The absence of ions in mixtures of acetic acid and nitric acid is shown by their poor electrical conductivity and the Raman spectra of solutions in acetic acid, nitromethane, and chloroform show only the absorptions of the solvent and molecular nitric acid the bands corresponding to the nitronium and nitrate ions cannot be detected. -... 

In aqueous solutions of sulphuric (< 50%) and perchloric acid (< 45 %) nitrous acid is present predominantly in the molecular form, although some dehydration to dinitrogen trioxide does occur.In solutions contairdng more than 60 % and 65 % of perchloric and sulphuric acid respectively, the stoichiometric concentration of nitrous acid is present entirely as the nitrosonium ion (see the discussion of dinitrogen trioxide 4.1). Evidence for the formation of this ion comes from the occurrence of an absorption band in the Raman spectrum almost identical with the relevant absorption observed in crystalline nitrosonium perchlorate. Under conditions in which molecular nitrous... 

An investigation of the infra-red spectra of mixtures of nitric acid and acetic anhydride supports these conclusions. The concentration of nitronium ions, measured by the absorption band at 2380 cm, was... 

As discussed earlier in Section lOC.l, ultraviolet, visible and infrared absorption bands result from the absorption of electromagnetic radiation by specific valence electrons or bonds. The energy at which the absorption occurs, as well as the intensity of the absorption, is determined by the chemical environment of the absorbing moiety. Eor example, benzene has several ultraviolet absorption bands due to 7t —> 71 transitions. The position and intensity of two of these bands, 203.5 nm (8 = 7400) and 254 nm (8 = 204), are very sensitive to substitution. Eor benzoic acid, in which a carboxylic acid group replaces one of the aromatic hydrogens, the... 

Infrared Spectra of Ionomers. Infrared absorption data, first pubHshed in 1964 (11), show that partial neutralization of ethylene—methacryhc acid introduced new absorption bands at 1480 1670 cm for the ionized carboxylate group while the 1698 — cm band of the free acid carboxyl diminishes in size (21). In addition to providing information on stmctural features, the numerous absorption bands ate significant in apphcations technology, providing rapid warmup of film and sheet under infrared radiation. 

The Reich test is used to estimate sulfur dioxide content of a gas by measuring the volume of gas required to decolorize a standard iodine solution (274). Equipment has been developed commercially for continuous monitoring of stack gas by measuring the near-ultraviolet absorption bands of sulfur dioxide (275—277). The deterrnination of sulfur dioxide in food is conducted by distilling the sulfur dioxide from the acidulated sample into a solution of hydrogen peroxide, foUowed by acidimetric titration of the sulfuric acid thus produced (278). Analytical methods for sulfur dioxide have been reviewed (279). 

Their physical properties closely resemble those of pterin, which has a basic pKt, of 2.20 and an acidic one of 7.86 associated with N-1 protonation and a hypsochromic shift of the long-wavelength absorption band in the UV spectrum, and N-3 deprotonation effecting a bathochromic shift respectively (Table 4). The xanthopterin (4) and isoxanthopterin types... 

Most other studies have indicated considerably more complex behavior. The rate data for reaction of 3-methyl-l-phenylbutanone with 5-butyllithium or n-butyllithium in cyclohexane can be fit to a mechanism involving product formation both through a complex of the ketone with alkyllithium aggregate and by reaction with dissociated alkyllithium. Evidence for the initial formation of a complex can be observed in the form of a shift in the carbonyl absorption band in the IR spectrum. Complex formation presumably involves a Lewis acid-Lewis base interaction between the carbonyl oxygen and lithium ions in the alkyllithium cluster. 

Figure 14 shows the ATR spectrum of the etched polyethylene surface treated with a chronic acid group [76]. Absorption bands due to surface treatment appear at 3300, 1700, 1260, 1215, and 1050 cm". The band at 3300 cm represents the absorption due to the hydroxyl group and that at 1700 cm " is due to the carbonyl group. The bands at 1260, 1215, and 1050 cm are all due to the alkyl sulfonate group. 

The UV absorption spectra of sodium nitrite in aqueous solutions of sulfuric and perchloric acids were recorded by Seel and Winkler (1960) and by Bayliss et al. (1963). The absorption band at 250 nm is due either to the nitrosoacidium ion or to the nitrosyl ion. From the absorbancy of this band the equilibrium concentrations of HNO2 and NO or H20 —NO were calculated over the acid concentration ranges 0-100% H2S04 (by weight) and 0-72% HC104 (by weight). For both solvent systems the concentrations determined for the two (or three) equilibrium species correlate with the acidity function HR. This acidity function is defined for protonation-dehydration processes, and it is usually measured using triarylcarbinol indicators in the equilibrium shown in Scheme 3-15 (see Deno et al., 1955 Cox and Yates, 1983). 

This section is completed with a brief review of the synthesis and properties of this epimer (20) of the precursor of thiazole in bacteria. This pentulose is conveniently accessible by an unconventional route (Scheme 19). Methyl 2,3 4,6-di-O-isopropylidene-a-D-mannopyranoside, readily available from methyl ot-D-mannopyranoside, is converted to the ketonic glycoside by butyllithium in 91% yield, following a method first published by Klemer and Rodemeyer43 and scaled up by Horton and Weckerle.44 This was converted by means of lithium hydroxide in a water-ether mixture into 3,5-0-benzylidene-l-deoxy-D-eryf/iro-2-pen-tulose in 55% yield. Hydrolysis to the free pentulose (20) proceeded in 73% yield in aqueous acetic acid. This product was obtained as a syrup with a characteristic absorption band at 1705 cm 1 as a film. Thus, there is a fair proportion of the open-chain ketone under these conditions, as with the D-threo epimer.45... 

In the spectra of the reaction mixture, the hypobromite absorption band at 330 nm disappeared before the first minute of reaction had elapsed and there appeared an intense band near 290 nm which decreased with time (Fig. 1). On the basis of published information for other N-bromo compounds, this absorption band is attributed to the N-bromoamino acid formed (refs. 6, 21). 

The various porphyrinogens are colorless, whereas the various porphyrins are all colored. In the smdy of porphyrins or porphyrin derivatives, the characteristic absorption spectrum that each exhibits—in both the visible and the ultraviolet regions of the spectrum—is of great value. An example is the absorption curve for a solution of porphyrin in 5% hydrochloric acid (Figure 32-10). Note particularly the sharp absorption band near 400 nm. This is a distinguishing feamre of the porphin ring and is characteristic of all porphyrins regardless of the... 

---