Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Oxygen zirconia sensors

Voltage Cell Type Oxygen Sensor The operation of the zirconia oxygen sensor utilizes the conduction of oxygen ions by virtue of anion or oxygen ion vacancies in the crystalline lattice. " The anion vacancies are created when the... [Pg.1305]

The basic zirconia oxygen sensor design is illustrated in Fig. 13.52, which shows the principle of the zirconia solid oxygen-ion electrolyte. The sensor consists of a closed-end tube of ceramic zirconia ZrO )). The zirconia ceramic... [Pg.1306]

Application The zirconia oxygen sensor is widely used for combustion control processes and for air/fuel ratio regulation in internal combustion engines. The closed-end portion of the electrode tube is inserted into the exhaust gas stream. In the control of industrial combustion processes, no out stack sampling system is required. [Pg.1308]

W. J. Fleming, Zirconia Oxygen Sensor—An Equivalent Circuit Model, SAE 800020, Society of Automotive Engineers, Warrendale, Pa., 1980. [Pg.497]

The objectives of this study were twofold (1) to develop a new type of oxygen sensor which makes the crucible-type sensor more compact and which does not use air as a reference gas, (2) to analyze output characteristics of both the newly-developed zirconia oxygen sensor and the crucible-type oxygen sensor. [Pg.102]

Thick Film Zirconia Oxygen Sensor and Measurements... [Pg.102]

T) A more compact thick film zirconia oxygen sensor with a built-in heater has been developed. In this sensor, the reference oxygen gas is not air the oxygen gas is generated electrolytically at the interface between the reference electrode and the porous zirconia electrolyte. [Pg.118]

Mendybaev R. A., Beckett J. R., Stolper E., and Grossman L. (1998) Measurement of oxygen fugacities under reducing conditions non-Nemstian behavior of Y203-doped zirconia oxygen sensors. Geochim. Cosmochim. Acta 62, 3131-3139. [Pg.428]

Kotzeva, V.P. and Kumar, R.V. (1999) The response of yttria stabilized zirconia oxygen sensors to carbon monoxide gas. Ionics, 5 (3-4), 220-6. [Pg.469]

Sridhar, K.R. and Blanchard, J.A. (1999) Electronic conduction in low oxygen partial pressure measurements using an amperometric zirconia oxygen sensor. Sens. Actuators B, 59, 60-7. [Pg.470]

Spirig, J.V., Ramamoorthy, R., Akbar, S.A., Routbort, J.L., Singh, D. and Dutta, P.K. (2007) High temperature zirconia oxygen sensor with sealed metal/metal oxide internal reference. Sens. Actuators B, 124 (1), 192-201. [Pg.473]

Kaneko, H., Okamura, T. and Taimatsu, H. (2003) Characterization of zirconia oxygen sensors with a molten internal reference for low-temperature operation. Sens. Actuators 93 (1-3), 205-8. [Pg.473]

The modified thermodynamic emf for the zirconia oxygen sensors with In-Hln203 and Bi+Bi203 REs can be calculated from Equations (3.3) and (4.7) ... [Pg.149]

FIGURE 4.16 Instrumentation scheme for impedance measurements 1 generator, 2, 4, and 6 amplifiers 3 attenuator 5 filter 7 zirconia oxygen sensor 8 osdlloscope C capacitance and Z electrochemical sensor impedance. (From Zhuiykov, S., In-situ diagnostics of solid electrolyte sensors measuring oxygen activity in melts by developed impedance method, Meas. Sci. Technol. 17 (2006) 1570-1578. With permission.)... [Pg.164]

Kaneko, H. et al.. Performance of a miniature zirconia oxygen sensor with Pd-PdO... [Pg.193]

Burkhard, D.J.M., Hanson, B., and Uhner, G.C., ZrOj oxygen sensors An evaluation of behavior at temperatures as low as 300°C, Solid State Ionics 47 (1991) 169-175. Can, Z.Y. et al., Detection of carbon monoxide by using zirconia oxygen sensor, Solid State Ionics 79 (1995) 344-348. [Pg.194]

Fig. 7 Internally platinized yttria-stabilized zirconia oxygen sensor measuring differences in the oxygen activity. Fig. 7 Internally platinized yttria-stabilized zirconia oxygen sensor measuring differences in the oxygen activity.
N. Matsui [1981] Complex-Impedance Analysis for the Development of Zirconia Oxygen Sensors, Solid State Ionics 3/4, 525-529. [Pg.566]

In the structure of the zirconia oxygen sensor, the sensor element is stored in the metal shell consisting of a metal with heater resistance. The sensor element is supported by talc in the metal shell by filling press. The gas detection portion which is exposed to the exhaust gas, is covered with a protection tube made... [Pg.42]

Shuk P, Bailey E, Guth U (2008) Zirconia oxygen sensor for the process application state-of-the-art. Mod Sens Technol 90 174-184... [Pg.237]

Matsui N (1981) Complex-impedance analysis for the development of zirconia oxygen sensors. Solid State Ion 3 525-529... [Pg.372]

Fleming WJ (1977) Physical principles governing non-ideal behavior of zirconia oxygen sensor. J Electrochem Soc 124(l) 21-28... [Pg.608]


See other pages where Oxygen zirconia sensors is mentioned: [Pg.1306]    [Pg.85]    [Pg.86]    [Pg.106]    [Pg.106]    [Pg.117]    [Pg.487]    [Pg.135]    [Pg.143]    [Pg.197]    [Pg.198]    [Pg.258]    [Pg.604]    [Pg.610]    [Pg.13]    [Pg.2240]    [Pg.2246]    [Pg.222]   
See also in sourсe #XX -- [ Pg.322 , Pg.323 ]




SEARCH



Modeling Interactions of Oxygen with the Zirconia Sensor

Nernst zirconia oxygen sensor

Oxygen sensors

Resistive zirconia oxygen sensor

Zirconia Sensors for Oxygen Measurement

Zirconia sensors

Zirconia-based oxygen sensor

© 2024 chempedia.info