Z epoxidation

The Pd-catalyzed hydrogenolysis of vinyloxiranes with formate affords homoallyl alcohols, rather than allylic alcohols regioselectively. The reaction is stereospecific and proceeds by inversion of the stereochemistry of the C—O bond[394,395]. The stereochemistry of the products is controlled by the geometry of the alkene group in vinyloxiranes. The stereoselective formation of stereoisomers of the syn hydroxy group in 630 and the ami in 632 from the ( )-epoxide 629 and the (Z)-epoxide 631 respectively is an example. 

Inversion of Olefin Stereochemistry The preparation of alkenes via inversion of the double bond geometry is an important synthetic transformation. For example, interconversion of the (Z)-alkene to the (ff-isomer depicted below involves treatment of the (Z)-epoxide with the nucleophilic LiPPh2 followed by phosphorus alkylation to furnish the betaine,which undergoes 5yn-elimination to produce the (Ef-alkene. The alkene inversion works for di-, tri-, and tetra-substituted olefins. 

EINECS 271-842-6 9-Octadecenoic acid (Z)-, epoxidized, ester with propylene glycol Oleic acid, 1,2-propylene glycol epoxidized ester Vikoflex49M. 

The isomerization shows high regiospecificity. Thus the Z-epoxide (5) is converted in high yield into the disubstituted allylic alcohol (6), whereas the E-epoxide (7) is converted mainly into the trisubstituted allylic alcohol (8). The bulk of the base may contribute to the selectivity of isomerization. 

The use of ( )-allyl alcohols gives ( )-epoxides, and the use of (Z)-aUyl alcohols gives (Z)-epoxides. According to the choice of tartrate ester, one diastereomer is obtained in excess. 

In all cases examined the ( )-isomers of the allylic alcohols reacted satisfactorily in the asymmetric epoxidation step, whereas the epoxidations of the (Z)-isomers were intolerably slow or nonstereoselective. The eryfhro-isomers obtained from the ( )-allylic alcohols may, however, be epimerized in 95% yield to the more stable tlireo-isomers by treatment of the acetonides with potassium carbonate (6a). The competitive -elimination is suppressed by the acetonide protecting group because it maintains orthogonality between the enolate 7i-system and the 8-alkoxy group (cf the Baldwin rules, p. 316). 

Physical and Chemical Properties. The (F)- and (Z)-isomers of cinnamaldehyde are both known. (F)-Cinnamaldehyde [14371-10-9] is generally produced commercially and its properties are given in Table 2. Cinnamaldehyde undergoes reactions that are typical of an a,P-unsaturated aromatic aldehyde. Slow oxidation to cinnamic acid is observed upon exposure to air. This process can be accelerated in the presence of transition-metal catalysts such as cobalt acetate (28). Under more vigorous conditions with either nitric or chromic acid, cleavage at the double bond occurs to afford benzoic acid. Epoxidation of cinnamaldehyde via a conjugate addition mechanism is observed upon treatment with a salt of /-butyl hydroperoxide (29). 

This reaction illustrates a stereoselective preparation of (Z)-vinylic cuprates, which are very useful synthetic intermediates. They react with a variety of electrophiles such as carbon dioxide, epoxides, aldehydes, allylic halides, alkyl halides, and acetylenic halides they undergo... 

Acetylenic epoxides are reduced readily to the olehnic epoxide, provided the resulting epoxide is not allylic (27). In the latter case, one might surmise that hydrogenolysis could best be avoided by use of rhodium in a neutral nonpolar solvent (81) or a Lindlar catalyst (13). Reduction of l,2-epoxydec-4-yne over Lindlar catalyst gave (Z)-l,2-epoxydec-4-ene in 95% yield (69). Hydrogenation ceased spontaneously. 

Vinylepoxides can be obtained by various strategies, all with their inherent limitations. Racemic epoxidation of olefins is a straightforward route to epoxides, as pure trans- or cis-epoxides can be obtained from ( )- or (Z)-alkenes, respectively. Various oxidants - such as mCPBA and other peracids, H2O2, or VO(acac)2/TBHP - can all be employed in this transformation [1],... 

Ten years after Sharpless s discovery of the asymmetric epoxidation of allylic alcohols, Jacobsen and Katsuki independently reported asymmetric epoxidations of unfunctionalized olefins by use of chiral Mn-salen catalysts such as 9 (Scheme 9.3) [14, 15]. The reaction works best on (Z)-disubstituted alkenes, although several tri-and tetrasubstituted olefins have been successfully epoxidized [16]. The reaction often requires ligand optimization for each substrate for high enantioselectivity to be achieved. 

Conjugated dienes can be epoxidized to provide vinylepoxides. Cyclic substrates react with Katsuki s catalyst to give vinylepoxides with high ees and moderate yields [17], whereas Jacobsen s catalyst gives good yields but moderate enantiose-lectivities [18]. Acyclic substrates were found to isomerize upon epoxidation (Z, )-conjugated dienes reacted selectively at the (Z)-alkene to give trans-vinylepoxides (Scheme 9.4a) [19]. This feature was utilized in the formal synthesis of leuko-triene A4 methyl ester (Scheme 9.4b) [19]. 

The development of Sharpless asymmetric epoxidation (SAE) of allylic alcohols in 1980 constitutes a breakthrough in asymmetric synthesis, and to date this method remains the most widely applied asymmetric epoxidation technique [34, 44]. A wide range of substrates can be used in the reaction ( ) -allylic alcohols generally give high enantioselectivity, whereas the reaction is more substrate-dependent with (Z)-allylic alcohols [34]. 

The cyclohexyloxy(dimethyl)silyl unit in 8 serves as a hydroxy surrogate and is converted into an alcohol via the Tamao oxidation after the allylboration reaction. The allylsilane products of asymmetric allylboration reactions of the dimethylphenylsilyl reagent 7 are readily converted into optically active 2-butene-l, 4-diols via epoxidation with dimethyl dioxirane followed by acid-catalyzed Peterson elimination of the intermediate epoxysilane. Although several chiral (Z)-y-alkoxyallylboron reagents were described in Section 1.3.3.3.3.1.4., relatively few applications in double asymmetric reactions with chiral aldehydes have been reported. One notable example involves the matched double asymmetric reaction of the diisopinocampheyl [(Z)-methoxy-2-propenyl]boron reagent with a chiral x/ -dialkoxyaldehyde87. 

Um einen prim. Alkohol zu erhalten, muG also das a-Kohlenstoff-Atom des aliphati-schen Epoxids tertiar sein8. Bei aromatisch substituierten Oxiranen (z.B. Phenyl-oxiran) geniigt ein Substituent. Als Beispiele dienen die Reduktionen von 2-Athyl-2-(4-chlor-phenyl)-oxiran mit Lithiumalanat oder Aluminiumhydrid9 ... 

Mit Lithium-triathyl-hydrido-borat werden auch sterisch behinderte Epoxide schnell nach dem SN2-Mechanismus angegriffen z.B.3 ... 

---