Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Water Lewis acids

Keywords water, Lewis acids, carbo-Diels-Alder reactions, hefero-Diels-Alder reactions... [Pg.301]

Manabe K, Mori Y, Wakabayashi T et al. (2000) Organic synthesis inside particles in water Lewis acid-surfactant-combined catalysts for organic reactions in water using colloidal dispersions as reaction media. J Am Chem Soc 122 7202-7207... [Pg.271]

Still another type of adsorption system is that in which either a proton transfer occurs between the adsorbent site and the adsorbate or a Lewis acid-base type of reaction occurs. An important group of solids having acid sites is that of the various silica-aluminas, widely used as cracking catalysts. The sites center on surface aluminum ions but could be either proton donor (Brpnsted acid) or Lewis acid in type. The type of site can be distinguished by infrared spectroscopy, since an adsorbed base, such as ammonia or pyridine, should be either in the ammonium or pyridinium ion form or in coordinated form. The type of data obtainable is illustrated in Fig. XVIII-20, which shows a portion of the infrared spectrum of pyridine adsorbed on a Mo(IV)-Al203 catalyst. In the presence of some surface water both Lewis and Brpnsted types of adsorbed pyridine are seen, as marked in the figure. Thus the features at 1450 and 1620 cm are attributed to pyridine bound to Lewis acid sites, while those at 1540... [Pg.718]

Boron trioxide is not particularly soluble in water but it slowly dissolves to form both dioxo(HB02)(meta) and trioxo(H3B03) (ortho) boric acids. It is a dimorphous oxide and exists as either a glassy or a crystalline solid. Boron trioxide is an acidic oxide and combines with metal oxides and hydroxides to form borates, some of which have characteristic colours—a fact utilised in analysis as the "borax bead test , cf alumina p. 150. Boric acid. H3BO3. properly called trioxoboric acid, may be prepared by adding excess hydrochloric or sulphuric acid to a hot saturated solution of borax, sodium heptaoxotetraborate, Na2B407, when the only moderately soluble boric acid separates as white flaky crystals on cooling. Boric acid is a very weak monobasic acid it is, in fact, a Lewis acid since its acidity is due to an initial acceptance of a lone pair of electrons from water rather than direct proton donation as in the case of Lowry-Bronsted acids, i.e. [Pg.148]

This chapter introduces the experimental work described in the following chapters. Some mechanistic aspects of the Diels-Alder reaction and Lewis-acid catalysis thereof are discussed. This chapter presents a critical survey of the literature on solvent ejfects on Diels-Alder reactions, with particular emphasis on the intriguing properties of water in connection with their effect on rate and selectivity. Similarly, the ejfects of water on Lewis acid - Lewis base interactions are discussed. Finally the aims of this thesis are outlined. [Pg.1]

Lewis acid - Lewis base coordination in water... [Pg.28]

In a Lewis-acid catalysed Diels-Alder reaction, the first step is coordination of the catalyst to a Lewis-basic site of the reactant. In a typical catalysed Diels-Alder reaction, the carbonyl oxygen of the dienophile coordinates to the Lewis acid. The most common solvents for these processes are inert apolar liquids such as dichloromethane or benzene. Protic solvents, and water in particular, are avoided because of their strong interactions wifti the catalyst and the reacting system. Interestingly, for other catalysed reactions such as hydroformylations the same solvents do not give problems. This paradox is a result of the difference in hardness of the reactants and the catalyst involved... [Pg.28]

The most effective Lewis-acid catalysts for the Diels-Alder reaction are hard cations. Not surprisingly, they coordinate to hard nuclei on the reacting system, typically oxygen atoms. Consequently, hard solvents are likely to affect these interactions significantly. Table 1.4 shows a selection of some solvents ranked according to their softness. Note that water is one of the hardest... [Pg.29]

The second important influence of the solvent on Lewis acid - Lewis base equilibria concerns the interactions with the Lewis base. Consequently the Lewis addity and, for hard Lewis bases, especially the hydrogen bond donor capacity of tire solvent are important parameters. The electron pair acceptor capacities, quantified by the acceptor number AN, together with the hydrogen bond donor addities. O, of some selected solvents are listed in Table 1.5. Water is among the solvents with the highest AN and, accordingly, interacts strongly witli Lewis bases. This seriously hampers die efficiency of Lewis-acid catalysis in water. [Pg.30]

Finally, the solvent also interacts with sites of the Lewis acid and the Lewis base that are not directly involved in mutual coordination, thereby altering the electronic properties of the complex. For example, delocalisation of charges into the surrounding solvent molecules causes ions in solution to be softer than in the gas phase . Again, water is particularly effective since it can act as an efficient electron pair acceptor as well as a donor. [Pg.31]

In summary, water is clearly an extremely bad solvent for coordination of a hard Lewis acid to a hard Lewis base. Hence, catalysis of Diels-Alder reactions in water is expected to be difficult due to the relative inefficiency of the interactions between the Diels-Alder reactants and the Lewis-acid catalyst in this medium. [Pg.31]

A combination of the promoting effects of Lewis acids and water is a logical next step. However, to say the least, water has not been a very popular medium for Lewis-acid catalysed Diels-Alder reactions, which is not surprising since water molecules interact strongly with Lewis-acidic and the Lewis-basic atoms of the reacting system. In 1994, when the research described in this thesis was initiated, only one example of Lewis-acid catalysis of a Diels-Alder reaction in water was published Lubineau and co-workers employed lanthanide triflates as a catalyst for the Diels-Alder reaction of glyoxylate to a relatively unreactive diene . No comparison was made between the process in water and in organic solvents. [Pg.31]

In view of the remarkable effects that water can exert on the uncatalysed Diels-Alder reaction, there might well be a similar effect on the rate and the selectivity of the Lewis-acid catalysed process. At the same time, coordination of a Lewis-acid to a Diels-Alder reagent is likely to overcome the... [Pg.31]

What is the effect of water on the rate and selectivity of the Lewis-acid catalysed Diels-Alder reaction, when compared to oiganic solvents Do hydrogen bonding and hydrophobic interactions also influence the Lewis-acid catalysed process Answers to these questions will be provided in Chapter 2. [Pg.32]

What is the influence of ligands on the Lewis acid on the rate and selectivity of the Diels-Alder reaction If enantioselectivity can be induced in water, how does it compare to other solvents Chapter 3 deals with these topics. [Pg.32]

What is the scope of Lewis-acid catalysis of Diels-Alder reactions in water An approach of extending the scope by making use of a temporary secondary coordination site is described in Chapter 4. [Pg.32]

Appreciating the beneficial influences of water and Lewis acids on the Diels-Alder reaction and understanding their origin, one may ask what would be the result of a combination of these two effects. If they would be additive, huge accelerations can be envisaged. But may one really expect this How does water influence the Lewis-acid catalysed reaction, and what is the influence of the Lewis acid on the enforced hydrophobic interaction and the hydrogen bonding effect These are the questions that are addressed in this chapter. [Pg.44]

In order to be able to provide answers to these questions, a Diels-Alder reaction is required that is subject to Lewis-acid catalysis in aqueous media. Finding such a reaction was not an easy task. Fortunately the literature on other Lewis-acid catalysed organic reactions in water was helpful to some extent... [Pg.44]

Bcamples of metal-ion catalysed organic reactions in water where the catalyst acts exclusively as Lewis acid are the hromination of diketones" " and the decarboxylation of oxaloacetate. The latter reaction has been studied in detail. In 1941 it was demonstrated that magnesium(II) ions catalyse this reaction" Later also catalysis by other multivalent metal ions, such as Zn(II), Mn(II), Cu(II), Cd(ir), Fe(II), Pb(II), Fe(III)... [Pg.46]

Scheme 2.2. Lewis-acid catalysed reactions in pure water. Scheme 2.2. Lewis-acid catalysed reactions in pure water.

See other pages where Water Lewis acids is mentioned: [Pg.160]    [Pg.117]    [Pg.215]    [Pg.144]    [Pg.130]    [Pg.160]    [Pg.117]    [Pg.215]    [Pg.144]    [Pg.130]    [Pg.65]    [Pg.65]    [Pg.245]    [Pg.719]    [Pg.152]    [Pg.9]    [Pg.24]    [Pg.30]    [Pg.31]    [Pg.32]    [Pg.43]    [Pg.44]    [Pg.44]    [Pg.45]    [Pg.46]    [Pg.46]    [Pg.47]    [Pg.48]   
See also in sourсe #XX -- [ Pg.314 ]

See also in sourсe #XX -- [ Pg.314 ]

See also in sourсe #XX -- [ Pg.314 ]

See also in sourсe #XX -- [ Pg.314 ]

See also in sourсe #XX -- [ Pg.314 ]




SEARCH



Aqueous Aldol Reaction with Water-stable Lewis Acids

Lewis acid catalysis water compatibility

Lewis acid catalyzed reactions, water

Lewis acid catalyzed reactions, water solvent

Lewis acids water-stable

Lewis acids water-tolerant

Water removing Lewis acids

Water-stable rare earth Lewis Acid catalysis

© 2024 chempedia.info