Voltammetric methods chronoamperometry

By applying fast voltammetric methods (chronoamperometry and fast pulse techniques, e.g., fast LSV, rapid polarography, etc.) chemical reactions with half-times not lower than 10" s can be followed. Both... 

Voltammetric methods in these methods, a potential is applied to the working electrode using a three-electrode setup (see section 1.6). The electrical current, resulting from charge transfer over the electrode-electrolyte interface, is measured and reveals information about the analyte that takes part in the charge transfer reaction. The potential applied can be constant (chronoamperometry, section2.5), varied linearly (cyclic voltammetry, section 2.3) or varied in other ways (Chapter 2). 

Electrochemical methods include potentiometry, cyclic voltammetry and chronoamperometry. These methods as well as other voltammetric methods and the impedance of electrochemical systems are discussed in this chapter. 

Studies of tethered electroactive species are less sensitive to pinholes than experiments with solution reactants and blocking layers, although heterogeneity and roughness of the substrate and film defects can still play a role. The rate constant, k, in this case has units of a first-order reaction (s ). Rate constants can be determined by a voltammetric method as described earlier for electroactive monolayers (Section 14.3.3). In addition potential-step chronoamperometry can be employed, in which case the current follows a simple exponential decay (88, 90, 91) ... 

ABSTRACT. Several aspects of electrochemistry at ultramicroelectrodes are presented and discussed in relevance to their application to the analysis of chemical reactivity. The limits of fast scan cyclic voltammetry are examined, and the method shown to allow kinetic investigations in the nanosecond time scale. On the other hand, the dual nature of steady state at ultramicroelectrodes is explained, and it is shown how steady state currents may be used, in combination with transient chronoamperometry, for the determination of absolute electron stoichiometries in voltammetric methods. Finally the interest of electrochemistry in highly resistive conditions for discussion and investigation of chemical reactivity is presented. 

The homogeneous catalysis method is suitable to measure rate constants over a very wide range, up to the diffusion limit. The lower limit is determined by interferences, such as convection, which occur at very slow scan rates. It is our experience that, unless special precautions are taken, scan rates below lOOmV/s result in significant deviations from a purely diffusion-controlled voltammetric wave. For small values of rate constants (down to 10 s ), other potentiostatic techniques are best suited, such as chronoamperometry at a rotating disk electrode UV dip probe and stopped-flow UV-vis techniques. ... 

---