Voltage electric surface

Low-voltage electric resistance heater cables fixed to the structural floor slab and then protected within a 50 mm thickness of cement and sand to give a suitable surface on which the floor vapour barrier can be laid. The heating is thermostatically controlled, and it is usual to include a distance reading or recording thermometer to give visual indication of the temperature of the floor at several locations below the insulation. 

These types of corona reactors involve simultaneous application of non-thermal plasma above liquid surface and direct high voltage electrical discharge in liquid phase. That is achieved by the combination of different electrode... 

The ultrafiltration of the microemulsion is a very useful operation for separating water and oil in these mixtures [117-120]. Because of the limited availability of solvent stable membranes, most of the work pubHshed so far was performed using ceramic membranes, which show a high adsorption of surfactant at the membrane surface and comparably low rejection rates of reverse micelles. Using electro ultrafiltration, where the concentration polarisation phenomenon of the reverse micelles (using the ionic surfactant AOT) at the membrane surface is depressed by asymmetric high voltage electrical fields, the rejection rates can be increased,but not to economical values [121,122]. 

Electrospinning uses a high-voltage electrical field (typically 10-20 kV) to form micro- and even nanoscale fibres from a suspended droplet of polymer melt or solution [118]. When the repulsive electrostatic interactions overcome the droplet s surface tension, a Taylor cone is formed and a polymer jet is ejected from the tip of this Taylor cone [119]. The polymer jet is then accelerated towards a grounded collector screen. As the jet moves through the air, a stretching process occurs and the solvent evaporates which results in a non-woven polymer fabric or polymer mat [120]. Electrospinning has already been applied for both synthetic as well... 

As for the metals most often used in electrochemistry (namely silver, copper or zinc) the electron work function values are 4 to 5 eV. For single-crystals this value is influenced by the particular type of crystalline face. This is hardly surprising given that the metal s surface properties affect the electric surface voltage x- The differences that can be observed between different types of crystalline faces vary by about 0.1 eV. 

The time required for a given electrical current to render the plastic surface of a material conductive because of carbonization by the arc flame. Also ability to resist the action of a high voltage electrical arc, usually in terms of time required to render the material electrically conductive. The total time (in sec) that intermittent arc may play across the plastic surface with rendering the surface conductive. 

Electrospray sample deposition (ESDEP) is a sample preparation method where matrix and analyte solutions are sprayed on the target surface under the influence of a high-voltage electric field [44,45]. ESDEP is reported to yield much better shot-to-shot and spot-to-spot reproducibility than the dried-droplet method. The improved results are ascribed to the small and evenly sized crystals that are formed, and as a consequence, improved homogeneity of the MALDI sample surface. Hanton et al. [45] analyzed PEG1450, a narrowly distributed poly(ethylene oxide) sample, using an uncommon... 

---