Viscoelastic non-linear

Other ideas proposed to explain the 3/4 power-law dependence include effects due to viscoelasticity, non-linear elasticity, partial plasticity or yielding, and additional interactions beyond simply surface forces. However, none of these ideas have been sufficiently developed to enable predictions to be made at this time. An understanding of this anomalous power-law dependence is not yet present. 

Limitations of the Tests, Especially when Applied to Viscoelastic Non-Linear Inhomogeneous Anisotropic Materials... 

Where materials are being examined for their suitability for specific applications it is essential that creep measurements are performed over an extended time-scale. It is possible that a material that shows good short-term creep shows accelerated creep at longer times (Figure 5.5). As discussed later, comparable problems may occur for materials that are viscoelastically non-linear, so that the recovery response is very different from that during the early stages of creep. 

In Equation (1.28) function M(t - r ) is the time-dependent memory function of linear viscoelasticity, non-dimensional scalars 4>i and 4>2 and are the functions of the first invariant of Q(t - f ) and F, t t ), which are, respectively, the right Cauchy Green tensor and its inverse (called the Finger strain tensor) (Mitsoulis, 1990). The memory function is usually expressed as... 

This type of response is referred to as non-linear viscoelastic but as it is not amenable to simple analysis it is often reduced to the form... 

Show that for a viscoelastic material in which the modulus is given by (t) = At ", there will be a non-linear strain response to a linear increase in stress with time. 

Viscoelasticity of metal This subject provides an introduction on the viscoelasticity of metals that has no bearing or relationship with viscoelastic properties of plastic materials. The aim is to have the reader recognize that the complex thermodynamic foundations of the theory of viscoplasticity exist with metals. There have been developments in the thermodynamic approach to combined treatment of rheologic and plastic phenomena and to construct a thermodynamic theory non-linear viscoplastic material that may be used to describe the behavior of metals under dynamic loads. 

Because of the assumption that linear relations exist between shear stress and shear rate (equation 3.4) and between distortion and stress (equation 3.128), both of these models, namely the Maxwell and Voigt models, and all other such models involving combinations of springs and dashpots, are restricted to small strains and small strain rates. Accordingly, the equations describing these models are known as line viscoelastic equations. Several theoretical and semi-theoretical approaches are available to account for non-linear viscoelastic effects, and reference should be made to specialist works 14-16 for further details. 

J.L. Leblanc, Investigating the non-linear viscoelastic behavior of filled mbber compounds through Fourier transform rheometry. Rubber Chem. TechnoL, 78, 54—75, 2005. 

C. Friedrich, K. Mattes, and D. Schulze, Non-linear Viscoelastic Properties of Polymer Melts as Analyzed by LAOS-FT Experiments, lUPAC Macro 2004, Paris, France, July 4—9, 2004, Paper 6.1.3. 

J.L. Leblanc, Fourier Transform rheometry A new tool to investigate intrinsically non-linear viscoelastic materials, Ann. Trans. Nordic Rheol. Soc., 13, 3-21, 2005. 

It is likely that most biomaterials possess non-linear elastic properties. However, in the absence of detailed measurements of the relevant properties it is not necessary to resort to complicated non-linear theories of viscoelasticity. A simple dashpot-and-spring Maxwell model of viscoelasticity will provide a good basis to consider the main features of the behaviour of the soft-solid walls of most biomaterials in the flow field of a typical bioprocess equipment. 

Non-linear viscoelastic flow phenomena are one of the most characteristic features of polymeric liquids. A matter of very emphasised interest is the first normal stress difference. It is a well-accepted fact that the first normal stress difference Nj is similar to G, a measure of the amount of energy which can be stored reversibly in a viscoelastic fluid, whereas t12 is considered as the portion that is dissipated as viscous flow [49-51]. For concentrated solutions Lodge s theory [52] of an elastic network also predicts normal stresses, which should be associated with the entanglement density. 

The term y(t,t ) is the shear strain at time t relative to the strain at time t. The use of a memory function has been adopted in polymer modelling. For example this approach is used by Doi and Edwards11 to describe linear responses of solution polymers which they extended to non-linear viscoelastic responses in both shear and extension. 

Firstly, it helps to provide a cross-check on whether the response of the material is linear or can be treated as such. Sometimes a material is so fragile that it is not possible to apply a low enough strain or stress to obtain a linear response. However, it is also possible to find non-linear responses with a stress/strain relationship that will allow satisfactory application of some of the basic features of linear viscoelasticity. Comparison between the transformed data and the experiment will indicate the validity of the application of linear models. 

The most surprising result is that such simple non-linear relaxation behaviour can give rise to such complex behaviour of the stress with time. In Figure 6.3(b) there is a peak termed a stress overshoot . This illustrates that materials following very simple rules can show very complex behaviour. The sample modelled here, it could be argued, can show both thixotropic and anti-thixotropic behaviour. One of the most frequently made non-linear viscoelastic measurements is the thixotropic loop. This involves increasing the shear rate linearly with time to a given... 

Figure 6.3 Plot of a simple non-linear viscoelastic response for (a) the stress relaxation as a function of the applied strain, (b) stress as a function of time at a shear strain y = 1 and (c) viscosity as a function of shear stress. (r (0) = 33Pas, rj(co) = 3 Pas, a = 1, P = 0.1, m = 0.35 and t = Is). Continued overleaf...

Contents Chain Configuration in Amorphous Polymer Systems. Material Properties of Viscoelastic Liquids. Molecular Models in Polymer Rheology. Experimental Results on Linear Viscoelastic Behavior. Molecular Entan-lement Theories of Linear iscoelastic Behavior. Entanglement in Cross-linked Systems. Non-linear Viscoelastic-Properties. 

Note 5 Creep is sometimes described in terms of non-linear viscoelastic behaviour, leading, for example, to evaluation of recoverable shear and steady-state recoverable shear compliance. The definitions of such terms are outside the scope of this document. 

The mechanical response of polypropylene foam was studied over a wide range of strain rates and the linear and non-linear viscoelastic behaviour was analysed. The material was tested in creep and dynamic mechanical experiments and a correlation between strain rate effects and viscoelastic properties of the foam was obtained using viscoelasticity theory and separating strain and time effects. A scheme for the prediction of the stress-strain curve at any strain rate was developed in which a strain rate-dependent scaling factor was introduced. An energy absorption diagram was constructed. 14 refs. 

---