Utility systems cooling water

A refrigeration system is a heat pump in which heat is absorbed below ambient temperature. Thus the appropriate placement principle for heat pumps applies in exactly the same way as for refrigeration cycles. The appropriate placement for refrigeration cycles is that they also should be across the pinch. As with heat pumps, refrigeration cycles also can be appropriately placed across utility pinches. It is common for refrigeration cycles to be placed across a utility pinch caused by maximizing cooling water duty. 

A test water box was installed during a 2-week trial to monitor corrosion and fouling in a utility cooling water system. A baffle plate from the test box was removed after the test. Small, hollow incipient tubercles dotted surfaces (Fig. 3.28). Small amounts of carbonate were present atop and around each tubercle. Each tubercle capped a small depression no deeper than 0.005 in. (0.013 cm) (Fig. 3.29). This indicated local average corrosion rates were as high as 130 mihy (3.3 mm/y). 

Now let us consider utility failure as a cause of overpressure. Failure of the utility supphes (e.g., electric power, cooling water, steam, instrument air or instrument power, or fuel) to refinery plant facihties wiU in many instances result in emergency conditions with potential for overpressuring equipment. Although utility supply systems are designed for reliability by the appropriate selection of multiple generation and distribution systems, spare equipment, backup systems, etc., the possibility of failure still remains. Possible failure mechanisms of each utility must, therefore, be examined and evaluated to determine the associated requirements for overpressure protection. The basic rules for these considerations are as follows ... 

Backup systems which depend upon the action of automatic cut-in devices (e.g., a turbine-driven standby spare for a motor-driven cooling water pump, with PLCI control) would not be considered an acceptable means of preventing a utility failure for normal pressure relief design purposes, even though their installation is fully justified by improved continuity and reliability of plant operations. 

Failure of the utilities and ancillary systems occurs when one or more of tlie following is lost electric power, cooling water or otlier heal removal systems, steam or other heat supply systems, fuel, air, inert gas, or effluent disposal facilities. 

Ensure the adequacy (in terms of quality, quantity and reliability) of services/utilities, e.g. steam, process/cooling water, electricity, compressed air, inert gas, fire suppression systems, ventilation. 

Heat transfer operations. Heat transfer fluids other than steam and cooling water utilities are sometimes introduced into the design of the heat exchange system. These heat transfer media are sometimes liquid hydrocarbons used at high pressure. When possible, higher boiling liquids should be used. Better still, the flammable material should be substituted with a nonflammable medium such as water or molten salt. 

Noncontact cooling water is normally supplied to several processes from the utilities area. The system is either a loop that utilizes one or more evaporative cooling towers, or a once-through system with direct discharge. 

---