Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Universal mill

Blooms and billets are used to make long products. After leaving the roughing stand, the piece of steel passes through a succession of stands which do not just reduce the size of the steel, but also change its shape. In a universal mill, all... [Pg.118]

The Alpine universal mill with turbine beater and grinding track shown in Figure 2.12 is suitable for both brittle and tough materials. The high airflow from the turbine keeps the temperature rise to a minimum. [Pg.113]

Waring Blender with stainless steel container (Waring), M 20 IKA-Universal Mill (IKA Works), or equivalent... [Pg.778]

Pour liquid nitrogen into a dry stainless steel Waring Blender container or M 20 IKA-Universal Mill grinding chamber and allow to evaporate. If operating a blender, turn on for few seconds. Repeat this procedure until container is well chilled. [Pg.778]

Beater mills, hammer mills, baffle plate mills, pin mills and universal mills consist of a horizontal shaft with a rotor and, optionally, an impact surface (Fig. 14.12). Impact bar mills and impact hammer mills with vertical shafts are also used. [Pg.420]

Miranda, S. Universal mill Grinding versatility in an economical package. Powder and Bulk Eng., June 2002, 22-27. [Pg.2350]

Universal Mills Several manufacturers are now making universal mills, which are essentially hammer mill-style devices with fairly narrow chambers that can be fitted with either a variety of hammer mill type of hammers and screens (although usually only fixed hammers) or set up as a pin mill. These are useful where frequent product changes are made and it is necessary to be able to rapidly change the grincTcharacteristics of the devices, such as small lot manufacturing or grinding research. [Pg.2301]

UMT (Paladin), Universal Milling Technology See also Andritz Industriestrasse 15a D-40822 Mettmann, Germany... [Pg.1115]

Table I. Sheared, Gas-cut, and Universal Mill Edge Plates... Table I. Sheared, Gas-cut, and Universal Mill Edge Plates...
Fig. 4. Cutting a bank of sprockets on a universal milling machine. Fig. 4. Cutting a bank of sprockets on a universal milling machine.
Cutting tests were carried out on a universal milling machine with vertical milling head. During these tests the cutting force is indicated by the output of a piezoelectric three-component dynamometer via a charge amplifier with a calibration factor of 500 N/V. [Pg.48]


See other pages where Universal mill is mentioned: [Pg.114]    [Pg.209]    [Pg.179]    [Pg.179]    [Pg.2346]    [Pg.3600]    [Pg.5]    [Pg.668]    [Pg.332]    [Pg.282]    [Pg.1403]    [Pg.229]   
See also in sourсe #XX -- [ Pg.209 ]




SEARCH



© 2024 chempedia.info