Turning and milling

The stacked steel plates were manufactured by milling [48]. The PTFE tubes were home-made by means of turning and milling. 

Expls may be machined to the same tolerances as metals. Turning and milling to a thousandth of an inch is not difficult with a good machine. However, the practical applicability of such precision is limited by the dimensional instability of most expl materials... 

The steel plates are made by milling and the PEEK tubes by turning and milling [39]. 

Budak E, Tunc LT (2010) Identification and modeling of process damping in turning and milling using a new approach. CIRP Ann Manuf Technol 59(l) 403-408 Koenigsberger E, Tlusty J (1967) Machine tool structures. 

Toenshoff HK, BuBmann W, Stanske C (1986) Hartbearbeitimg dutch Drehen und Frasen [hard cutting by turning and milling], tz fiir Metallbearbeitung 80 35 ... 

High-content PcBN grades (containing >80 % cBN) are used for machining of cast irons, heavy turning, and milling of hardened... 

Thin walled pieces are only pickled in an electrolytic or salt bath. It is important that not only the surface layer of oxide, but also the underlying oxygen enriched diffusion zone is removed. Otherwise, the machinability and the service life of turning and milling tools would be negatively affected. 

Holes may be formed using a diamond tipped or tungsten carbide drill, by turning and milling or, for laminate thicknesses less than 4 mm, by bit by bit punching with a concave punching tool. 

Machinability m9- she-n3- bi-lo-te (ca. 1864) vt.(l) In fabricating materials by such operations as drilling, lathe-turning, and milling, the ease with which the material is removed. 

While cermets have a hardness similar to sintered hard metals, these are less sensitive to diffusion and they have a better friction and wear behavior. They are capable of machining at speeds higher than those used for sintered hard metals. They excel in the semi-finish turning and milling and finishing of steels and stainless steels. The material properly deficiencies between high-speed steels and sintered hard metals is made up by the composites consisting of a dispersion of TiC or, less... 

---