Tubing Mechanical Properties

ELECTROMAGNETIC MONITORING OF MICROSTRUCTURE AND MECHANICAL PROPERTIES FOR COLD-ROLLED 12Kh2MFSR STEEL TUBE by V.A.Burganova, L.V. Kochman, V.A. Kuz mina and L.P. Chukanova, Vol.10, No. 4, 1974, pp. 432 -437... 

Inorganic membranes (29,36) are generaUy more stable than their polymeric counterparts. Mechanical property data have not been definitive for good comparisons. IndustriaUy, tube bundle and honeycomb constmctions predominate with surface areas 20 to 200 m. Cross-flow is generaUy the preferred mode of operation. Packing densities are greater than 1000 /m. Porous ceramics, sintered metal, and metal oxides on porous carbon support... 

Niobium is used as a substrate for platinum in impressed-current cathodic protection anodes because of its high anodic breakdown potential (100 V in seawater), good mechanical properties, good electrical conductivity, and the formation of an adherent passive oxide film when it is anodized. Other uses for niobium metal are in vacuum tubes, high pressure sodium vapor lamps, and in the manufacture of catalysts. 

Cast iron may be used under similar circumstances, but has inferior mechanical properties. It has been used, although not in current practice, for internal cathodic protection, where it has been demonstrated that the presence of ferrous ions in water is of benefit in reducing sulphide-induced attack on Cu alloy tube plate and tubesWater treatment has now been found to be a more practical method. 

A major advantage of the electroless nickel process is that deposition takes place at an almost uniform rate over surfaces of complex shape. Thus, electroless nickel can readily be applied to internal plating of tubes, valves, containers and other parts having deeply undercut surfaces where nickel coating by electrodeposition would be very difficult and costly. The resistance to corrosion of the coatings and their special mechanical properties also offer advantages in many instances where electrodeposited nickel could be applied without difficulty. 

Biomedical materials prepared from polysiloxane/PU IPNs have been studied, and it has been reported that these materials can be useful as steam-sterihzing medical tubing. The mechanical properties showed a very wide range. Silon-TSR temporary skin, which was composed with polysiloxane/PTFE IPNs, has been proposed for assisting bum healing. ... 

As regards the heat conduction through the solid parts of a cryostat, in the choice of the structural materials a compromise is sought for a low thermal conductivity and suitable mechanical properties. When possible, disordered materials are used in the case of metals, low-conductivity alloys are used as Cu-Ni or stainless steel, in the form of thin-walled tubes. In the evaluation of the heat conduction, the most useful data are the thermal conductivity integrals shown in Fig. 5.2 for some structural materials. The thermal conductivity integral between two temperatures TL and rH is defined as ... 

---