Transition phosphate

Inspired by the many hydrolytically-active metallo enzymes encountered in nature, extensive studies have been performed on so-called metallo micelles. These investigations usually focus on mixed micelles of a common surfactant together with a special chelating surfactant that exhibits a high affinity for transition-metal ions. These aggregates can have remarkable catalytic effects on the hydrolysis of activated carboxylic acid esters, phosphate esters and amides. In these reactions the exact role of the metal ion is not clear and may vary from one system to another. However, there are strong indications that the major function of the metal ion is the coordination of hydroxide anion in the Stem region of the micelle where it is in the proximity of the micelle-bound substrate. The first report of catalysis of a hydrolysis reaction by me tall omi cell es stems from 1978. In the years that... 

Complex Ion Formation. Phosphates form water-soluble complex ions with metallic cations, a phenomenon commonly called sequestration. In contrast to many complexing agents, polyphosphates are nonspecific and form soluble, charged complexes with virtually all metallic cations. Alkali metals are weakly complexed, but alkaline-earth and transition metals form more strongly associated complexes (eg, eq. 16). Quaternary ammonium ions are complexed Htde if at all because of their low charge density. The amount of metal ion that can be sequestered by polyphosphates generally increases... 

Phosphite triesters, P(OR)3, form donor complexes with transition metals and other acceptors and are oxidized to the respective phosphates under appropriate conditions. 

Multilayers of Diphosphates. One way to find surface reactions that may lead to the formation of SAMs is to look for reactions that result in an insoluble salt. This is the case for phosphate monolayers, based on their highly insoluble salts with tetravalent transition metal ions. In these salts, the phosphates form layer stmctures, one OH group sticking to either side. Thus, replacing the OH with an alkyl chain to form the alkyl phosphonic acid was expected to result in a bilayer stmcture with alkyl chains extending from both sides of the metal phosphate sheet (335). When zirconium (TV) is used the distance between next neighbor alkyl chains is - 0.53 nm, which forces either chain disorder or chain tilt so that VDW attractive interactions can be reestablished. 

Scotts technology (17) uses fluid-bed (Wurster column) technology to apply polymeric coatings to a number of fertilizer substrates including urea, potassium nitrate, potassium sulfate, and monoammonium phosphate (MAP). The coating material is appHed as a water-borne latex onto the fluidized substrate. As the substrate is fluidized with warm air (40—50°C), water is driven off and the latex coalesces into a continuous film around the fertilizer particle. The particular latex compositions used have selected glass-transition and blocking temperatures, which enable quick removal of the water before the soluble fertilizer core dissolves. This obviates the need to use precoats prior to the latex appHcation. 

In 1826 J. J. Berzelius found that acidification of solutions containing both molybdate and phosphate produced a yellow crystalline precipitate. This was the first example of a heteropolyanion and it actually contains the phos-phomolybdate ion, [PMoi204o] , which can be used in the quantitative estimation of phosphate. Since its discovery a host of other heteropolyanions have been prepared, mostly with molybdenum and tungsten but with more than 50 different heteroatoms, which include many non-metals and most transition metals — often in more than one oxidation state. Unless the heteroatom contributes to the colour, the heteropoly-molybdates and -tungstates are generally of varying shades of yellow. The free acids and the salts of small cations are extremely soluble in water but the salts of large cations such as Cs, Ba" and Pb" are usually insoluble. The solid salts are noticeably more stable thermally than are the salts of isopolyanions. Heteropoly compounds have been applied extensively as catalysts in the petrochemicals industry, as precipitants for numerous dyes with which they form lakes and, in the case of the Mo compounds, as flame retardants. 

Znj(P04)2 4H2 0 appears in three crystal forms, a-hopeite (rhombic plates), 3-hopeite (rhombic crystals), and p-hopeite (triclinic crystals). Their transition points are at 105, 140 and 163°C respectively. It has been observed that zinc phosphate coatings heated in the absence of air lose their corrosion resistance at between 150 and 163°C. 

Due to mechanistic requirements, most of these enzymes are quite specific for the nucleophilic component, which most often is dihydroxyacetone phosphate (DHAP, 3-hydroxy-2-ox-opropyl phosphate) or pyruvate (2-oxopropanoate), while they allow a reasonable variation of the electrophile, which usually is an aldehyde. Activation of the donor substrate by stereospecific deprotonation is either achieved via imine/enamine formation (type 1 aldolases) or via transition metal ion induced enolization (type 2 aldolases mostly Zn2 )2. The approach of the aldol acceptor occurs stereospecifically following an overall retention mechanism, while facial differentiation of the aldehyde is responsible for the relative stereoselectivity. 

Solid catalysts for the metathesis reaction are mainly transition metal oxides, carbonyls, or sulfides deposited on high surface area supports (oxides and phosphates). After activation, a wide variety of solid catalysts is effective, for the metathesis of alkenes. Table I (1, 34 38) gives a survey of the more efficient catalysts which have been reported to convert propene into ethene and linear butenes. The most active ones contain rhenium, molybdenum, or tungsten. An outstanding catalyst is rhenium oxide on alumina, which is active under very mild conditions, viz. room temperature and atmospheric pressure, yielding exclusively the primary metathesis products. 

Although the 3 - and 5 -polyphosphate derivatives mentioned above exhibit exquisite inhibitory potency these compounds are not cell permeable. To take advantage ofthepotency of such derivatives for studies with intact cells and tissues, there are two possibilities. One is chemically to protect the phosphate groups from exonucleotidases that also allows the compound to transit the membrane intact. The other is to provide a precursor molecule that is cell permeable and is then metabolized into an inhibitor by intracellular enzymes. The general term for such a compound is prodrug nucleotide precursors are also referred to as pronucleotides. Families of protected monophosphate derivatives were synthesized, based on (3-L- and 3-D-2, 5 -dd-3 -AMP, 3-L-2, 3 -dd-5 -AMP, and the acyclic 9-substituted adenines, PMEA and PMPA. Protective substituents were (i) -( -pivaloyl-2-thioethyl) ... 

The transition took a course independent of concentration, reversible and extraordinarily fast. Transition temperature and kinetics were independent of pH and of the concentration of the salt. Measurements have been made either in acetic acid, (pH 3.0) or in 50 mM phosphate buffer at pH 7.5. 

Transition metal dithio- and diseleno-phosphate complexes. J. R. Wasson, G. M. Woltermann and H. J. Stoklosa, Top. Curr. Chem., 1973,35,66-129 (428). 

The development of monoalkyl phosphate as a low skin irritating anionic surfactant is accented in a review with 30 references on monoalkyl phosphate salts, including surface-active properties, cutaneous effects, and applications to paste and liquid-type skin cleansers, and also phosphorylation reactions from the viewpoint of industrial production [26]. Amine salts of acrylate ester polymers, which are physiologically acceptable and useful as surfactants, are prepared by transesterification of alkyl acrylate polymers with 4-morpholinethanol or the alkanolamines and fatty alcohols or alkoxylated alkylphenols, and neutralizing with carboxylic or phosphoric acid. The polymer salt was used as an emulsifying agent for oils and waxes [70]. Preparation of pharmaceutical liposomes with surfactants derived from phosphoric acid is described in [279]. Lipid bilayer vesicles comprise an anionic or zwitterionic surfactant which when dispersed in H20 at a temperature above the phase transition temperature is in a micellar phase and a second lipid which is a single-chain fatty acid, fatty acid ester, or fatty alcohol which is in an emulsion phase, and cholesterol or a derivative. 

---