Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Transition electronic states

Transition Electronic states Excitation energies Experiment3... [Pg.153]

UV-visible spectroscopy UV-Vis Valence electron transitions. Electronic state of metal from d-d transitions. Identification of unusual ligands, e.g., Cu(II)—SR, Fe "—OPh, Fe —0—Fe . Single crystals and polarized light give geometrical information. [Pg.193]

Figure Al.6.21. Bra and ket wavepacket dynamics which detennine the coherence overlap, (( ) ( ) ). Vertical arrows mark the transitions between electronic states and horizontal arrows indicate free propagation on the potential surface. Full curves are used for the ket wavepacket, while dashed curves indicate the bra wavepacket. (a) Stimulated emission, (b) Excited state (transient) absorption (from [41]). Figure Al.6.21. Bra and ket wavepacket dynamics which detennine the coherence overlap, (( ) ( ) ). Vertical arrows mark the transitions between electronic states and horizontal arrows indicate free propagation on the potential surface. Full curves are used for the ket wavepacket, while dashed curves indicate the bra wavepacket. (a) Stimulated emission, (b) Excited state (transient) absorption (from [41]).
Although the transition to difhision control is satisfactorily described in such an approach, even for these apparently simple elementary reactions the situation in reality appears to be more complex due to the participation of weakly bonding or repulsive electronic states which may become increasingly coupled as the bath gas density increases. These processes manifest tliemselves in iodine atom and bromine atom recombination in some bath gases at high densities where marked deviations from TronnaF behaviour are observed [3, 4]. In particular, it is found that the transition from Lto is significantly broader than... [Pg.846]

In this section we concentrate on the electronic and vibrational parts of the wavefimctions. It is convenient to treat the nuclear configuration in temis of nomial coordinates describing the displacements from the equilibrium position. We call these nuclear nomial coordinates Q- and use the symbol Q without a subscript to designate the whole set. Similarly, the symbol v. designates the coordinates of the th electron and v the whole set of electronic coordinates. We also use subscripts 1 and ii to designate the lower and upper electronic states of a transition, and subscripts a and b to number the vibrational states in the respective electronic states. The total wavefiinction f can be written... [Pg.1127]

This last transition moment integral, if plugged into equation (B 1.1.2). will give the integrated intensity of a vibronic band, i.e. of a transition starting from vibrational state a of electronic state 1 and ending on vibrational level b of electronic state u. [Pg.1128]

Now the spectrum will show various transitions originating with state iih and ending on the various vibrational levels la of the lower electronic state. Equation (Bl.1.14) (or Bl.1.13) if we have to worry about variation of transition... [Pg.1131]

We now discuss the lifetime of an excited electronic state of a molecule. To simplify the discussion we will consider a molecule in a high-pressure gas or in solution where vibrational relaxation occurs rapidly, we will assume that the molecule is in the lowest vibrational level of the upper electronic state, level uO, and we will fiirther assume that we need only consider the zero-order tenn of equation (BE 1.7). A number of radiative transitions are possible, ending on the various vibrational levels a of the lower state, usually the ground state. The total rate constant for radiative decay, which we will call, is the sum of the rate constants,... [Pg.1132]

The selection rule for vibronic states is then straightforward. It is obtained by exactly the same procedure as described above for the electronic selection rules. In particular, the lowest vibrational level of the ground electronic state of most stable polyatomic molecules will be totally synnnetric. Transitions originating in that vibronic level must go to an excited state vibronic level whose synnnetry is the same as one of the coordinates, v, y, or z. [Pg.1138]

An interesting example occurs in the spectrum of the C2 molecule. The usual rule of absorption spectroscopy is that the transitions originate in the ground electronic state because only it has sufficient population. However, in C2 transitions were observed starting both from a fl state and from a jTstate, so it was not... [Pg.1141]

One very important aspect of two-photon absorption is that the selection ndes for atoms or synnnetrical molecules are different from one-photon selection ndes. In particular, for molecules with a centre of synnnetry, two-photon absorption is allowed oidy for g g or u u transitions, while one-photon absorption requires g-f u transitions. Therefore, a whole different set of electronic states becomes allowed for two-photon spectroscopy. The group-theoretical selection ndes for two-photon spectra are obtained from the synnnetries... [Pg.1146]

The siim-over-states method for calculating the resonant enlrancement begins with an expression for the resonance Raman intensity, /.y, for the transition from initial state to final state /in the ground electronic state, and is given by [14]... [Pg.1161]

Since the vibrational eigenstates of the ground electronic state constitute an orthonomial basis set, tire off-diagonal matrix elements in equation (B 1.3.14) will vanish unless the ground state electronic polarizability depends on nuclear coordinates. (This is the Raman analogue of the requirement in infrared spectroscopy that, to observe a transition, the electronic dipole moment in the ground electronic state must properly vary with nuclear displacements from... [Pg.1192]

The SHG/SFG technique is not restricted to interface spectroscopy of the delocalized electronic states of solids. It is also a powerful tool for spectroscopy of electronic transitions in molecules. Figure Bl.5.13 presents such an example for a monolayer of the R-enantiomer of the molecule 2,2 -dihydroxyl-l,l -binaphthyl, (R)-BN, at the air/water interface [ ]. The spectra reveal two-photon resonance features near wavelengths of 332 and 340 mu that are assigned to the two lowest exciton-split transitions in the naphtli-2-ol... [Pg.1293]

Electron-impact energy-loss spectroscopy (EELS) differs from other electron spectroscopies in that it is possible to observe transitions to states below the first ionization edge electronic transitions to excited states of the neutral, vibrational and even rotational transitions can be observed. This is a consequence of the detected electrons not originating in the sample. Conversely, there is a problem when electron impact induces an ionizing transition. For each such event there are two outgoing electrons. To precisely account for the energy deposited in the target, the two electrons must be measured in coincidence. [Pg.1307]

Figure Bl.22.4. Differential IR absorption spectra from a metal-oxide silicon field-effect transistor (MOSFET) as a fiinction of gate voltage (or inversion layer density, n, which is the parameter reported in the figure). Clear peaks are seen in these spectra for the 0-1, 0-2 and 0-3 inter-electric-field subband transitions that develop for charge carriers when confined to a narrow (<100 A) region near the oxide-semiconductor interface. The inset shows a schematic representation of the attenuated total reflection (ATR) arrangement used in these experiments. These data provide an example of the use of ATR IR spectroscopy for the probing of electronic states in semiconductor surfaces [44]-... Figure Bl.22.4. Differential IR absorption spectra from a metal-oxide silicon field-effect transistor (MOSFET) as a fiinction of gate voltage (or inversion layer density, n, which is the parameter reported in the figure). Clear peaks are seen in these spectra for the 0-1, 0-2 and 0-3 inter-electric-field subband transitions that develop for charge carriers when confined to a narrow (<100 A) region near the oxide-semiconductor interface. The inset shows a schematic representation of the attenuated total reflection (ATR) arrangement used in these experiments. These data provide an example of the use of ATR IR spectroscopy for the probing of electronic states in semiconductor surfaces [44]-...
To compare the relative populations of vibrational levels, the intensities of vibrational transitions out of these levels are compared. Figure B2.3.10 displays typical potential energy curves of the ground and an excited electronic state of a diatomic molecule. The intensity of a (v, v ) vibrational transition can be written as... [Pg.2073]

This teclnhque can be used both to pennit the spectroscopic detection of molecules, such as H2 and HCl, whose first electronic transition lies in the vacuum ultraviolet spectral region, for which laser excitation is possible but inconvenient [ ], or molecules such as CH that do not fluoresce. With 2-photon excitation, the required wavelengdis are in the ultraviolet, conveniently generated by frequency-doubled dye lasers, rather than 1-photon excitation in the vacuum ultraviolet. Figure B2.3.17 displays 2 + 1 REMPI spectra of the HCl and DCl products, both in their v = 0 vibrational levels, from the Cl + (CHg) CD reaction [ ]. For some electronic states of HCl/DCl, both parent and fragment ions are produced, and the spectrum in figure B2.3.17 for the DCl product was recorded by monitoring mass 2 (D ions. In this case, both isotopomers (D Cl and D Cl) are detected. [Pg.2083]

Our intention is to give a brief survey of advanced theoretical methods used to detennine the electronic and geometric stmcture of solids and surfaces. The electronic stmcture encompasses the energies and wavefunctions (and other properties derived from them) of the electronic states in solids, while the geometric stmcture refers to the equilibrium atomic positions. Quantities that can be derived from the electronic stmcture calculations include the electronic (electron energies, charge densities), vibrational (phonon spectra), stmctiiral (lattice constants, equilibrium stmctiires), mechanical (bulk moduli, elastic constants) and optical (absorption, transmission) properties of crystals. We will also report on teclmiques used to study solid surfaces, with particular examples drawn from chemisorption on transition metal surfaces. [Pg.2201]


See other pages where Transition electronic states is mentioned: [Pg.31]    [Pg.115]    [Pg.236]    [Pg.245]    [Pg.253]    [Pg.260]    [Pg.269]    [Pg.846]    [Pg.875]    [Pg.956]    [Pg.1119]    [Pg.1120]    [Pg.1130]    [Pg.1132]    [Pg.1142]    [Pg.1143]    [Pg.1151]    [Pg.1161]    [Pg.1193]    [Pg.1200]    [Pg.1306]    [Pg.1307]    [Pg.1610]    [Pg.2022]    [Pg.2061]    [Pg.2073]    [Pg.2222]    [Pg.2321]    [Pg.2391]    [Pg.2395]    [Pg.2395]    [Pg.2447]   
See also in sourсe #XX -- [ Pg.25 ]




SEARCH



20-electron transition state

20-electron transition state

A Transition-State Perspective of Proton-Coupled Electron Transfers

Electron transfer reactions quantum transition-state theory

Electronic Structure of Transition States

Electronic Transitions and Lifetime of Excited States in Porphyrin-Based Compounds

Electronic energies, transition state

Electronic entropy spin-state transitions

Electronic structure calculations transition state theory

Electronic transition state theory

Hemes electronic state transitions

Hydrazino group, electronic effects hydrogen-bonded transition state

Palladium compounds, electronic structure transition state

Spectroscopic Techniques for Measuring Collision-Induced Transitions in the Electronic Ground State of Molecules

Sulfur atoms, electronic states transition state

Transition between molecular electronic states

Transition elements valence electronic state

Transition state theory electronic structure

Transition states electronic structure

Transition states, 3 center-2 electron

Transitions, between electronic states

© 2024 chempedia.info