Titanium silicates oxidation

Titanium Silicates. A number of titanium siUcate minerals are known (160) examples are Hsted in Table 19. In most cases, it is convenient to classify these on the basis of the connectivity of the SiO building blocks, eg, isolated tetrahedra, chains, and rings, that are typical of siUcates in general. In some cases, the SiO units may be replaced, even if only to a limited extent by TiO. For example, up to 6% of the SiO in the garnet schorlomite can be replaced by TiO. In general, replacement of SiO by TiO bull ding blocks increases the refractive indices of these minerals. Ti has also replaced Si in the framework of various zeofltes. In addition, the catalytic activity of both titanium-substituted ZSM-5 (TS-1) and ZSM-11 (TS-2) has received attention (161), eg, the selective oxidation of phenol, with hydrogen peroxide, to hydroquinone and catechol over TS-1 has been operated at the 10,000 t/yr scale in Italy (162). 

Enichem made one of the most important steps forward in the development of general heterogeneous oxidation catalysts in the early 1990s with the commercialization of titanium silicate (TS-1) catalysts. TS-1 has a structure similar to ZSM-5 in which the aluminium has been replaced by titanium it is prepared by reaction of tetraethylorthosilicate and tetra-ethylorthotitanate in the presence of an organic base such as tetrapropy-lammonium hydroxide. This catalyst is especially useful for oxidation reactions using hydrogen peroxide (Scheme 4.11), from which the only byproduct is water, clean production of hydroquinone being one of the possibilities. 

In earlier work, Bhaumik and Kumar (1995) have reported that the use of two liquid phases in the oxidation of hydrophobic organic substances with aqueous H2O2 using titanium silicate as the catalyst not only enhances the rate of oxidation but also improves selectivity for species like toluene, anisole, and benzyl alcohol. For a single liquid phase acetonitrile was u.sed a solvent. The solid-liquid system gives high ortho selectivity. Thus, in the case of anisole the ratios of o to p for. solid-liquid and solid-liquid-liquid system were 2.22 1 and 0.35 1, respectively. 

Titanium silicate molecular sieves not only catalyze the oxidation of C=C double bonds but can be successfully employed for the oxidative cleavage of carbon-nitrogen double bonds as well. Tosylhydrazones and imines are oxidized to their corresponding carbonyl compounds (243) (Scheme 19). Similarly, oximes can be cleaved to their corresponding carbonyl compounds (165). The conversion of cyclic dienes into hydroxyl ketones or lactones is a novel reaction reported by Kumar et al. (165) (Scheme 20). Thus, when cyclopentadienes, 1,3-cyclohexadiene, or furan is treated with aqueous H202 in acetone at reflux temperatures for 6 h in the presence of TS-1, the corresponding hydroxyl ketone or lactone is obtained in moderate to good yields (208). 

Anilines are converted into nitrosoarenes ArNO by the action of hydrogen peroxide in the presence of [Mo(0)(02)2(H20) (HMPA)]224, whereas catalysis of the reaction by titanium silicate and zeolites results in the formation of azoxybenzenes ArN (0)=NAr225. Azo compounds ArN=NAr are formed in 42-99% yields by the phase-transfer assisted potassium permanganate oxidation of primary aromatic amines in aqueous benzene containing a little tetrabutylammonium bromide226. The reaction of arylamines with chromyl chloride gives solid adducts which, on hydrolysis, yield mixtures of azo compounds, p-benzoquinone and p-benzoquinone anils 234227. 

Acidity, 27 284, 285 catalytic performance, 30 121 crystalline titanium silicates, 41 319-320 estimating, 37 166 heteropoly compounds, 41 139-150 ion exchange and, zeolites, 31 5-6 sulfate-supported metal oxides, 37 186-187 surface, monolayer dispersion, 37 34-35 tin-antimony oxide, 30 114-115, 125-1256 Acids, see also specific compounds adsorption of, on oxide surfaces, 25 243-245... 

R. Meiers, U. Dingerdissen, and W. F. Holderich, Synthesis of propylene oxide from propylene, oxygen and hydrogen catalyzed by palladium—platinum-containing titanium silicate, J. Catal. 176, 376-386(1998). 

The rate of silicate sol and gel formation is pH and water-alcohol-sensitive as is the solubility of the amorphous silica that is formed. Silica networks are based on (Si04) " tetrahedra modified by (O3 Si-O, M+) units and often addition of boron oxide, aluminum oxide, titanium IV oxide, or zirconium IV oxide. 

SCHEME 72. Oxidation of a-hydroxy-containing monoterpenes using titanium silicate catalysts... 

Besides a variety of other methods, phenols can be prepared by metal-catalyzed oxidation of aromatic compounds with hydrogen peroxide. Often, however, the selectivity of this reaction is rather poor since phenol is more reactive toward oxidation than benzene itself, and substantial overoxidation occurs. In 1990/91 Kumar and coworkers reported on the hydroxylation of some aromatic compounds using titanium silicate TS-2 as catalyst and hydrogen peroxide as oxygen donor (equation 72) . Conversions ranged from 54% to 81% with substituted aromatic compounds being mainly transformed into the ortho-and para-products. With benzene as substrate, phenol as the monohydroxylated product... 

Selective Oxidation of Alkanes, Alkenes, and Phenol with Aqueous H2O2 on Titanium Silicate Molecular Sieves... 

Titanium containing pure-silica ZSM-5 (TS-1) materials are synthesized using different methods. The activity of the titanium containing catalysts for the oxidation of alkanes, alkenes and phenol at temperatures below 100 °C using aqueous H2O2 as oxidant is reported. The relationships between the physicochemical and catalytic properties of these titanium silicates are discussed. The effects of added duminum and sodium on the catalytic activity of TS-1 are described. The addition of sodium during the synthesis of TS-1 is detrimental to the catalytic activity while sodium incorporation into preformed TS-1 is not. The framework substitution of aluminum for silicon appears to decrease the amount of framework titanium. 

The activity data confirm that an IR absorption band at 960 cm" is a necessary condition for titanium silicates to be active for the selective oxidation of hydrocarbons with aqueous H2O2 as suggested by Huybrechts et al. (9). However, this band is not a sufficient condition for predicting the activity of the TS-1 catalyst. Although TS-l(B) and TS-l(C) show intensities for the 960 cm- band similar to TS-1 (A), their activities are different First of all, the reaction data reveal that TS-1 (A) is much more active than TS-l(B) for phenol hydroxylation, while both samples show similar activity for n-octane oxidation and 1-hexene epoxidation. Therefore, the presence of the IR band at 960 cm-i in TS-1 catalysts may correlate with the activities for the oxidation of n-octane and the epoxidation of 1-hexene but not for phenol hydroxylation. However, note that the amorphous Ti02-Si02 also has an IR absorption band at 960 cm- and it does not activate either substrate. 

---