Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Time-resolved fluorescence spectroscopy pulse methods

A new era of research in fluorescence spectroscopy has emerged with the advent of powerful lasers capable of generating short-lived pulses and with the simultaneous development of sophisticated detection methods. While research groups were previously limited to the study of processes on the microsecond and nanosecond time scale, these developments have expanded the accessible time scale to the pico- and femtosecond. Time-resolved fluorescent measurements are being used, for example, to unravel the dynamics of excited states (excitons) generated in conjugated polymer films (such as stimulated emission) and the processes that... [Pg.823]

A method less common for lifetime measurements is the so-called pump-probe or double-pulse approach. Like time- and frequency-domain detection, the technique originates in non-spatially-resolved fluorescence spectroscopy [ 19]. In this technique, two very short excitation pulses follow each other. The first pulse excites fluorochromes inside the detection volume to full or partial saturation. The second pulse, or probe pulse, arrives at a variable (ns) time delay. If the time delay between the pulses is short compared to the fluorescence lifetime, most of the fluorochromes will still be in the excited state when the second pulse arrives so that the second pulse cannot excite additional fluorochromes and thus does not lead to additional fluorescence. If the time delay is long, most fluorochromes will have relaxed back to their ground state, so that the second pulse leads to... [Pg.151]

Hydrogen transfer in excited electronic states is being intensively studied with time-resolved spectroscopy. A typical scheme of electronic terms is shown in fig. 46. A vertical optical transition, induced by a picosecond laser pulse, populates the initial well of the excited Si state. The reverse optical transition, observed as the fluorescence band Fj, is accompanied by proton transfer to the second well with lower energy. This transfer is registered as the appearance of another fluorescence band, F2, with a large anti-Stokes shift. The rate constant is inferred from the time dependence of the relative intensities of these bands in dual fluorescence. The experimental data obtained by this method have been reviewed by Barbara et al. [1989]. We only quote the example of hydrogen transfer in the excited state of... [Pg.109]

We summarize here two time-resolved spectroscopic methods, giving direct information on picosecond and nanosecond photodynamics of solid surface. One is a fluorescence spectroscopy which analyzes fluorescence behavior of the surface area excited by the evanescent laser pulse. The other is to get transient UV-visible absorption spectra by using the evanescent light as a probe beam. [Pg.15]

The methods discussed so far, fluorescence upconversion, the various pump-probe spectroscopies, and the polarized variations for the measurement of anisotropy, are essentially conventional spectroscopies adapted to the femtosecond regime. At the simplest level of interpretation, the information content of these conventional time-resolved methods pertains to populations in resonantly prepared or probed states. As applied to chemical kinetics, for most slow reactions (on the ten picosecond and longer time scales), populations adequately specify the position of the reaction coordinate intermediates and products show up as time-delayed spectral entities, and assignment of the transient spectra to chemical structures follows, in most cases, the same principles used in spectroscopic experiments performed with continuous wave or nanosecond pulsed lasers. [Pg.1984]

A useful and common way of describing the reorientation dynamics of molecules in the condensed phase is to use single molecule reorientation correlation functions. These will be described later when we discuss solute molecular reorientational dynamics. Indirect experimental probes of the reorientation dynamics of molecules in neat bulk liquids include techniques such as IR, Raman, and NMR spectroscopy. More direct probes involve a variety of time-resolved methods such as dielectric relaxation, time-resolved absorption and emission spectroscopy, and the optical Kerr effect. The basic idea of time-resolved spectroscopic techniques is that a short polarized laser pulse removes a subset of molecular orientations from the equifibrium orientational distribution. The relaxation of the perturbed distribution is monitored by the absorption of a second time-delayed pulse or by the time-dependent change in the fluorescence depolarization. [Pg.232]


See other pages where Time-resolved fluorescence spectroscopy pulse methods is mentioned: [Pg.1968]    [Pg.129]    [Pg.17]    [Pg.1968]    [Pg.818]    [Pg.5]    [Pg.704]    [Pg.286]    [Pg.45]    [Pg.140]    [Pg.3]    [Pg.332]    [Pg.600]    [Pg.1988]    [Pg.235]    [Pg.354]    [Pg.20]    [Pg.428]    [Pg.194]    [Pg.179]    [Pg.179]    [Pg.448]   
See also in sourсe #XX -- [ Pg.298 , Pg.345 ]




SEARCH



7-resolved spectroscopy

Fluorescence methods

Fluorescence spectroscopy

Fluorescence time-resolved spectroscopy

Fluorescent method

Fluorescent spectroscopy

Pulse time-resolved

Pulsed Methods

Pulsed fluorescence

Pulsed fluorescence method

Resolvent method

Spectroscopy method

Time resolved spectroscopy

Time spectroscopy

Time-resolved fluorescence

Time-resolved spectroscopies spectroscopy

Timing pulse

© 2024 chempedia.info