Time domain measurements, electrochemical impedance spectroscopy

In early Me UPD studies on single crystal substrates S [3.89, 3.98, 3.122], classical electrochemical techniques such as cyclic voltammetry, r(E,ju) isotherm measurements using thin-layer techniques ( PlL, FTTL), transient techniques in the time domain, and electrochemical impedance spectroscopy (EIS) in the frequency... 

Conventional kinetics is largely concerned with the description of dynamic processes in the time domain, and in consequence few conceptual problems are encountered in understanding time resolved experiments. By contrast, frequency resolved measurements often pose more of a challenge to understanding, in spite of the obvious correspondence between the time and frequency domains. This conceptual difficulty may explain why the only frequency resolved method to achieve universal acceptance in electrochemistry is electrochemical impedance spectroscopy (EIS) [27-29], which analyses the response of electrochemical systems to periodic (sinusoidal) perturbations of voltage or current. It is clear that EIS is a very powerful method, and there... 

ABSTRACT State determination of Li-ion cells is often accomplished with Electrochemical Impedance Spectroscopy (EIS). The measurement results are in frequency domain and used to describe the state of a Li-ion cell by parameterizing impedance-based models. Since EIS is a costly measurement method, an alternative method for the parameterization of impedance-based models with time-domain data easier to record is presented in this work. For this purpose the model equations from the impedance-based models are transformed from frequency domain into time domain. As an excitation signal a current step is applied. The resulting voltage step responses are the model equations in time domain. They are presented for lumped and derived for distributed electrical circuit elements, i.e. Warburg impedance, Constant Phase Element and RCPE. A resulting technique is the determination of the inner resistance from an impedance spectrum which is performed on measurement data. 

Impedance spectroscopy or electrochemical impedance spectroscopy is a powerful electrochemical technique used to investigate the binding events that occur at the electrode surface. The same three electrode systems comprising of a WE, RE and CE are utilized for the EIS experiment. Electrochemical impedance is usually measured by applying an AC sine wave potential with low amplitude (5—10 mV peak to peak) superimposed on a DC potential to the electrochemical system. The AC signal scans the frequency domain, allowing the individual excitation of different processes with different time constants. Therefore, slow processes like chemical reactions and fast reactions Hke ionic conduction can be studied independently this way. 

In most cases, the measurements are carried out isothermally in the frequency domain and the terms dielectric spectroscopy (DS) and dielectric relaxation spectroscopy (DRS) are then used. Other terms frequently used for DRS are impedance spectroscopy and admittance spectroscopy. Impedance spectroscopy is usually used in connection with electrolytes and electrochemical studies, whereas admittance spectroscopy often refers to semiconductors and devices. Isothermal measurements in the time domain are often used, either as a convenient tool for extending the range of measurements to low frequencies (slow time-domain spectroscopy, dc transient current method, isothermal charging-discharging current measurements) or for fast measurements corresponding to the frequency range of about 10 MHz - 10 GHz (time-domain spectroscopy or time-domain reflectometry). Finally, TSDC is a special dielectric technique in the temperature domain, which will be discussed in Section 2.2. 

---