Thermal Decomposition, Vapor Pressure, Vaporization

Balankin et al. [3] found that only the liquid Th appears under Langmuir vaporization conditions. The vapor partial pressures given as a function of stoichiometry are 

The equations describe the partial pressures as a function of x in Th. N and, in particular, define the congruent composition when the vapors have the same composition as the solid, i.e., when pN/pjh = x/2(1-x). 

Early measurements of N2 partial pressures over ThN in a Ta Knudsen cell that were reported as being preliminary can be associated with the reaction ThN(s)- Th (s or l) + V2N2 and are given by the equation 

The solid material was analyzed by ignition as ThN 05, the apparent excess N being very probably due to oxygen present as impurity. 

The vaporization from the Th-rich specimens (rows 2, 5, and 7) is much slower than from more N-rich specimens. Vapors of Th are monatomic [6, 7]. According to the kinetic theory, the N2 and Th molecules effuse at the relative rates 

---

Van Der Vis MGM, Cordfuuke EHP, Konings RJM (1995) The thermodynamic propertyes of tetraethoxysilane (TEOS) and an infrared study of its thermal decomposition, vapor pressure of TEOS. J de Physique IV, 5, C5-75-82... 

Some alkylphenols in commercial production have low vapor pressures and/or low thermal decomposition temperatures. Eor these products, the economics of distillation are poor and other recovery processes are used. Crystallisation from a solvent is the most common nondistUlation method for the purification of these alkylphenols. 

Solutions of these fire retardant formulations are impregnated into wood under fliU cell pressure treatment to obtain dry chemical retentions of 65 to 95 kg/m this type of treatment greatly reduces flame-spread and afterglow. These effects are the result of changed thermal decomposition reactions that favor production of carbon dioxide and water (vapor) as opposed to more flammable components (55). Char oxidation (glowing or smoldering) is also inhibited. 

Thermal Decomposition of GIO2. Chloiine dioxide decomposition in the gas phase is chaiacteiized by a slow induction period followed by a rapid autocatalytic phase that may be explosive if the initial concentration is above a partial pressure of 10.1 kPa (76 mm Hg) (27). Mechanistic investigations indicate that the intermediates formed include the unstable chlorine oxide, CI2O2. The presence of water vapor tends to extend the duration of the induction period, presumably by reaction with this intermediate. When water vapor concentration and temperature are both high, the decomposition of chlorine dioxide can proceed smoothly rather than explosively. Apparently under these conditions, all decomposition takes place in the induction period, and water vapor inhibits the autocatalytic phase altogether. The products of chlorine dioxide decomposition in the gas phase include chlorine, oxygen, HCl, HCIO, and HCIO. The ratios of products formed during decomposition depend on the concentration of water vapor and temperature (27). 

Notwithstanding their very low vapor pressure, their good thermal stability (for thermal decomposition temperatures of several ionic liquids, see [11, 12]) and their wide operating range, the key property of ionic liquids is the potential to tune their physical and chemical properties by variation of the nature of the anions and cations. An illustration of their versatility is given by their exceptional solubility characteristics, which make them good candidates for multiphasic reactions (see Section 5.3.4). Their miscibility with water, for example, depends not only on the hydrophobicity of the cation, but also on the nature of the anion and on the temperature. 

The atmospheric reduced crude is the feedstock for the vacuum distillation unit. To prevent thermal decomposition (cracking) of the higher boiling point hydrocarbons in the crude oil, the pressure in the vacuum distillation fractionation column is reduced to about one-twentieth of an atmosphere absolute (one atmosphere pressure is 14.7 psia or 760 mm Fig). This effectively reduces the boiling points of the hydrocarbons several hundred degrees Fahrenheit. The components boiling below about 1050°F (565°C) are vaporized and removed as vacuum gas... 

Dinitrogen oxide, N20, gas was generated from the thermal decomposition of ammonium nitrate and collected over water. The wet gas occupied 126 mL at 21°C when the atmospheric pressure was 755 Torr. What volume would the same amount of dry dinitrogen oxide have occupied if collected at 755 Torr and 21°C The vapor pressure of water is... 

Chloroxytrifluoromethane, 26 137-139 reactions, 26 140-143 addition to alkenes, 26 145-146 oxidative addition, 26 141-145 vibrational spectra, 26 139 Chloryl cation, 18 356-359 internal force constants of, 18 359 molecular structure of, 18 358, 359 properties of, 18 357, 358 synthesis of, 18 357, 358 vibrational spectra of, 18 358, 359 Chloryl compounds, reactions of, 5 61 Chloryl fluoride, 18 347-356 chemical properties of, 18 353-356 fluoride complexes of, 5 59 molecular structure of, 18 349-352 physical properties of, 18 352, 353 preparation, 5 55-57 and reactions, 27 176 properties of, 5 48 reactions, 5 58-61, 18 356 synthesis of, 18 347-349 thermal decomposition of, 18 354, 355 vapor pressures, 5 57, 18 353 vibrational spectra of, 18 349-352 Chloryl ion, 9 277 Cholegobin, 46 529 Cholesterol, astatination, 31 7 Cholorofluorphosphine, 13 378-380 h CHjPRj complexes, osmium, 37 274 Chromatium, HiPIP sequence, 38 249 Chromatium vinosum HiPIP, 38 108, 133 Fe4S4 + core, 33 60 Chromato complexes, osmium, 37 287... 

These examples of explosives show beyond doubt that the m.p. is raised by the introduction of amino group/s. Further, data on thermal decomposition show that the thermal stability is associated with high melting point and low vapor pressure... 

Vapor binding, or air lock, is another common cause of household radiator malfunction. Often, the vapor accumulating in the radiator is CO,2, rather than air. The C02 originates from the thermal decomposition of carbonates in the boiler. Regardless, air and C02 form a noncondensable vapor in the radiator. These noncondensables mix with the steam in the radiator. The noncondensables then reduce the concentration of the steam, by dilution. The diluted steam has a lower partial pressure than pure steam. The lower the partial pressure of the steam, the more difficult it is to condense. As the rate of condensation of the steam drops, so does the heat radiated by the radiator. 

---