Allylic oxidation synthesis

All that remains before the final destination is reached is the introduction of the C-l3 oxygen and attachment of the side chain. A simple oxidation of compound 4 with pyridinium chlorochro-mate (PCC) provides the desired A-ring enone in 75 % yield via a regioselective allylic oxidation. Sodium borohydride reduction of the latter compound then leads to the desired 13a-hydroxy compound 2 (83% yield). Sequential treatment of 2 with sodium bis(trimethylsilyl)amide and /(-lactam 3 according to the Ojima-Holton method36 provides taxol bis(triethylsilyl ether) (86 % yield, based on 89% conversion) from which taxol (1) can be liberated, in 80 % yield, by exposure to HF pyridine in THF at room temperature. Thus the total synthesis of (-)-taxol (1) was accomplished. 

The activity of the FePeCli6-S/tert-butyl hydroperoxide (TBHP) catalytic system was studied under mild reaction conditions for the synthesis of three a,p-unsaturated ketones 2-cyclohexen-l-one, carvone and veibenone by allylic oxidation of cyclohexene, hmonene, and a-pinene, respectively. Substrate conversions were higher than 80% and ketone yields decreased in the following order cyclohexen-1-one (47%), verbenone (22%), and carvone (12%). The large amount of oxidized sites of monoterpenes, especially limonene, may be the reason for the lower ketone yield obtained with this substrate. Additional tests snggested that molecular oxygen can act as co-oxidant and alcohol oxidation is an intermediate step in ketone formation. 

Bayardon and Sinou have reported the synthesis of chiral bisoxazolines, which also proved to be active ligands in the asymmetric allylic alkylation of l,3-diphenylprop-2-enyl acetate, as well as cyclopropanation, allylic oxidations and Diels-Alder reactions. [62] The ligands do not have a fluorine content greater than 60 wt% and so are not entirely preferentially soluble in fluorous solvents, which may lead to a significant ligand loss in the reaction system and in fact, all recycling attempts were unsuccessful. However, the catalytic results achieved were comparable with those obtained with their non-fluorous analogues. 

A second nonselective synthesis involved chain extension of the tosylate of ( )-citronellol (82) with 2-methylpentyl magnesium bromide and lithium tetrachlorocuprate catalysis to give the carbon skeleton 83 (Scheme 12A) [92]. Allylic oxidation with Se02 and ferf-butylhydroperoxide, hydrogenation of the... 

The second synthetic approach to oidiolactone C (61) is summarized in Scheme 20. This route also commences with the ozonolysis of trans-communic acid 180. Now, when this compound was exposed to ozone in excess, keto aldehyde 187 was obtained in 76% yield. The key step in this approach was the y-lactone closure via chemoselective reduction of the lactone moiety on compound 189 through a SN2 mechanism. Compound 189 could be prepared by saponification of the corresponding methyl ester with sodium propanethiolate. Once the primary alcohol is oxidized, the completion of the synthesis of key lactone 103 only requires the allylic oxidation of the C-17 methyl with concomitant closure of the 8-lactone. This conversion was achieved with Se02 in refluxing acetic acid to give 103 in 51% yield. 

The cyclohexene 121, which was readily accessible from the Diels-Alder reaction of methyl hexa-3,5-dienoate and 3,4-methylenedioxy-(3-nitrostyrene (108), served as the starting point for another formal total synthesis of ( )-lycorine (1) (Scheme 11) (113). In the event dissolving metal reduction of 121 with zinc followed by reduction of the intermediate cyclic hydroxamic acid with lithium diethoxyaluminum hydride provided the secondary amine 122. Transformation of 122 to the tetracyclic lactam 123 was achieved by sequential treatment with ethyl chloroformate and Bischler-Napieralski cyclization of the resulting carbamate with phosphorus oxychloride. Since attempts to effect cleanly the direct allylic oxidation of 123 to provide an intermediate suitable for subsequent elaboration to ( )-lycorine (1) were unsuccessful, a stepwise protocol was devised. Namely, addition of phenylselenyl bromide to 123 in acetic acid followed by hydrolysis of the intermediate acetates gave a mixture of two hydroxy se-lenides. Oxidative elimination of phenylselenous acid from the minor product afforded the allylic alcohol 124, whereas the major hydroxy selenide was resistant to oxidation and elimination. When 124 was treated with a small amount of acetic anhydride and sulfuric acid in acetic acid, the main product was the rearranged acetate 67, which had been previously converted to ( )-lycorine (108). 

The anodic oxidation of olefins in the presence of nucleophiles, such as CH3OH or CHjCOOH, is in principle a reaction of very great industrial interest since it permits allyl oxidation as well as C—C coupling. Nevertheless, it is hardly used industrially today. This is essentially due to the fact that the selectivities are frequently poor. Over the past few years, the reaction principle has been used in synthesis problems in the area of fine chemicals. For example, the anodic methoxylation of citronellol is a key step in a new rose oxide synthesis by Sumitomo35). 

Catalytic Asymmetric Synthesis Sharpless Oxidations of Allylic alcohols... 

W.-D. Woggon, Formation of C-0 Bonds by Allylic Oxidation with Selenium(IV) Oxide, in Stereoselective Synthesis (Houben-Weyl) 4th ed., 1996, (G. Helmchen, R. W. Hoffmann, J. Mulzer, E. Schau-mann, Eds.), 1996, Vol. E21 (Workbench Edition), 8, 4947—4956, Georg Thieme Verlag, Stuttgart. 

---