Substitutions boron trifluoride etherate

A one-pot reaction between a tryptophan ester, benzotriazole, and 2,5-dimethoxytetrahydrofuran in acetic acid gives the diastereomeric benzotriazolyl tetracycles, 349, in good yield. Substitution of the benzotriazole by reaction with silyl enol ethers and boron trifluoride etherate gives the corresponding ketones 350 and 351, and reaction with allylsilanes gives the corresponding alkenes 352 and 353. If the boron trifluoride etherate is added to the mixture before the silane, elimination of benzotriazole from 349 is also observed (Scheme 83) <1999T3489>. 

In contrast, when boron trifluoride etherate is substituted for the free boron trifluoride, only a trace of the hydrocarbon is formed, even after weeks of reaction.143 The unique effectiveness of boron trifluoride gas in promoting these reductions is believed to be due to several factors, including the ability of the coordinatively unsaturated boron center to rapidly and tightly coordinate with oxygen centers and to the thermodynamically favorable creation of a Si-F bond.1 A slight pressure of boron trifluoride gas must be maintained over the surface of the solution throughout the reaction because boron trifluoride has only limited solubility in the weakly coordinating dichloromethane solvent. 

The cobalt(I) complex CoBr(PPh3)3 as a boron trifluoride etherate selectively hydrogenates conjugated dienes to monoenes via an unusual 1,2-hydrogen addition at the more-substituted double bond (186). 

Electron-rich aromatic compounds, such as phenol, anisole and A,./V-dimethylaniline, add to bis(2-trichloroethyl) azodicarboxylate under the influence of lithium perchlorate, boron trifluoride etherate or zinc chloride to yield para-substituted products 74, which are transformed into the anilines 75 by means of zinc and acetic acid86. Triflic acid (trifluoromethanesulphonic acid) catalyses the reactions of phenyl azide with benzene, toluene, chlorobenzene and naphthalene, to give TV-arylanilines (equation 34)87. 

Elimination to yield alkenes can be induced thermally or by treatment with acids or bases (for one possible mechanism, see Figure 3.39) [138,206]. Less common thermal demetallations include the thermolysis of arylmethyloxy(phenyl)carbene complexes, which can lead to the formation of aryl-substituted acetophenones [276]. Further, (difluoroboroxy)carbene complexes of molybdenum, which can be prepared by treating molybdenum hexacarbonyl with an organolithium compound and then with boron trifluoride etherate at -60 °C, decompose at room temperature to yield acyl radicals [277]. 

When the chiral molybdenum Ti-allyl-substituted enone 147 was treated with lithium dimethylcuprate, formation of adduct 148 with fair selectivity was observed (Scheme 6.29) [69]. Interestingly, higher selectivities were obtained in the presence of boron trifluoride etherate. It is assumed that Lewis acid coordination induces the s-trans reactive conformation 149 [64]. Consequently, nucleophile attack anti to the molybdenum fragment should afford the major diastereomer 148. 

Oxidation of 2-(trimethylsilyloxy)furan (301) with iodosobenzene in the presence of boron trifluoride etherate and alcohols or acids results in the formation of 5-substituted 2(5//)-furanones 303. The first step of this conversion gives intermediate 302, which on nucleophilic substitution by alcohols or acids affords the products (89TL3019) (Scheme 75). 

Tetrahydrofuran itself can be opened using either the stoichiometric or the catalytic version of arene-promoted lithiation, but both cases need the activation by boron trifluoride. The catalytic reaction was performed by treating the solvent THF 324 with the complex boron trifluoride-etherate and a catalytic amount (4%) of naphthalene. The intermediate 325 was formed. Further reaction with carbonyl compounds and flnal hydrolysis yielded the expected 1,5-diols 326 (Scheme 95), which could be easily cyclized to the corresponding substituted tetrahydropyrans under acidic conditions (concentrated FlCl). 

In the search for a reactive functional group which could be substituted on the acetylacetonate ring, chloromethylation of these chelates was attempted. The initially formed products were too reactive to be characterized directly. Treatment of rhodium acetylacetonate with chloromethyl methyl ether in the presence of boron trifluoride etherate afforded a solution of a very reactive species, apparently the chloromethyl chelate (XXX) (26). Hydrolytic workup of this intermediate yielded a polymeric mixture of rhodium chelates, but these did not contain chlorine On the basis of evidence discussed later on electrophilic cleavage of carbon from metal chelate rings and on the basis of their NMR spectra, these polymers may be of the type shown below. Reaction of the intermediate with dry ethanol afforded an impure chelate which is apparently the trisethyl ether (XXXI). Treatment of the reactive intermediate with other nucleophiles gave intractable mixtures. 

These reagents are also useful for the preparation of 1,2-diols. Upon exposure to Lewis acids such as boron trifluoride etherate (BFa-OEta), the a-alkoxy and oc-siloxyallyl stannanes undergo a stereospecific, intermolecular 1,3-isomerization to give y-alkoxy- and y-siloxy allylic stannanes.3. .7 When tert-butyldimethylsilyl trifluoromethanesulfonate is substituted for chloromethyl methyl ether in the above procedure, the isomeric -y-siloxy allylic stannane can be obtained directly with no loss of enantioselectivity.6 These stannanes can then be added to various aldehydes to give monoprotected 1,2-diols with high diastereoselectivity.8... 

Benzoxathiolium salts have proven to be effective masked acylating agents (79S223). 2-Substituted 1,3-benzoxathiolium tetrafluoroborates have now been utilized in the preparation of esters. Reaction of the salt (334) with two equivalents of an alcohol gave the 2-alkoxy-2-alkyl-benzoxathiole (335). Hydrolysis of (335) with red mercury(II) oxide and boron trifluoride etherate in aqueous THF delivered ethyl benzoate in excellent yield (Scheme 72). 

Arenediazonium tetrafluoroborates, 19 Azidotrimethylsilane, 24 N-Chlorosuccinimide, 79 Diphenyldiazomethane, 242 a-Substituted a-amino acids a-Methylbenzylamine, 185 Methyl N-benzyloxy carbonyl-a-chloro-glycinate, 186 Pivaldehyde, 249 Miscellaneous compounds Diisobutylaluminum hydride-Boron trifluoride etherate, 116 Tin(IV) chloride, 300 Amino alcohols... 

Asymmetric induction in the aldol reaction of enolsilane and metal enolate nucleophiles with yS-substituted aldehydes gives rise to both excellent yields and good diastereoselectivities (equation 128)507. The best diastereoselectivity was obtained using a trimethylsilyl enolate in the presence of boron trifluoride-etherate (92 8 anti. syn). The key step in the synthesis of the N-terminal amino acid analogue of nikkomycin B and Bx (nucleoside peptide antibiotics) has been performed using this type of methodology508. 

Boron trifluoride etherate promotes the fWt/a-selcctivc oxacyclization of polyepoxides derived from various acyclic terpenoid polyalkenes, including geraniol, farnesol, and geranylgeraniol, providing an efficient and stereoselective synthesis of substituted oxepanes and fused polyoxepanes. The oxacyclization transformations may mimic ringforming steps in the biosynthesis of trans-syn-trans-fused polycyclic ether marine natural products <2002JOC2515>. 

Substituted pipecolic acid derivatives can be accessed from a suitably protected allylglycine derivative by first use of a palladium-catalyzed N, O-acetal formation followed by RCM.43 Treatment of 19 with boron trifluoride etherate followed by a variety of nucleophiles formed the corresponding substituted products 20 and 21 (Scheme 28.12). 

Reports) was converted (by a modified Curtius reaction) into the corresponding isocyanate, which was cyclized in 70—90% yield into the lactam (26), using boron trifluoride etherate. Since these represent new conditions for effecting such a reaction, generalization to a number of substituted phenethyl isocyanates was carried out. Compound (26), upon successive acetoxybromination, dehydro-bromination, and hydrolysis, gave the target compound (27), whose quasi-axial a-OH configuration was deduced from n.m.r. data. 

---