SUBJECTS furnaces

One design for a low temperature convection furnace shown in Figure 4 utilizes an external circulating fan, heating chamber, and duct system. The fan draws air (or a protective atmosphere) from the furnace and passes through the external heating chamber and back into the furnace past the work. This system minimizes the chance that the work receives any direct heat radiation. In theory it is less efficient because the external blower, heating chamber, and ductwork add external surfaces that are subject to heat losses. 

The analytical mechanisms for predicting the corresponding pollutant formation associated with fossil-fuel-fired furnaces lag the thermal performance prediction capabiUty by a fair margin. The most firmly estabUshed mechanism at this time is the prediction of thermal NO formation (24). The chemical kinetics of pollutant formation is, in fact, a subject of research. 

In water-wall incinerators. The internal walls of the combustion chamber are lined with boiler tubes that are arranged vertically and welded together in continuous sections. When water walls are employed in place of refrac toiy materials, they are not only useful for the recovery of steam but also extremely effective in controlling furnace temperature without introducing excess air however, they are subject to corrosion by the hydrochloric acid produced from the burning of some plastic compounds and the molten ash containing salts (chlorides and sulfates) that attach to the tubes. 

Which Alloy to Use. Unalloyed mild steel parts have been known to corrode at rates as high as 800 mils per year. The low-chrome steels, through 9-Cr, are sometimes much more resistant than mild steel. No corrosion has been reported, with both 2%-Cr and 5-Cr furnace tubes, whereas carbon steel tubes in the same service suffered severe coiTosion. The 12-Cr stainless steels are scarcely, if any, better than the low-chromes. But the 18-8 Cr-Ni steels, without molybdenum, are often quite resistant under conditions of low velocity although they are sometimes subject to severe pitting. 

Vermiculite is a naturally occurring group of hydrated aluminum-iron-magnesium silicates having a laminate structure. When subjected to direct heat in a furnace, the pulverized material exfoliates or expands in size, and then consists of a series of parallel plates with air spaces between. 

Section 3 Subject to Section 4 (which allows for exemptions to Section 3) any furnace to which Section 2 applies shall be fitted with grit and dust arrestment plant if burning... 

Steel structures and components subject to high temperature and corrosive attack on which paint would fail rapidly are given excellent protection by sprayed aluminium applied in accordance with BS 2569 Part 2 1965. Such coatings are used in blast-furnace downcomers, conveyor cooling hoods, and offtake ducting in reheating furnaces. 

Coil boilers are available as fully automatic package units, typically ranging in size from 15 to 300 boiler hp (500 lb/hr-10,000 lb/hr). Most designs employ forced circulation and a single, continuous spiral, helical-wound coiled tube that hangs inside the furnace. The coil is subjected to intense heat release from a gas or oil burner. 

In order to derive a quantitative relation between emission Intensity as measured by EMI and actual metal content, cell samples were subjected to graphite furnace atomic absorption (GFAA) analysis (14). Atomic absorption experiments were performed both on cells which had been stained with a fluorescent reagent and on cells not exposed to a lumlnophore. After EMI analysis, 50 fiL of cell suspension were withdrawn from the 0.30 mL of sample used for EMI and were digested In 150 iiL of concentrated HNO3 for 90 minutes at 85° . These solutions were then diluted to 1/10 of their concentration with deionized water, and the 150 liL of these diluted... 

---