Subcooled refrigerant, flow

An increase in the elevation that the condenser effluent must flow up into the receiver will reduce the pressure of the liquid refrigerant, in the same way as the 10-psig piping friction losses. This loss in pressure, due to increased elevation, will also require an increase in the surface area of the condenser sacrificed for subcooling. 

The bypassed vapor heats up the liquid there, thereby causing the pressure to rise. WTien the bypass is closed, the pressure falls. Sufficient heat transfer surface is provided to subcool the condensate, (f) Vapor bypass between the condenser and the accumulator, with the condenser near ground level for the ease of maintenance When the pressure in the tower falls, the bypass valve opens, and the subcooled liquid in the drum heats up and is forced by its vapor pressure back into the condenser. Because of the smaller surface now exposed to the vapor, the rate of condensation is decreased and consequently the tower pressure increases to the preset value. With normal subcooling, obtained with some excess surface, a difference of 10-15 ft in levels of drum and condenser is sufficient for good control, (g) Cascade control The same system as case (a), but with addition of a TC (or composition controller) that resets the reflux flow rate, (h) Reflux rate on a differential temperature controller. Ensures constant internal reflux rate even when the performance of the condenser fluctuates, (i) Reflux is provided by a separate partial condenser on TC. It may be mounted on top of the column as shown or inside the column or installed with its own accumulator and reflux pump in the usual way. The overhead product is handled by an alter condenser which can be operated with refrigerant if required to handle low boiling components. 

---