Stress corrosion cracking electrochemical effects

However, whilst the effects of change in alloy composition upon stress-corrosion cracking susceptibility in the present context may be partly due to their effect upon stacking-fault energy, this does not constitute a complete explanation, since alloying may have significant effects upon electrochemical parameters. The effect of the zinc content of brasses upon their filming characteristics has already been mentioned, while in more recent... 

If crack propagation occurs by dissolution at an active crack tip, with the crack sides rendered inactive by filming, the maintenance of film-free conditions may be dependent not only upon the electrochemical conditions but also upon the rate at which metal is exposed at the crack tip by plastic strain. Thus, it may not be stress, per se, but the strain rate that it produces, that is important, as indicated in equation (8.8). Clearly, at sufficiently high strain rates a ductile fracture may be propagated faster than the electrochemical reactions can occur whereby a stress-corrosion crack is propagated, but as the strain rate is decreased so will stress-corrosion crack propagation be facilitated. However, further decreases in strain rate will eventually result in a situation where the rate at which new surface is created by straining does not exceed the rate at which the surface is rendered inactive and hence stress corrosion may effectively cease. 

A typical rack employed for installation of specimens in pilot plants is shown in Fig. 6. Both corrosion coupons, 2 X 1 X 0.35 in. thick, and bend specimens intended to determine stress-corrosion cracking susceptibility, are included in the installation for aqueous corrosion testing. Specimens are separated by high density alumina spacers to eliminate electrochemical effects. During exposure, the racks are welded to existing components in the pilot plant equipment. 

The non-electrochemical techniques include direct immersion of materials samples in the test fluid in either the laboratory or plant. These s lmples sometimes have an artificial crevice generated with a serrated washer. They may be welded to determine the effects of welds and weld heat affected zones. Real-time information can be obtained using electrical resistance probes. Heat transfer effects can be evaluated by having a test sample that is exposed to the corrodent on one side and the other side heated or cooled. Stressed samples are used to evaluate stress corrosion cracking tendencies [33]. 

---