Storage Measurement

Sorbic acid and its salts are highly refined to obtain the necessary purity for use in foods. The quaUty requirements are defined by the Food Chemicals Codex (Table 3). Codistillation or recrystaUization from water, alcohoHc solutions, or acetone is used to obtain sorbic acid and potassium sorbate of a purity that passes not only the Codex requirements but is sufficient for long-term storage. Measurement of the peroxide content and heat stabiUty can further determine the presence of low amounts of impurities. The presence of isomers, other than the trans,trans form, causes instabiUty and affects the melting point. 

Yamamoto et al. [6] studied preservation of arsenic- and antimony-bearing samples of seawater. One-half of the sample (201) was acidified to pH 1 with hydrochloric acid immediately after sampling, and the remaining half was kept without acidification. In order to clarify the effect of acidification on storage, measurements were made over a period of a month after sampling. Results are given in Table 1.1. In this study, a standard addition method and calibration curve method were used for comparison and it was proven that the two gave the same results for the analyses of seawater. 

Haugen, E., Undeland, I. (2003) Lipid oxidation in herring fillets (Clupea harengus) during ice storage measured by a commercial hybrid gas sensor array system. J. Agric. Food Chem. 51 752-759. 

Figure 145 suggests a very small reduction (n the power of dynamite and ammonium nitrate explosives on storage, measured in a ballistic mortar. Figure 146 indicates the change in the transmission of detonation during storage. The decline in trans-... 

In our experimental setup, oxygen storage measurements take place in three... 

Effort in the immediate future (6-9 months) will focus on completion of the review of current accepted practices and initiation of the definition and design of the test facilities. Visits to a number of leading laboratories in hydrogen storage measurement will be included as part of the review of current practices. 

Storage Measures for keeping in appropriate premises any product necessary for the company s activities in particular raw materials, packaging materials and semi-finished or finished products. 

Figure 5. Dynamic oxygen storage measured at (a) 773 and (b) 873 K over CZ/AI2O3 samples calcined at 773 and 1373 K.

Long-term corrosion rates—for example, metals in concrete or in clays used in nuclear waste storage. Measurements could be carried out in sealed glass vessels to control the environment, and these samples measured at monthly or even yearly intervals. Current methods for measuring the evolution of corrosion for nuclear waste samples of this type include the indirect measurement of hydrogen evolution, which is not straightforward. 

Tan 5 of natural rubbers with different non-rubber content after 3- and 6-month storage measured at frequency- and strain-sweep modes. 

---