Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Steric effects rings

The amino group activates the thiazole ring toward electrophilic centers. This point is illustrated by the rate constants of the reaction between 2-dialkylaminothiazoles (32) and methyl iodide in nitromethane at 25 C (Scheme 23) (158). The steric effects of substituents on nitrogen are... [Pg.32]

The quatemization reaction of the thiazole nitrogen has been used to evaluate the steric effect of substituents in heterocyclic compounds since thiazole and its alkyl derivatives are good models for such study. In fact, substituents in the 2- and 4-positions of the ring only interact through their steric effects (inductive and resonance effects were constant in the studied series). The thiazole ring is planar, and the geometries of the ground and transition states are identical. Finally, the 2- and 4-positions have been shown to be different (259. 260). [Pg.386]

The greater stability of an equatorial methyl group compared with an axial one IS another example of a steric effect (Section 3 2) An axial substituent is said to be crowded because of 1,3 diaxial repulsions between itself and the other two axial sub stituents located on the same side of the ring... [Pg.121]

A similar steric effect was seen in Section 3 11 where van der Waals strain be tween methyl groups on the same side of the ring made as 1 2 dimethylcyclopropane less stable than its trans stereoisomer... [Pg.200]

Reactions such as catalytic hydrogenation that take place at the less hindered side of a reactant are common m organic chemistry and are examples of steric effects on reactivity Previously we saw steric effects on structure and stability m the case of CIS and trans stereoisomers and m the preference for equatorial substituents on cyclo hexane rings... [Pg.235]

Lately a third type of transition state has been favored for [2 + 2] cycloadditions forming carbocyclic and heterocyclic four-membered rings. The experimental data on the addition of diarylketenes to arylethylenes are well accommodated by the [ 2s + 2s + 2s] process proposed by Baldwin (70JA4874). The steric effects on the cycloaddition of allenes to ketenes also favor this mechanism (76JA7698). [Pg.39]

The Hammett equation in the form of Eq. (4.14) or Eq. (4.15) is free of complications due to steric effects, since it is applied only to meta and para substituents. The geometry of the benzene ring ensures that groups in these positions cannot interact stoically with the site of reaction. Tables of a values for many substituents have been collected some values are given in Table 4.5, but substituent constants are available for a much wider range of... [Pg.207]

When this stereoelectronic requirement is combined with a calculation of the steric and angle strain imposed on the transition state, as determined by MM-type calculations, preferences for the exo versus endo modes of cyclization are predicted to be as summarized in Table 12.3. The observed results show the expected qualitative trend. The observed preferences for ring formation are 5 > 6, 6 > 7, and 8 > 7, in agreement with the calculated preferences. The relationship only holds for terminal double bonds. An additional alkyl substituent at either end of the double bond reduces the relative reactivity as a result of a steric effect. [Pg.691]

On the basis of these empirical observations and your own knowledge of steric effects in six-mem-bered rings, predict the preferred form (a- or (3-pyranose) at equilibrium in aqueous solution for each of the following ... [Pg.1066]

The rate of saponification of ethyl 2-thenoate, in contrast to ethyl 3-thenoate, was found to be considerably slower than predicted from the pKa of the acid, showing that the reactivities of thiophenes do not parallel those of benzene. The first explanation, that this was produced by a steric effect of the ring sulfur similar to the case in or /lo-substituted benzenes and in ethyl 1-naphthoate, could not be upheld when the same effect was found in ethyl 2-furoate. It was later ascribed to a stereospecific acid strengthening factor, involving the proper relation of the carboxylic hydrogen and the heteroatom, as the rate of saponification of 2-thienylacrylic acid was in agreement with that predicted from the acid constants. ... [Pg.80]


See other pages where Steric effects rings is mentioned: [Pg.150]    [Pg.84]    [Pg.150]    [Pg.84]    [Pg.205]    [Pg.136]    [Pg.305]    [Pg.126]    [Pg.363]    [Pg.388]    [Pg.4]    [Pg.177]    [Pg.268]    [Pg.475]    [Pg.24]    [Pg.51]    [Pg.52]    [Pg.229]    [Pg.148]    [Pg.163]    [Pg.819]    [Pg.248]    [Pg.883]    [Pg.18]    [Pg.215]    [Pg.911]    [Pg.32]    [Pg.243]    [Pg.244]    [Pg.336]    [Pg.181]    [Pg.182]    [Pg.188]    [Pg.293]    [Pg.185]   
See also in sourсe #XX -- [ Pg.102 , Pg.103 , Pg.104 ]




SEARCH



Benzene ring steric effect

Disubstituted benzene rings steric effects

Ring effect

Ring opening steric effects

Steric effect of benzene ring

Steric effect ring-opening polymerization

© 2024 chempedia.info