Stamping flash

If the car hadn t been an automatic I would have stalled it as I stamped on the brake. I stared into the woods where the flash had appeared. But whatever had been cau in the headlights was invisible now. Mouth diy, I sbwfy edged forwards, turning the wheel back towards it. As the beam swung over the trees, something deep within them gleamed a in... 

Uses Metal/fiber wetting agent demulsifier stabilizer for chlorinated systems for drawing, stamping, rolling lubricants wastewater stripping oils leather treatment textile spin finishes rust preventive compds. Features Patented forms continuous monomolecular film with rust prevention props. environmentally friendly Properties Gardner 10 max. color vise. 100-140 SUS (100 F) acid no. 6-10 iodine no. 100-130 sapon. no. 170-180 hyd. no. 21-35 pour pt. -6 to 6 F cloud pt. 40 F max. flash pt. (COC) 450 F min. 

Blocks are usually stamped with relevant product information such lot numbers, grade and weight, and edge flashings are manually trimmed before despatch. 

Fig. 13.7 Step and Flash Nano Imprint Lithography a wafer coated in photoresist b master stamp imprinted into resist c UV curing flash step to selectively harden resist d stamp retracted from resist...

Flash-free, molded holes can be produced during stamping. When the hole is vertical or parallel with the press ram motion, fixed pierce punches are used. The punches must be located on the side from which the part is to be stripped. As a rule, the part will bind on the protruding punches, eliminating the need for additional undercuts. The part will nearly always stay on the mold half with the punches. 

---