Stage Spectroscopy

HEATING STAGE SPECTROSCOPY INFRARED, RAMAN, ENERGY DISPERSIVE X-RAY AND X-RAY PHOTOELECTRON SPECTROSCOPY... 

Several techniques have been used to characterize ICP/ PE blends, primarily to identify the presence and quality of distribution of the conducting polymer in the PE matrix. The methods have also been used to investigate possible interactions between the polymers and to identify any chemical modifications that have taken place during the fabrication stages. Spectroscopy, microscopy and thermal analysis techniques are commonly used for the characterization of ICP/ PE blends. 

Figure 8.1(c) illustrates schematically the kind of process occurring in Auger electron spectroscopy (AES). The process occurs in two stages. In the first, a high-energy photon ejects an electron from a core orbital of an atom A ... 

Electrochemical impedance spectroscopy leads to information on surface states and representative circuits of electrode/electrolyte interfaces. Here, the measurement technique involves potential modulation and the detection of phase shifts with respect to the generated current. The driving force in a microwave measurement is the microwave power, which is proportional to E2 (E = electrical microwave field). Therefore, for a microwave impedance measurement, the microwave power P has to be modulated to observe a phase shift with respect to the flux, the transmitted or reflected microwave power APIP. Phase-sensitive microwave conductivity (impedance) measurements, again provided that a reliable theory is available for combining them with an electrochemical impedance measurement, should lead to information on the kinetics of surface states and defects and the polarizability of surface states, and may lead to more reliable information on real representative circuits of electrodes. We suspect that representative electrical circuits for electrode/electrolyte interfaces may become directly determinable by combining phase-sensitive electrical and microwave conductivity measurements. However, up to now, in this early stage of development of microwave electrochemistry, only comparatively simple measurements can be evaluated. 

An electron in an atom is like a particle in a box, in the sense that it is confined within the atom by the pull of the nucleus. We can therefore expect the electron s wavefunctions to obey certain boundary conditions, like the constraints we encountered when fitting a wave between the walls of a container. As we saw for a particle in a box, these constraints result in the quantization of energy and the existence of discrete energy levels. Even at this early stage, we can expect the electron to be confined to certain energies, just as spectroscopy requires. 

The effects of the feed ratio in the lipase CA-catalyzed polymerization of adipic acid and 1,6-hexanediol were examined by using NMR and MALDI-TOF mass spectroscopies. NMR analysis showed that the hydroxyl terminated product was preferentially formed at the early stage of the polymerization in the stoichiometric substrates. As the reaction proceeded, the carboxyl-terminated product was mainly formed. Even in the use of an excess of the dicarboxylic acid monomer, the hydroxy-terminated polymer was predominantly formed at the early reaction stage, which is a specific polymerization behavior due to the unique enzyme catalysis. 

---