Spiraling effect

If two dislocation sources of the same sign (right or left handed) are very close together, less than half a step spacing, their spirals may join and form nonintersecting parallel spirals (Figure 2.14). These spirals effectively act as a... 

The high exothermicity of most oxidation reactions results in the release of a large amount of heat. If cooling, i.e., heat transfer, is not efficient, this would cause an increase in the temperature of the reaction medium. Consequently, the rate of the reaction would increase, releasing more heat and causing a further increase in the reaction rate. A spiraling effect of this type, called a thermal runaway, may eventually lead to an explosion. Indeed, runaway reactions have been found to be responsible for many major industrial accidents. 

The spiral effect of the ribbon is reflected in the wire wound cartridge in which a wire is wound in a close spiral around the core to form a filter medium working entirely as a surface strainer. The turns of wire are set in grooves machined on the core, so that there is a precise slot between adjacent turns of the wire. The wire may be of metal or made from a single filament of polymer. 

A catalyst may play an active role in a different sense. There are interesting temporal oscillations in the rate of the Pt-catalyzed oxidation of CO. Ertl and coworkers have related the effect to back-and-forth transitions between Pt surface structures [220] (note Fig. XVI-8). See also Ref. 221 and citations therein. More recently Ertl and co-workers have produced spiral as well as plane waves of surface reconstruction in this system [222] as well as reconstruction waves on the Pt tip of a field emission microscope as the reaction of H2 with O2 to form water occurred [223]. Theoretical simulations of these types of effects have been reviewed [224]. 

This equation is for Eigure 9 cyclone dimension ratios. The term the effective number of spirals the gas makes in the cyclone, was found to be approximately 5 for Lapple s system (134). The soHd line grade-efficiency curve of Eigure 7 is also used with Lapple s cyclone, which is a somewhat taller, less compact cyclone than many commercial designs. 

The dried malted barley is ground and mashed in a tub, after which the Hquid portion is drained off, cooled, and placed in the fermentor. After fermentation, a batch distillation system is usually used to separate the whisky from the fermented wort. The stiU consists of a copper ketde with a spiral tube or "worm" leading from the top. The dimensions and shape of the stills have a critical effect on the character of the whisky. The product taken off in the first part of the distillation is called foreshots (heads). The middle portion is the high wines and the last portion is the feints (tails). The middle portion is redistilled at the 140—160° proof (70—80%) range and matured in used oak cooperage. 

Work in connection with desahnation of seawater has shown that specially modified surfaces can have a profound effect on heat-transfer coefficients in evaporators. Figure 11-26 (Alexander and Hoffman, Oak Ridge National Laboratory TM-2203) compares overall coefficients for some of these surfaces when boiling fresh water in 0.051-m (2-in) tubes 2.44-m (8-ft) long at atmospheric pressure in both upflow and downflow. The area basis used was the nominal outside area. Tube 20 was a smooth 0.0016-m- (0.062-in-) wall aluminum brass tube that had accumulated about 6 years of fouhng in seawater service and exhibited a fouling resistance of about (2.6)(10 ) (m s K)/ J [0.00015 (fF -h-°F)/Btu]. Tube 23 was a clean aluminum tube with 20 spiral corrugations of 0.0032-m (lA-in) radius on a 0.254-m (10 -in)... 

Description These exchangers are typically a series of stacked helical-coiled tubes connected to manifolds, then inserted into a casing or shell. They have many advantages hke spiral-plate designs, such as avoiding differential expansion problems, acceleration effects of the helical flow increasing the heat transfer coefficient, and compactness of plot area. They are typically selected because of their economical design. 

Effective Number of Spiral Paths Taken By the Gas Within the Body of a Cyclone... 

Vibration is both a cause of problems and an effect of equipment problems. The potential destructive force of an out-of-balance load has led to setting lower shutdown limits on the magnitude of vibration than other rotating equipment. Flexible connections for process and utility lines become a must so these vibration problems are not transmitted to connected equipment. Flexible hoses with liners having concentric convolutions (bellows type) avoid the sharp points inherent with spiral metallic liners. By avoiding the sharp point the liner is less likely to cut the exterior covering. 

In reality the charging current increases in the smaller diameter dip pipe. Also, small diameter spiral-wound hose can in some cases greatly increase charging current. This effect is presumed due to increased turbulence at the inner wall [8]. Eor overhead filling of road and rail tankers the maximum vd products recommended in this book are respectively 0.38 mVs and 0.50 mVs, which are smaller than the maximum recommended values given in... 

Dry gas seals are in the positive seal class and have the same basic design features as mechanical face seals with one significant difference. The dry gas seal has shallow grooves cut in the rotating seal face located part way across the face. The grooves may be in a spiral pattern the exact location and pattern vary from one manufacturer to another. Lubrication and separation is effected by a microscopically thin film of gas. This implies some finite amount of leakage, which is quite small but must be accounted for in the design. 

Effect of base polymer polydispersity on ease of forming a uniform spiral spray pattern from the corresponding adhesives... 

Cyclone Separators Cyclone separators are described in Chapter 7. Typically used to remove particulate from a gas stream, the gas enters tangentially at the top of a cylinder and is forced downward into a spiral motion. The particles exit the bottom while the gas turns upward into the vortex and leaves through the top of the unit. Pressure drops through cyclones are usually from 13 to 17 mm water gauge. Although seldom adequate by themselves, cyclone separators are often an effective first step in pollution control. 

---