Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Space charge parameter

Some electrical properties are shown in Table 3. Values of other parameters have been pubflshed (146). Polymorphism of the PVDF chains and the orientation of the two distinct dipole groups, —CF2— and —CH2—, rather than trapped space charges (147) contribute to the exceptional dielectric properties and the extraordinarily large piezoelectric and pyroelectric activity of the polymer (146,148,149). [Pg.387]

For typical polymer LED device parameters, currenl is space charge limited if the energy barrier to injection is less than about 0.3-0.4 eV and contact limited if it is laiger than that. Injection currents have a component due to thermionic emission and a component due to tunneling. Both thermionic emission and tunneling... [Pg.501]

The lattice gas has been used as a model for a variety of physical and chemical systems. Its application to simple mixtures is routinely treated in textbooks on statistical mechanics, so it is natural to use it as a starting point for the modeling of liquid-liquid interfaces. In the simplest case the system contains two kinds of solvent particles that occupy positions on a lattice, and with an appropriate choice of the interaction parameters it separates into two phases. This simple version is mainly of didactical value [1], since molecular dynamics allows the study of much more realistic models of the interface between two pure liquids [2,3]. However, even with the fastest computers available today, molecular dynamics is limited to comparatively small ensembles, too small to contain more than a few ions, so that the space-charge regions cannot be included. In contrast, Monte Carlo simulations for the lattice gas can be performed with 10 to 10 particles, so that modeling of the space charge poses no problem. In addition, analytical methods such as the quasichemical approximation allow the treatment of infinite ensembles. [Pg.165]

Support for the applicability of this model to an explanation of the Meyer-Neldel rule comes from measurements of space-charge limited currents in anthracene where a correlation (see Fig. 20) has been found between the total density of traps H and the distribution parameter Tc (Owen et al, 1974). It has been shown that this effect is not fortuitous as suggested by some workers... [Pg.196]

Using a horizontal 4.7 Tesla cryoshimmed supercon magnet with a bore diameter of 15 cm, we have obtained two-parameter mass calibrations with absolute mass accuracies of better than 1.5 ppm without, and better than 0.4 ppm with an internal calibrant over a mass range from 18 to 502 amu (10). Absolute accuracies with an internal calibrant are slightly better because the calibrant and the unknown compound are measured under identical physical conditions, in particular with the exact same number of ions in the cell, resulting in identical space-charge shifts (2). [Pg.90]


See other pages where Space charge parameter is mentioned: [Pg.288]    [Pg.288]    [Pg.541]    [Pg.187]    [Pg.475]    [Pg.495]    [Pg.520]    [Pg.211]    [Pg.329]    [Pg.371]    [Pg.468]    [Pg.220]    [Pg.229]    [Pg.178]    [Pg.15]    [Pg.13]    [Pg.268]    [Pg.69]    [Pg.54]    [Pg.54]    [Pg.55]    [Pg.342]    [Pg.98]    [Pg.101]    [Pg.229]    [Pg.352]    [Pg.91]    [Pg.275]    [Pg.79]    [Pg.56]    [Pg.23]    [Pg.23]    [Pg.332]    [Pg.417]    [Pg.42]    [Pg.43]    [Pg.542]    [Pg.256]    [Pg.399]    [Pg.599]    [Pg.613]    [Pg.62]    [Pg.65]   
See also in sourсe #XX -- [ Pg.288 ]




SEARCH



Charging parameter

Space charging

Space parameter

Space-charge

© 2024 chempedia.info