Silica gels molecular properties

Adsorption is the property of certain extremely porous materials to hold vapors in the pores until the desiccant is either heated or exposed to a drier gas. The material is a solid at all times and operates alternately through drying and reactivation cycles with no change in composition. Adsorbing materials in principal use are activated Alumina and silica gel. Molecular sieves are also used. Atmospheric dew points of minus 1000°F are readily obtained using adsorption. 

Molecular hybrids between organic polymers and silica gel are expected to show many possibilities as new composite materials. First, the hybrids may show intermediate properties between plastics and glasses (ceramics). In addition, the composition of the hybrids can be widely varied. In other words, the hybrids can be used to modify the organic polymer materials or to modify the inorganic glassy materials. The hydrophilic modification as described before is a typical example. 

Normal-phase liquid chromatography is thus a steric-selective separation method. The molecular properties of steric isomers are not easily obtained and the molecular properties of optical isomers estimated by computational chemical calculation are the same. Therefore, the development of prediction methods for retention times in normal-phase liquid chromatography is difficult compared with reversed-phase liquid chromatography, where the hydrophobicity of the molecule is the predominant determinant of retention differences. When the molecular structure is known, the separation conditions in normal-phase LC can be estimated from Table 1.1, and from the solvent selectivity. A small-scale thin-layer liquid chromatographic separation is often a good tool to find a suitable eluent. When a silica gel column is used, the formation of a monolayer of water on the surface of the silica gel is an important technique. A water-saturated very non-polar solvent should be used as the base solvent, such as water-saturated w-hexane or isooctane. 

The factors that control separation and dispersion are quite different. The relative separation of two solutes is solely dependent on the nature and magnitude of the Interactions between each solute and the two phases. Thus, the relative movement of each solute band would appear to be Independent of column dimensions or particle geometry and be determined only by the choice of the stationary phase and the mobile phase. However, there is a caveat to this statement. It assumes that any exclusion properties of the stationary phase are not included in the term particle geometry. The pore size of the packing material can control retention directly and exclusively, as in exclusion chromatography or, indirectly, by controlling the access of the solute to the stationary phase in normal and reverse phase chromatography. As all stationary phases based on silica gel exhibit some exclusion properties, the ideal situation where the selective retention of two solutes is solely controlled by phase interactions is rarely met in practice. If the molecular size of the solutes differ, then the exclusion properties of the silica gel will always play some part in solute retention. 

It is seen that an approximately linear relationship exists between the retention volume of each alkane and Its carbon number and that the smaller molecule exhibits the greatest retention. This is a direct result of the exclusion properties of the silica gel support. The fact that the data, taken at the two different temperatures, fall on the same straight line confirms that little or no partition is taking place and that the difference In retention between the Individual solutes is entirely related to their molecular size. 

To achieve a significant adsorptive capacity an adsorbent must have a high specific area, which implies a highly porous structure with very small micropores. Such microporous solids can be produced in several different ways. Adsorbents such as silica gel and activated alumina are made by precipitation of colloidal particles, followed by dehydration. Carbon adsorbents are prepared by controlled burn-out of carbonaceous materials such as coal, lignite, and coconut shells. The crystalline adsorbents (zeolite and zeolite analogues are different in that the dimensions of the micropores are determined by the crystal structure and there is therefore virtually no distribution of micropore size. Although structurally very different from the crystalline adsorbents, carbon molecular sieves also have a very narrow distribution of pore size. The adsorptive properties depend on the pore size and the pore size distribution as well as on the nature of the solid surface. 

Polyolefins possessing properties distinctly different from those produced in homogeneous solution, characterised by an unusually high molecular weight, have recently been obtained by using catalysts with c/ .sc/-metallocene precursors supported directly on an unpretreated silica gel carrier [204,206], This may be due to the active site isolation effect, i.e. to the strict suppression of participation of other sites in the polymerisation [30],... 

---