Silanes configuration

If R1 differs from R2. the preparation may lead to both regioisomers. In these cases, a synthetic route which does not rely on allyl anion substitution is often the most advantageous one. Thus, the best results are recorded for allylboronates and -silanes which also possess the required constitutional and configurational stability. 

More recently, the Lewis acid promoted asymmetric 1,4-addition of trimethyl(2-propenyl)silane to chiral a,/ -unsaturated /V-acylamides has been published33. Lewis acid mediated reactions of trimethyl(2-propenyl)silanes with a,/I-unsatu rated AT-acyloxazolidinones or iV-enoylsultams show high chemical yield with good diastereomeric excess. The absolute configuration of the new asymmetric center is controlled by the nature of the Lewis acid used. 

This excellent method of oxidative cleavage (/) of carbon-silicon bonds requires that the silane carry an electronegative substituent (2), such as alkoxy or fluoro. Either hydrogen peroxide or mcpba may be used as oxidant, and the alcohol is produced with retention of configuration (3). Fluoride ion is normally a mandatory additive in what is believed to be a fluoride ion-assisted rearrangement of a silyl peroxide, as shown below ... 

A comparable exchange occurred between (—)-phenylneopentylmethyl-silylcobalt tetracarbonyl and triphenylsilane. All these exchanges proceeded with retention of configuration of the asymmetric center of the silane. 

As an example of the selective reactivity of borazirconocene alkenes, their hydrolysis was examined [1]. The carbon—zirconium bond is more reactive than the carbon—boron bond towards various electrophiles, and so hydrolysis can be expected to occur with preferential cleavage of the former bond. Since hydrolysis of alkenylzirconocenes is known to proceed with retention of configuration [4,127—129], a direct utility of 45 is the preparation of (Z)-1-alkenylboronates 57 (Scheme 7.17) [12]. Though the gem-dimetalloalkenes can be isolated, in the present case it is not necessary. The desired (Z)-l-alkenylboronates can be obtained in a one-pot procedure by hydrozirconation followed by hydrolysis with excess H20. The reaction sequence is operationally simple and is compatible with various functional groups such as halides, acetals, silanes, and silyloxy protecting groups [12]. 

Cleavage of Si—C bonds (12,243-245). This oxidation can be used to convert vinylsilanes in three steps to syn- or anti-1,2-diols. Thus Grignard reagents cleave epoxides of vinylsilanes selectively to (3-hydroxy silanes, which can be oxidized with retention of configuration to 1,2-diols. When applied to an (E)-vinylsilane, the sequence results in the syn-l,2-diol the an -l,2-diol is obtained from a (Z)-vinylsilane by the same reactions. 

A more recent synthesis of 197 [365] is shown in Fig. 9. Enders introduced the stereogenic centre of (S)-lactic acid into the crucial position 10 in 197. The vinylsulfone B, readily available from lactic acid, was transformed into the planar chiral phenylsulfonyl-substituted (q3-allyl)tetracarbonyliron(+l) tetra-fluoroborate C showing (IR,2S,3 )-configuration. Addition of allyltrimethyl silane yielded the vinyl sulfone D which was hydrogenated to E. Alkylation with the dioxolane-derivative of l-bromoheptan-6-one (readily available from 6-bro-mohexanoic acid) afforded F. Finally, reductive removal of the sulfonyl group and deprotection of the carbonyl group furnished 197. A similar approach was used for the synthesis of 198 [366]. 

The absolute configuration of the silicon complex has been established by an X-ray study and shown to be (S) starting from the (R) silane, involving retention of configuration. ... 

Tris(trimethylsilyl)silane reacts with phosphine sulfides and phosphine selen-ides under free radical conditions to give the corresponding phosphines or, after treatment with BH3-THF, the corresponding phosphine-borane complex in good to excellent yields (Reaction 4.45) [82]. Stereochemical studies on P-chiral phosphine sulphides showed that these reductions proceed with retention of configuration. An example is given in Reaction (4.46). 

A couple of 2-alkenyl carbamates have been deprotonated by n-BuLi/(—)-sparteine (11) (toluene, —78°C) in the presence of an excess of trimethylsUyl chloride. The ee values in the silane, formed in situ with inversion of the configuration, demonstrate the... 

Reaction of allylic silanes with enantiomerically pure 1,3-dioxanes has been found to proceed with high enantioselectivity.70 The enantioselectivity is dependent on several reaction variables, including the Lewis acid and the solvent. The observed stereoselectivity appears to reflect differences in the precise structure of the electrophilic species that is generated. Mild Lewis acids tend to react with inversion of configuration at the reaction site, whereas very strong Lewis acids cause loss of enantioselectivity. These trends, and related effects of solvent and other experimental variables, determine the nature of the electrophile. With mild Lewis acids, a tight ion pair favors inversion, whereas stronger... 

Optimization of the previously reported Mannich-type reaction of trimethyl (pent-2-en-3-yloxy)silane with the sulfone Is derived from phenyl acetaldehyde (Table 5, entry 11) led to the corresponding (3-amino ketone in a good yield with moderate diastereoselectivity (2 mol% Bi(0Tf)3-4H20, yield = 84%, 24v/24v syn/anti = 72 28) (Scheme 8). Reduction of the major diastereoisomer 24v with lithium tri-ferf-butoxyaluminohydride afforded 25 as the only one diastereoisomer. Further cyclization of the latter with NaH afforded 4-benzyl-6-ethyl-5-methyl-l,3-oxazinan-2-one 26. The relative configuration of the six-membered carbamate was established as cis-cis by NMR analysis. 

We need to deposit a silica film on 200 jum wires by reacting tetraethyl siloxane. In the reactor configuration proposed the silane in N2 at a partial pressure of 10 tOIT flows over the wires at... 

---