Sieve tray extractors diameters

Siemens-Martin furnace-regenerator, 590 Sieve tray extractors, 483 capacity, 484,487 diameters, 483, 487 efliciency. 483.487 pulsed, 478,483,487 sizing example, 486 Sieve trays, 428 assembly in a tower, 428 comparison with other types, example, 431... 

FIG. 23-38 Efficiency and capacity range of small-diameter extractors, 50 to 150 mm diameter. Acetone extracted from water with toluene as the disperse phase, V /V = 1.5. Code AC = agitated cell PPC = pulsed packed column PST = pulsed sieve tray RDC = rotating disk contactor PC = packed column MS = mixer-settler ST = sieve tray. (Stichlmair, Chem. Ing. Tech. 52(3), 253-255 [1980]). 

The method of calculation introduced in this chapter not only allows an exact determination of the column diameter for nonpulsed sieve tray columns, but also allows a good estimation of the diameters of pulsed and stirred extractors. For the latter, however, more exact specific equations exist for the flooding point, see for example [1,4]. 

An extractor column is generally a tall, vertical packed tower that has two or more bed sections. Each packed bed section is typically limited to no more than 8 ft tall, making the overall tower height about 40 to 80 ft. Tower diameter depends fully upon liquid rates, but is usually in the range of 2 to 6 ft. Liquid-liquid extractors may also have tray-type column internals, usually composed of sieve-type trays without downcomers. These tray-type columns are similar to duoflow-type vapor-liquid separation, but here serve as contact surface area for two separate liquid phases. The packed-type internals are more common by far and are the type of extractor medium considered the standard. Any deviation from packed-type columns is compared to packing. 

---