Shrinkage direction

Biaxial Orientation. Many polymer films require orientation to achieve commercially acceptable performance (10). Orientation may be uniaxial (generally in the machine direction [MD]) or biaxial where the web is stretched or oriented in the two perpendicular planar axes. The biaxial orientation may be balanced or unbalanced depending on use, but most preferably is balanced. Further, this balance of properties may relate particularly to tensile properties, tear properties, optical birefringence, thermal shrinkage, or a combination of properties. A balanced film should be anisotropic, although this is difficult to achieve across the web of a flat oriented film. 

CompoundShrinka.g e. In its simplest form (Fig. 8a) compound shrinkage consists of machining the inner radius of an outer component I, (Qp so that it is smaller than the outer radius of an inner component II, The difference between the two is known as the radial interference 5. To assemble the cylinders, outer component I is heated and/or inner component II cooled so that the outer component can be sHpped over the inner as shown in Figure 8b. When the temperature of the assembly returns to ambient, a compressive stress (pressure) is generated across the interface which simultaneously compresses the inner and expands the outer component and, in so doing, displaces radius (r/j by Uj and radius ( jj by U, Unfortunately, it is difficult to carry out this operation without setting up stresses in the axial direction (32). 

Urea—Formaldehyde and Urea-Based. In the 1970s and early 1980s, urea materials were in general use particularly for direct field retrofitting of cavity wall constmction of wood frame and masonry. However, because of formaldehyde odor and excess shrinkage under specific conditions, this ceUular plastic has limited use as an insulation. 

Textile finishing encompasses a broad range of approaches and may be directed toward needed properties such as shrinkage control or smooth-dry performance or toward developing properties for specific end uses such as flame retardance, soil release, smolder resistance, weather resistance, or control of static charges. 

Zinc rolling slabs have been cast successfully by semicontinuous direct-chill casting methods. This is the preferred method for superplastic zinc alloys which, because of their large freezing range, display unacceptable surface shrinkage when cast in open molds. 

Shrinkage of about 5-10% occurs at right angles to the direction of the preforming force. The amount of shrinkage is mainly dependent on the rate of cooling, but also to a minor extent, on the preforming pressure. 

The manufacturers stress ease of processing as a particular feature of the material. Recommended melt temperatures are in the range 320-340°C and mould temperatures are 135-165°C. Mould shrinkage of glass-filled grades is usually of the order of 0.2-0.4% in the flow direction and up to twice this value in the transverse direction. The materials are notable for their ability to withstand vapour phase and infrared soldering processes. 

Cotton Lightweight, reasonably hard-wearing, no static generation Resists penetration of direct splashes of corrosive Unaffected by oils Liable to shrinkage unless treated More flammable than wool Vulnerable to hot splashes Suitable for under-gloves... 

---