Shift change lockout

During shift changes, the continuity of lockout protection must be ensured. 

Any time a machine needs to be locked out across a shift change, the oncoming authorized supervisor shall ensure that his or her lockout device is removed. In the event this sequence is not followed and the lockout device is removed before the oncoming employee arrives, the oncoming employee must follow the entire lockout procedure before beginning work. 

Fixed Electrical Equipment and Circuits Working ON OR Near Exposed De-energized Parts 

When any employee is exposed to contact with parts of fixed electrical equipment or circuits that have been de-energized, the circuits energizing the parts shall be locked out or tagged out or both in accordance with the requirements of this paragraph. The requirements shall be followed in the order in which they are presented. 

NOTE Fixed equipment in this section refers to equipment that is fastened in place or connected by permanent wiring methods. 

---

Are specific procedures established for lockout/tagout utilization during shift change [29 CFR 1910.147 (E)(4)]... 

How must lockout be continued between shift changes ... 

Adopt procedures to ensure safety when equipment must be tested during servicing, when outside contractors are working at the site, when multiple lockouts are needed for the crew servicing equipment, and when shifts or personnel change occur. 

Other concerns that must be addressed for your organization s lockout/tagout program include working with outside contractors and shift and personnel changes. 

---