Schematic Diagram of the Instrumentation

Figure 3.12. Schematic diagram of the instrumental setup of the mobile aerosol mass spectrometer LAMPAS 2 . (Trimborn et al. 2000.)...

This is the best method for determining fluorescence lifetimes. Developed only five or so years ago, this method has achieved wide acceptance/6 A schematic diagram of the instrumentation used in this method is shown in Figure 2.16. 

Figure 5. Schematic diagram of the instruments used for simultaneous separation of anions and cations [10].

FIGURE 14-10 Schematic diagram of the instrument panel for a single screw extruder. 

Figure 2 Schematic diagram of the instrument set-up used to detect a polarized signal.

Fig.l also shows the schematic diagram of the instrument to measure the curvature of a substrate during thermal spray[5]. A strip-shaped substrate is fixed onto a pair of knife edges by a pair of springs and the displacement at the center of the rear surface is measured by a displacement sensor. A thermocouple is spot welded to record the thermal history. 

Figure 9.8 Schematic diagram of the instrumentation for flow injection analysis.

Schematic diagrams of the instrumentation for the ANL capacitive flowmeter are given in Fig. 6.20. A 100-kHz sine-wave oscillator, with stable frequency and amplitude controls, was used to pulse the drive electrode. Each sensing electrode was connected to a current-to-voltage converter preamplifier. The preamplifier outputs were bandpass filtered at 100 kHz 5 Hz and amplitude-demodulated. The demodulated signals were amplified and DC-coupled to a first-order low-pass filter to give density signals.

A schematic diagram of the instrumentation for the capacitive flowmeter is presented in Fig. 6.31. The drive electrode was driven by 100-kHz sine waves... 

Draw a schematic diagram of the instrumentation used for measuring UV fluorescence intensity. 

Fig. 2.4 Schematic diagram of the instrumentation for the ER measurements. Notations LIA, lock-in amplifier ...

Figure 11.23 presents a schematic diagram of the instrumentation required for HPLC. Six major components needed to perform HPLC are... 

Fig. 3 Schematic diagram of the instrumentation used for impedance measurements. ------------------------ IFMBE Proceedings Vol. 54 ---------------------...

---