Responsibility performance-influencing factors

Chang, Y. J. and A. Mosleh (2007b). Cognitive modeling and dynamic probabilistic simulation of operating crew response to complex system accidents. Part 2 - IDAC performance influencing factors model. 

The greater basicity of alcohols over olefins is responsible for the fact that dehydration can be performed by weaker acidic sites than are necessary for olefin isomerization. There are, however, also other factors, such as participation of neighboring groups, which may influence the rate of dehydration of alcohols. 

In reference 20, a typical robustness test is not performed, but a study on the influence of peak measurement parameters is reported on the outcome. The study is special in the sense that no physicochemical parameter in the experimental runs is changed, but only data measurement and treatment-related parameters. These parameters can largely affect the reported results, as shown earlier, and in that sense they do influence the robusmess of the method. The different parameters (see above) were first screened in a two-level D-optimal design (9 factors in 10 experiments). The most important were then examined in a face-centered CCD, and conclusions were drawn from the response surfaces plots. 

The experiments are performed according to the chosen design and a response or a number of responses are measured. The sequence in which the experiments are performed can influence the estimation of the effect of a factor [36]. The reason for this lies in the fact that the measurements can be influenced by different sources of error. Each measurement is influenced by uncontrolled factors that cause random error. Measurements can also be influenced by systematic errors or by systematic errors caused by drift (linear drift due to time-dependent factors). The occurrence of systematic errors or of drift will affect the estimation of the effects of the factors fi om the design [36]. 

A reflected half-fraction factorial design for three factors (2 ) was performed. The influence of the factors on the responses recovery (%), resolution between peaks R) and Ry-value was calculated. Approximate critical values were obtained using the method given by Youden and Steiner (Ecritical MSE)e)- The standard error was estimated from... 

---