Representativeness defined

During evaluation four reference points are always offered representing defined decipol levels (2, 5, 10, 20 decipol), so called milestones. Each decipol level is created by a defined acetone concentration evaporated into air and provided to... 

Problem 7 What is a two component system and how it is graphically represented Define reduced phase rule equation and condensed state. 

Table 2 IC50 ( xM) of preferred experimental agents in a line panel representing defined forms of cytotoxic drug resistance...

The exact value of the atomic mass unit is defined in relation to a standard, just as the units of the metric system represent defined quantities. The carbon-12 isotope has been chosen and is assigned a mass of exactly 12 atomic mass units. Hence this standard reference point defines an atomic mass unit as exactly one-twelfth the mass of a carbon-12 atom. 

A) by an employee or group of employees or any individual or labor organization acting in their behalf alleging that a substantial number of employees (i) wish to be represented for collective bargaining and that their employer declines to recognize their representative as the representative defined in... 

They represent defined molecular models for both experimental and theoretical studies of aromaticity and, in general, electronic effects and n conjugation [20]. 

The flash curve of a petroleum cut is defined as the curve that represents the temperature as a function of the volume fraction of vaporised liquid, the residual liquid being in equilibrium with the total vapor, at constant pressure. 

If one imagine.s that the fuel is used in the liquid state in the form of droplets —as in the case of fuel injection— the specific energy of the motor fuel (SE) is expressed in kilojoules per kilogram of air utilized, under predetermined conditions of equivalence ratio (stoichiometry for example). The SE is none other than the NHY /r quotient where r represents the previously defined stoichiometric ratio. 

Product characterization aims at defining their end-use properties by means of conventional standard measurements related as well as possible — and in any case, being the object of a large consensus— to end-use properties. We cite for example that octane numbers are supposed to represent the resistance of gasoline to knocking in ignition engines. 

The type of development, type and number of development wells, recovery factor and production profile are all inter-linked. Their dependency may be estimated using the above approach, but lends itself to the techniques of reservoir simulation introduced in Section 8.4. There is never an obvious single development plan for a field, and the optimum plan also involves the cost of the surface facilities required. The decision as to which development plan is the best is usually based on the economic criterion of profitability. Figure 9.1 represents a series of calculations, aimed at determining the optimum development plan (the one with the highest net present value, as defined in Section 13). 

Finally, the concentrated localized AE events are represented on the monitor in the form of a histogram "number of localized AE events vs axial coordinate", which is automatically updated at user-defined time intervals. 

The corresponding fiinctions i-, Xj etc. then define what are known as the normal coordinates of vibration, and the Hamiltonian can be written in tenns of these in precisely the fonn given by equation (AT 1.69). witli the caveat that each tenn refers not to the coordinates of a single particle, but rather to independent coordinates that involve the collective motion of many particles. An additional distinction is that treatment of the vibrational problem does not involve the complications of antisymmetry associated with identical fennions and the Pauli exclusion prmciple. Products of the nonnal coordinate fiinctions neveitlieless describe all vibrational states of the molecule (both ground and excited) in very much the same way that the product states of single-electron fiinctions describe the electronic states, although it must be emphasized that one model is based on independent motion and the other on collective motion, which are qualitatively very different. Neither model faithfully represents reality, but each serves as an extremely usefiil conceptual model and a basis for more accurate calculations. 

Equation (ASA. 110) represents the canonical fonn T= constant) of the variational theory. Minimization at constant energy yields the analogous microcanonical version. It is clear that, in general, this is only an approximation to the general theory, although this point has sometimes been overlooked. One may also define a free energy... 

---