Reduction ethanol, mechanism

Serval reactions occurred evidenced by a complex desorption products. First, acetaldehyde (m/e 29, 15, 44) desorbed at 390 K followed by traces of ethanol at 415 K (2 % of carbon selectivity, table 2). Three other products were observed. Butadiene and butene desorbed at 540 and 673 K respectively with a combined carbon selectivity of 21.1 %. This reaction pathway follows a reductive coupling mechanism which has been observed previously on the surfaces of Ti02 single crystal and powder [19-21]. The formation of C4 olefins is a clear example of the capacity of UO2 surfaces to abstract large amounts of oxygen from surface carbonyls, via pinacolates [19], as follow... 

Step 6 is the final step in the cellulose-to-lactic acid cascade, involving the isomerization of the 2-keto-hemi-acetal (here pyruvic aldehyde hydrate) into a 2-hydroxy-carboxyhc acid. This reaction is known to proceed in basic media following a Cannizzaro reaction with 1,2-hydride shift [111], Under mild conditions, Lewis acids are able to catalyze this vital step, which can also be seen as an Meerwein-Ponndorf-Verley reduction reaction mechanism. The 1,2-hydride shift has been demonstrated with deuterium labeled solvents [110, 112], Attack of the solvent molecule (water or alcohol) on pymvic aldehyde (step 5) and the hydride shift (step 6) might occur in a concerted mechanism, but the presence of the hemiacetal in ethanol has been demonstrated for pyruvic aldehyde with chromatography by Li et al. [113] andfor4-methoxyethylglyoxal with in situ CNMRby Dusselier et al. (see Sect. 7) [114]. 

The catalytic alcohol racemization with diruthenium catalyst 1 is based on the reversible transfer hydrogenation mechanism. Meanwhile, the problem of ketone formation in the DKR of secondary alcohols with 1 was identified due to the liberation of molecular hydrogen. Then, we envisioned a novel asymmetric reductive acetylation of ketones to circumvent the problem of ketone formation (Scheme 6). A key factor of this process was the selection of hydrogen donors compatible with the DKR conditions. 2,6-Dimethyl-4-heptanol, which cannot be acylated by lipases, was chosen as a proper hydrogen donor. Asymmetric reductive acetylation of ketones was also possible under 1 atm hydrogen in ethyl acetate, which acted as acyl donor and solvent. Ethanol formation from ethyl acetate did not cause critical problem, and various ketones were successfully transformed into the corresponding chiral acetates (Table 17). However, reaction time (96 h) was unsatisfactory. 

Figure 4.9. Mechanism for NO reduction with ethanol on Ag/y-Al203 proposed in ref. [120].

Coleman, Kobylecki, and Utley studied the electrochemical reduction of the conformationally fixed ketones 4-tert-butylcyclohexanone and 3,3,5-tri-methylcyclohexanone 82>. Stereochemically, the cleanest reductions took place at a platinum cathode in a mixture of hexamethylphosphoramide and ethanol containing lithium chloride. Under these conditions the equatorial alcohol predominated heavily (95% from 4-fer/-butylcyclohexane and 91% from 3,3,5-trimethylcyclohexanone).In acidic media roughly equal quantities of axial and equatorial alcohol were produced. It was suggested that organo-lead intermediates are involved in the reductions in aqueous media. This is reasonable, based upon the probable mechanism of reduction in acid 83F Reductions in acid at mercury cathodes in fact do result in the formation of... 

An unusual observation was noted when ethanolic solutions of 2-alkyl-4(5)-aminoimidazoles (25 R = alkyl) were allowed to react with diethyl ethoxymethylenemalonate (62 R = H) [92JCS(P1)2789]. In addition to anticipated products (70), which were obtained in low yield ( 10%), the diimidazole derivatives (33 R = alkyl) were formed in ca.30% yield. The mechanism of formation of the diimidazole products (33) has been interpreted in terms of a reaction between the aminoimidazole (25) and its nitroimidazole precursor (27) during the reduction process. In particular, a soft-soft interaction between the highest occupied molecular orbital (HOMO) of the aminoimidazole (25) and the lowest unoccupied molecular orbital (LUMO) of the nitroimidazole (27) is favorable and probably leads to an intermediate, which on tautomerism, elimination of water, and further reduction, gives the observed products (33). The reactions of amino-imidazoles with hard and soft electrophiles is further discussed in Section VI,C. 

In the Clemmensen reduction of 1,4-cyclohexanedione, all the products isolated from the reduction of 2,5-hexanedione were found in addition to 2,5-hexanedione (20%) and 2-methylcyclopentanone (6%). The presence of the two latter compounds reveals the mechanism of the reduction. In the first stage the carbon-carbon bond between carbons 2 and 3 ruptured, and the product of the cleavage, 2,5-hexanedione, partly underwent aldol condensation, partly its own further reduction [927], The cleavage of the carbon-carbon bond in 1,4-diketones was noticed during the treatment of 1,2-diben-zoylcyclobutane which afforded, on short refluxing with zinc dust and zinc chloride in ethanol, an 80% yield of 1,6-diphenyl-1,6-hexanedione [75<5]. 

The sedative-hypnotic action of chloral hydrate should be explained by the formation of trichloroethanol, which is synthesized as a result of its reduction in tissues. Despite the fact that the precise mechanism of action of chloral hydrate is not known, it evidently acts analogous to ethanol on the CNS by inCTeasing membrane permeability, which leads to sedation or sleep. Chloral hydrate can be used for insomnia as an alternative to benzodiazepines. Synonyms for this drug are aquachloral, chloradorm, chloratol, noctec, and others. 

Concurrent with acetic anhydride formation is the reduction of the metal-acyl species selectively to acetaldehyde. Unlike many other soluble metal catalysts (e.g. Co, Ru), no further reduction of the aldehyde to ethanol occurs. The mechanism of acetaldehyde formation in this process is likely identical to the conversion of alkyl halides to aldehydes with one additional carbon catalyzed by palladium (equation 14) (18). This reaction occurs with CO/H2 utilizing Pd(PPh )2Cl2 as a catalyst precursor. The suggested catalytic species is (PPh3)2 Pd(CO) (18). This reaction is likely occurring in the reductive carbonylation of methyl acetate, with methyl iodide (i.e. RX) being continuously generated. 

A. Reduction and hydrolysis. A solution of 129 g. (0.75 mole) of 0-naphthyl ethyl ether in 1.5 1. of 95% ethanol is prepared in a 5-1. three-necked flask fitted with a mechanical stirrer, a bulb condenser topped by a Friedrichs condenser, and a Y-tube to allow for the introduction of nitrogen and sodium. The apparatus is llushed thoroughly with nitrogen, the nitrogen flow is reduced, and 225 g. (9.8 gram atoms) of sodium is added in small portions (Note 1), wilh efficient stirring, at a rate suffi-... 

Preliminary accounts of the preparation and chemistry of betaines 381 (R = H, Me) have appeared. Compound 381 (R = H) is obtained in high yield by oxidation of dihydronorcoralyne (382 R = H) with w-chloroper-benzoic acid. In a similar manner, ethanolic solutions of dihydrocoralyne (382 R = Me) are oxidized to betaine 381 (R = Me) by air. The study of these compounds has so far been restricted to their oxidation products. Photooxidation of betaine 381 (R = H) followed by borohydride reduction gives a high yield of the phthalideisoquinoline 383. Photooxidation of the 8-methylbetaine 381 (R = Me) gives papaveraldine derivatives (384 R = COMe, CO2Me). The mechanisms of these transformations are open to conjecture. 

---