Big Chemical Encyclopedia

Chemical substances, components, reactions, process design ...

Articles Figures Tables About

Solution redox potentials

Nitric acid Cr II 5 N H2SO4 -1- 0-5 N Boiling with solution 1. Mass loss per unit (a) Redox potential Solute segregation to... [Pg.1032]

Rossetti R, Nakahara S and Brus L E 1983 Quantum size effects In the redox potentials, resonance Raman spectra and electronic spectra of CdS crystallites In aqueous solution J. Chem. Phys. 79 1086... [Pg.2921]

The data in Tables 4.2 and 4.3 refer to ions in aqueous acid solution for cations, this means effectively [MlHjO), ]" species. However, we have already seen that the hydrated cations of elements such as aluminium or iron undergo hydrolysis when the pH is increased (p. 46). We may then assume (correctly), that the redox potential of the system... [Pg.101]

When either hydrogen ions or hydroxide ions participate in a redox half-reaction, then clearly the redox potential is alTected by change of pH. Manganate(Vir) ions are usually used in well-acidified solution, where (as we shall see in detail later) they oxidise chlorine ions. If the pH is increased to make the solution only mildly acidic (pH = 3-6), the redox potential changes from 1.52 V to about 1.1 V, and chloride is not oxidised. This fact is of practical use in a mixture of iodide and chloride ions in mildly acid solution. manganate(VII) oxidises only iodide addition of acid causes oxidation of chloride to proceed. [Pg.102]

The following redox potentials are given for the oxidation of manganese(II) to manganese(III) in acid and alkaline solution. [Pg.110]

Ozone is very much more reactive than oxygen and is a powerful oxidising agent especially in acid solution (the redox potential varies with conditions but can be as high as + 2.0 V). Some examples are 1. the conversion of black lead(ll) sulphide to white lead(II) sulphate (an example of oxidation by addition of oxygen) ... [Pg.264]

Two important redox potentials for reduction by sulphur dioxide in aqueous solution are ... [Pg.291]

Many of the reactions of halogens can be considered as either oxidation or displacement reactions the redox potentials (Table 11.2) give a clear indication of their relative oxidising power in aqueous solution. Fluorine, chlorine and bromine have the ability to displace hydrogen from hydrocarbons, but in addition each halogen is able to displace other elements which are less electronegative than itself. Thus fluorine can displace all the other halogens from both ionic and covalent compounds, for example... [Pg.325]

The acids are only known in aqueous solution all are oxidising agents the standard redox potentials for the reaction... [Pg.338]

In an aquo-complex, loss of protons from the coordinated water molecules can occur, as with hydrated non-transition metal ions (p. 45). To prevent proton loss by aquo complexes, therefore, acid must usually be added. It is for these conditions that redox potentials in Chapter 4 are usually quoted. Thus, in acid solutions, we have... [Pg.367]

In Table 8.26, E° represents the redox potential at which the color change of the indicator would normally be perceived in a solution containing approximately 1A7H+. Lor a one-color indicator this is the potential at which the concentration of the colored form is just large enough to impart a visible color to the solution and depends on the total concentration of indicator added to the solution. If it is the reduced form of the indicator that is colorless, the potential at which the first visible color... [Pg.1160]

Electron donor molecules are oxidized in solution easily. Eor example, for TTE is 0.33V vs SCE in acetonitrile. Similarly, electron acceptors such as TCNQ are reduced easily. TCNQ exhibits a reduction wave at — 0.06V vs SCE in acetonitrile. The redox potentials can be adjusted by derivatizing the donor and acceptor molecules, and this tuning of HOMO and LUMO levels can be used to tailor charge-transfer and conductivity properties of the material. Knowledge of HOMO and LUMO levels can also be used to choose materials for efficient charge injection from metallic electrodes. [Pg.240]

Aqueous solutions of sodium sulfite are alkaline and have a pH of ca 9.8 at 1 wt %. The solutions are oxidized readily by air. The redox potential is a function of pH, as would be expected from the foUowing equation ... [Pg.148]

For solvent extraction of a tetravalent vanadium oxyvanadium cation, the leach solution is acidified to ca pH 1.6—2.0 by addition of sulfuric acid, and the redox potential is adjusted to —250 mV by heating and reaction with iron powder. Vanadium is extracted from the blue solution in ca six countercurrent mixer—settler stages by a kerosene solution of 5—6 wt % di-2-ethyIhexyl phosphoric acid (EHPA) and 3 wt % tributyl phosphate (TBP). The organic solvent is stripped by a 15 wt % sulfuric acid solution. The rich strip Hquor containing ca 50—65 g V20 /L is oxidized batchwise initially at pH 0.3 by addition of sodium chlorate then it is heated to 70°C and agitated during the addition of NH to raise the pH to 0.6. Vanadium pentoxide of 98—99% grade precipitates, is removed by filtration, and then is fused and flaked. [Pg.392]

For vanadium solvent extraction, Hon powder can be added to reduce pentavalent vanadium to quadrivalent and trivalent Hon to divalent at a redox potential of —150 mV. The pH is adjusted to 2 by addition of NH, and an oxyvanadium cation is extracted in four countercurrent stages of mixer—settlers by a diesel oil solution of EHPA. Vanadium is stripped from the organic solvent with a 15 wt % sulfuric acid solution in four countercurrent stages. Addition of NH, steam, and sodium chlorate to the strip Hquor results in the precipitation of vanadium oxides, which are filtered, dried, fused, and flaked (22). Vanadium can also be extracted from oxidized uranium raffinate by solvent extraction with a tertiary amine, and ammonium metavanadate is produced from the soda-ash strip Hquor. Fused and flaked pentoxide is made from the ammonium metavanadate (23). [Pg.392]

MV Botuyan, A Toy-Palmer, J Chung, RC Blake II, P Beroza, DA Case. NMR solution structure of Cu(I) rusticyanm from Thiobacillus feiTooxidans Structural basis of the extreme acid stability and redox potential. J Mol Biol 263 752-767, 1996. [Pg.414]

As a result, the electromotive force (EMF) of the cell is zero In the presence of fluoride ions, cerium(IV) forms a complex with fluoride ions that lowers the cerium(IV)-cerium(IIl) redox potential The inner half-cell is smaller, and so only 5 mL of cerium(IV)-cenum (III) solution is added To the external half-cell, 50 mL of the solution is added, but the EMF of the cell is still zero When 10 mL of the unknown fluonde solution is added to the inner half-cell, 100 mL of distilled water IS added to the external half-cell The solution in the external half-cell is mixed thoroughly by turning on the stirrer, and 0 5 M sodium fluonde solution is added from the microburet until the null point is reached The quantity of known fluonde m the titrant will be 10 times the quantity of the unknown fluoride sample, and so the microburet readings must be corrected prior to actual calculations... [Pg.1026]

It follows from the electrochemical mechanism of corrosion that the rates of the anodic and cathodic reactions are interdependent, and that either or both may control the rate of the corrosion reaction. It is also evident from thermodynamic considerations (Tables 1.9 and 1.10) that for a species in solution to act as an electron acceptor its redox potential must be more positive than that of the M /M equilibrium or of any other equilibrium involving an oxidised form of the metal. [Pg.96]

The effects of concentration, velocity and temperature are complex and it will become evident that these factors can frequently outweigh the thermodynamic and kinetic considerations detailed in Section 1.4. Thus it has been demonstrated in Chapter 1 that an increase in hydrogen ion concentration will raise the redox potential of the aqueous solution with a consequent increase in rate. On the other hand, an increase in the rate of the cathodic process may cause a decrease in rate when the metal shows an active/passive transition. However, in complex environmental situations these considerations do not always apply, particularly when the metals are subjected to certain conditions of high velocity and temperature. [Pg.307]


See other pages where Solution redox potentials is mentioned: [Pg.429]    [Pg.429]    [Pg.177]    [Pg.223]    [Pg.417]    [Pg.1939]    [Pg.98]    [Pg.100]    [Pg.102]    [Pg.108]    [Pg.368]    [Pg.395]    [Pg.378]    [Pg.433]    [Pg.163]    [Pg.169]    [Pg.390]    [Pg.392]    [Pg.113]    [Pg.361]    [Pg.488]    [Pg.358]    [Pg.358]    [Pg.54]    [Pg.162]    [Pg.405]    [Pg.905]    [Pg.63]    [Pg.63]    [Pg.69]    [Pg.177]    [Pg.178]   
See also in sourсe #XX -- [ Pg.311 ]




SEARCH



Aqueous solution redox potentials

Calculating Equilibrium Potentials of Solutions Containing Several Redox Couples

General Case Equilibrium Potential of a Solution Containing Two Redox Couples

Potential of a Solution Containing Only One Redox Couple

Redox potential semiconductor-solution interface

Redox potentials

Solution potentials

© 2024 chempedia.info