Redox enzyme catalytic cycles

A quantitative model for the electrocatalyitic response of enzymatic amperometric biosensors requires consideration of the diffusion of all the involved species and the kinetics of the redox-enzyme catalytic cycle, as is depicted in Figure 2.27. 

One of the most used systems involves use of horseradish peroxidase, a 3-diketone (mosl commonly 2,4-pentandione), and hydrogen peroxide." " " Since these enzymes contain iron(II), initiation may involve decomposition of hydrogen peroxide by a redox reaction with formation of hydroxy radicals. However, the proposed initiation mechanism- involves a catalytic cycle with enzyme activation by hydrogen peroxide and oxidation of the [3-diketone to give a species which initiates polymerization. Some influence of the enzyme on tacticity and molecular... 

Assuming that the enzymatic reaction is highly enantioselective, then even after only four cycles the enantiomeric excess will have reached 93.4% whereas after seven catalytic cycles the enantiomeric excess is >99% (Figure 5.3). This type of deracemization is really a stereoinversion process in that the reactive enantiomer undergoes stereoinversion during the process. One of the challenges of developing this type of process is to find conditions under which the enzyme catalyst and chemical reactant can coexist, particularly in the case of redox chemistry in which the coexistence of an oxidant and reductant in the same reaction vessel is difficult to achieve. For this... 

The one-electron reduction of the Ni-C form results in the diamagnetic species Ni-R. From the redox titration studies of Lindahl s group, a plausible catalytic cycle can be postulated where the enzyme in the Ni-Sl state binds H2 (77) and becomes the two-electron more reduced Ni-R state. Sequential one-electron oxidations from Ni-R to Ni-C and then to Ni-Sl will close the cycle (Fig. 6). The various redox states differ not only in the extent of their reduction, but also in their protonation, as shown by the pH dependence of their redox potentials (87). It is remarkable that both EPR (which monitors the magnetic... 

The discovery of a new heterodinuclear active site in [NiFe] hydro-genases opens the way for the proposal of catalytic cycles based on the available spectroscopic data on the different active site redox states, namely EXAFS studies that reveal that the Ni-edge energy upon reduction of the enzyme supports an increase in the charge density of the nickel (191). 

MnP is the most commonly widespread of the class II peroxidases [72, 73], It catalyzes a PLC -dependent oxidation of Mn2+ to Mn3+. The catalytic cycle is initiated by binding of H2O2 or an organic peroxide to the native ferric enzyme and formation of an iron-peroxide complex the Mn3+ ions finally produced after subsequent electron transfers are stabilized via chelation with organic acids like oxalate, malonate, malate, tartrate or lactate [74], The chelates of Mn3+ with carboxylic acids cause one-electron oxidation of various substrates thus, chelates and carboxylic acids can react with each other to form alkyl radicals, which after several reactions result in the production of other radicals. These final radicals are the source of autocataly tic ally produced peroxides and are used by MnP in the absence of H2O2. The versatile oxidative capacity of MnP is apparently due to the chelated Mn3+ ions, which act as diffusible redox-mediator and attacking, non-specifically, phenolic compounds such as biopolymers, milled wood, humic substances and several xenobiotics [72, 75, 76]. 

As ascribed, the EPR spectrum with g = 2.10 can be low-spin Fec(III). When the isolated enzyme is reductively titrated this signal disappears at a potential Emj -0.3 V [65]. This would seem to indicate that the putative Fec(III) form is not relevant, at least not to hydrogen-production activity. The cubane is a one-electron acceptor as it can shuttle between the 2+ and 1 + oxidation states. Therefore, if the active center were to take up a total of two electrons, then the oxidation state of the Fec would, as least formally, shuttle between II and I. Recently, a redox transition in Fe hydrogenase with an Em below the H2/H+ potential has been observed in direct electrochemistry [89]. This superreduced state has not been studied by spectroscopy. It might well correspond to the formal Fec(I) state. For NiFe hydrogenases Fec(I) has recently been proposed as a key intermediate in the catalytic cycle [90] (cf. Chapter 9). 

The occurred activated complex may induce formation of either epoxide or allyl alcohol. However, under current experimental conditions the biomimic possesses exclusive epoxi-dizing ability, and the catalytic cycle is completed at this stage. The number of cycles per perFTPhPFe(III)OH mole under optimal process conditions is 80 per hour [82], This example of the mimetic catalysis indicates the unity of acidic-basic and redox mechanisms typical of the enzyme catalysis. 

---