Reaction mechanisms, phase-transfer catalysis

The reaction with ammonia or amines, which undoubtedly proceeds by the SnAt mechanism, is catalyzed by copper and nickel salts, though these are normally used only with rather unreactive halides. This reaction, with phase-transfer catalysis, has been used to synthesize triarylamines. Copper ion catalysts (especially cuprous oxide or iodide) also permit the Gabriel synthesis (10-61) to be... 

Rabinovitz, M., Y. Cohen, and M. Halpem, Hydroxide Ion Initiated Reactions Under Phase Transfer Catalysis Conditions Mechanism and Implications, Chem., Int. Ed. En., 25, 960 (1986). 

The reaction between acyl halides and alcohols or phenols is the best general method for the preparation of carboxylic esters. It is believed to proceed by a 8 2 mechanism. As with 10-8, the mechanism can be S l or tetrahedral. Pyridine catalyzes the reaction by the nucleophilic catalysis route (see 10-9). The reaction is of wide scope, and many functional groups do not interfere. A base is frequently added to combine with the HX formed. When aqueous alkali is used, this is called the Schotten-Baumann procedure, but pyridine is also frequently used. Both R and R may be primary, secondary, or tertiary alkyl or aryl. Enolic esters can also be prepared by this method, though C-acylation competes in these cases. In difficult cases, especially with hindered acids or tertiary R, the alkoxide can be used instead of the alcohol. Activated alumina has also been used as a catalyst, for tertiary R. Thallium salts of phenols give very high yields of phenolic esters. Phase-transfer catalysis has been used for hindered phenols. Zinc has been used to couple... 

The reaction of an a-halo sulfone with a base to give an alkene is called the Ramberg-Bdcklund reaction. The reaction is quite general for a-halo sulfones with an (x hydrogen, despite the unreactive nature of a-halo sulfones in normal 8 2 reactions (p. 437). Halogen reactivity is in the order I>Br>Cl. Phase-transfer catalysis has been used. In general, mixtures of cis and trans isomers are obtained, but usually the less stable cis isomer predominates. The mechanism involves formation of an episulfone, and then elimination of SO9. There is much evidence for... 

Partitioning of carbocations between addition of nucleophiles and deprotonation, 35, 67 Perchloro-organic chemistry structure, spectroscopy and reaction pathways, 25, 267 Permutational isomerization of pentavalent phosphorus compounds, 9, 25 Phase-transfer catalysis by quaternary ammonium salts, 15, 267 Phosphate esters, mechanism and catalysis of nucleophilic substitution in, 25, 99 Phosphorus compounds, pentavalent, turnstile rearrangement and pseudoration in permutational isomerization, 9, 25... 

Reactions performed under two-phase conditions are further complicated by the partitioning of the reactants and catalyst over the two phases. In the case of quaternary ammonium phase-transfer catalysis, the mechanistic aspects have received a great deal of attention (Brandstrom, 1977 Makosza, 1975 Starks and Owens, 1973). In contrast, the mechanism of crown ether-type phase-transfer catalysis has hardly been investigated at all, despite its... 

Thioethers (sulfides) can be prepared by treatment of alkyl halides with salts of thiols (thiolate ions).7S2 R may be alkyl or aryl. As in 0-35, RX cannot be a tertiary halide, and sulfuric and sulfonic esters can be used instead of halides. As in the Williamson reaction (0-12), yields are improved by phase-transfer catalysis.753 Instead of RS ions, thiols themselves can be used, if the reaction is run in benzene in the presence of DBU (p. 1023).754 Neopentyl bromide was converted to Me3CCH2SPh in good yield by treatment with PhS in liquid NH3 at -33°C under the influence of light.755 This probably takes place by an SrnI mechanism (see p. 648). Vinylic sulfides can be prepared by treating vinylic bromides with PhS in the presence of a nickel complex,756 and with R3SnPh in the presence of Pd(PPh3)4.757 R can be tertiary if an alcohol is the substrate, e.g,758... 

Compounds containing a CH2 bonded to two Z groups (as defined on p. 464) can be converted to diazo compounds on treatment with tosyl azide in the presence of a base,164 The use of phase transfer catalysis increases the convenience of the method.165 p-Dodecylbenzenesul-fonyl azide,166 methanesulfonyl azide,167 and p-acetamidobenzenesulfonyl azide168 also give the reaction. The reaction, which is called the diazo transfer reaction, can also be applied to other reactive positions, e.g., the 5 position of cyclopentadiene.169 The mechanism is probably as follows ... 

Enol lactones with a halogen at the vinylic position have been synthesized as potential mechanism-based inactivators of serine hydrolyases <81JA5459). 5-Hexynoic acids (181) can be cyclized with mercury(II) ion catalysis to y-methylenebutyrolactones (182) (Scheme 41). Cyclization of the 6-bromo and 6-chloro analogues leads stereospecifically to the (Z)-haloenol lactones (trans addition) but is quite slow. Cyclization of unsubstituted or 6-methyl or 6-trimethylsilyl substituted 5-hexynoic acids is more rapid but alkene isomerization occurs during the reaction. Direct halolactonization of the 5-hexynoic acids with bromine or iodine in a two-phase system with phase transfer catalysis was successful in the preparation of various 5-halomethylene- or 5-haloethylidene-2-phenylbutyrolactones and 6-bromo-and iodo-methylenevalerolactones (Scheme 42). 

The fate of the onium carbanion Q+R incorporated into the organic phase depends on the electrophilic reaction partner. The most studied area in the asymmetric phase-transfer catalysis is that of asymmetric alkylation of active methylene or methine compounds with alkyl halides, in an irreversible manner. The reaction mechanism illustrated above is exemplified by the asymmetric alkylation of glycine Schiff base (Scheme 1.5) [8]. 

Scheme 8.1 also illustrates an important feature of asymmetric phase-transfer catalysis, namely that the catalyst is involved in two different steps of the mechanism. Thus, the rate of reaction increases because the catalyst accelerates the substrate deprotonation step, but the asymmetric induction occurs during the subsequent enolate alkylation step. 

---