Racemization amount

The cyclic steady state SMB performance is characterized by four parameters purity, recovery, solvent consumption, and adsorbent productivity. Extract (raffinate) purity is the ratio between the concentration of the more retained component (less retained) and the total concentration of the two species in the extract (raffinate). The recovery is the amount of the target species obtained in the desired product stream per total amount of the same species fed into the system. Solvent consumption is the total amount of solvent used (in eluent and feed) per unit of racemic amount treated. Productivity is the amount of racemic mixture treated per volume of adsorbent bed and per unit of time. 

Chirality has shown that at least some POPs are not likely to be biotransformed by some fish species. Some legacy POPs were racemic in fish, such as the toxaphene congener B7-1453 in cod liver oil [214], as well as cis- and ira 5 -chlordane, a-HCH, o,p -DDT, and photodieldrin in fish oils purchased from various countries [215]. Arctic cod Boreogadus saida) also had racemic amounts of a-HCH, cis- and ira 5-chlordane, U82, MC-5, and MC-7 [190, 216], as well as MC-6 [216] and PCBs [192]. Emerald rockcod (Trematomus bernacchii) in the Antarctic also had racemic residues of a-HCH [195]. 

The enthalpies of activation of racemization amounted to 34.1 kcal mol" in the case of 2-methyl-3,3-diphenyloxaziridine, but only to 27.7 kcal mol in the case of the Al-t-butyl compound the entropies of activation were -1-5 and -)-6 cal mol deg respectively. Further investigations into the dependence of racemization on N- and C-substituents of the oxaziridine ring were carried out by Bjorgo and Boyd. ... 

Figure 7 7 shows why equal amounts of (R) and (5) 1 2 epoxypropane are formed m the epoxidation of propene There is no difference between the top face of the dou ble bond and the bottom face Peroxyacetic acid can transfer oxygen to either face with equal facility the rates of formation of the R and S enantiomers of the product are the same and the product is racemic... 

Although Pasteur was unable to provide a structural explanation—that had to wait for van t Hoff and Le Bel a quarter of a century later—he correctly deduced that the enantiomeric quality of the crystals was the result of enantiomeric molecules The rare form of tartanc acid was optically inactive because it contained equal amounts of (+) tartaric acid and (—) tartaric acid It had earlier been called racemic acid (from Latin racemus meaning a bunch of grapes ) a name that subsequently gave rise to our pres ent term for an equal mixture of enantiomers... 

These protons show a single chemical shift in the NMR spectrum. This is called a racemic (subscript r) structure, since it contains equal amounts of D and L character. In the next section we shall discuss the NMR spectra of stereoregular polymers in more detail. 

EinaHy, kinetic resolution of racemic olefins and aHenes can be achieved by hydroboration. The reaction of an olefin or aHene racemate with a deficient amount of an asymmetric hydroborating agent results in the preferential conversion of the more reactive enantiomer into the organoborane. The remaining unreacted substrate is enriched in the less reactive enantiomer. Optical purities in the range of 1—65% have been reported (471). 

The subject was then fully investigated by Pyman, who found that the products obtained depended partly on the material started with and partly on the conditions of the experiment. Thus under his conditions, Z-canadine methohydroxide when dried in vacuo gave rise to three anhydro-bases, a and b optically inactive, and c optically active whilst the methohydroxide of the dZ-base formed only two, a and Z , but the proportion of b formed in this instance was equal to the amount of b and c together in the case of the Z-base (canadine). For this and other reasons b was regarded as the racemic form of c and, like it, is represented by F (R = Me),... 

In the desulfurization of 3-substituted thiophenes several stereoisomers may be formed in certain cases. Both meso and racemic compounds have been obtained from the desulfurization of 3,4-diaryl-substituted thiophenes. It is claimed, however, that only meso, -diphenyladipic acid is obtained upon desulfurization of 3,4-di-phenyl-2,5-thiophenedicarboxylic acid and only di-isoleucin from 3-thienylglycine. The formation of small amounts of dimeric products in the desulfurization has been discussed with reference to the mechanism of this reaction. ... 

Among the J ,J -DBFOX/Ph-transition(II) metal complex catalysts examined in nitrone cydoadditions, the anhydrous J ,J -DBFOX/Ph complex catalyst prepared from Ni(C104)2 or Fe(C104)2 provided equally excellent results. For example, in the presence of 10 mol% of the anhydrous nickel(II) complex catalyst R,R-DBFOX/Ph-Ni(C104)2, which was prepared in-situ from J ,J -DBFOX/Ph ligand, NiBr2, and 2 equimolar amounts of AgC104 in dichloromethane, the reaction of 3-crotonoyl-2-oxazolidinone with N-benzylidenemethylamine N-oxide at room temperature produced the 3,4-trans-isoxazolidine (63% yield) in near perfect endo selectivity (endo/exo=99 l) and enantioselectivity in favor for the 3S,4J ,5S enantiomer (>99% ee for the endo isomer. Scheme 7.21). The copper(II) perchlorate complex showed no catalytic activity, however, whereas the ytterbium(III) triflate complex led to the formation of racemic cycloadducts. 

The carbonyl carbon of an unsymmetrical ketone is a prochiral center reaction with a Grignard reagent 2 (R 7 R, R") can take place on either face of the carbonyl group with equal chance. The products 8a and 8b are consequently formed in equal amounts as racemic mixture, as long as no asymmetric induction becomes effective ... 

However, it was not until the beginning of 1994 that a rapid (<1.5 h) total resolution of two pairs of racemic amino acid derivatives with a CPC device was published [124]. The chiral selector was A-dodecanoyl-L-proline-3,5-dimethylanilide (1) and the system of solvents used was constituted by a mixture of heptane/ethyl acetate/methanol/water (3 1 3 1). Although the amounts of sample resolved were small (2 ml of a 10 inM solution of the amino acid derivatives), this separation demonstrated the feasibility and the potential of the technique for chiral separations. Thus, a number of publications appeared subsequently. Firstly, the same chiral selector was utilized for the resolution of 1 g of ( )-A-(3,5-dinitrobenzoyl)leucine with a modified system of solvents, where the substitution of water by an acidified solution... 

The screening was performed in a way similar to that of Welch, except that it involved the use of a spectropolarimeter instead of chiral chromatography to determine the selectivity. Equal amounts of the target racemate 17 were added into each of the 16 wells containing beads and the ellipticity of the supernatant liquid in each well was measured after equilibrating for 24 h at the wavelength of the maximum adsorption (260 nm). Knowing the specific ellipticity of one enantiomerically pure... 

Each racemate was applied on a polymer (ca. 0.1. imol per gram dry polymer) imprinted with one antipode of the racemate. Tlie standard mobile phase, consisting of acetonitrile containing various amounts of acetic acid, was used in most cases. Cbz = Carbobenzyloxy, Boc = t-butyloxycarbonyl. 

The analytical capability of these matrices has been demonstrated for chiral amines [12, 13]. The procedure is illustrated in Fig. 8-4 for the separation of NapEtNH " CIO . Concentrated methanol/dichloromethane solutions of the racemic mixture were placed on a column containing the chiral macrocycle host. The enantiomers of the ammonium salts were resolved chromatographically with mixtures of methanol and dichloromethane as the mobile phase. The amounts of R and S salts in each fraction were determined by polarimetry. Because the chiral supported macrocycle interacts more strongly with S salts, the R salt passes through the column first and the S salt last, as seen in Fig. 8-4. 

During product launch and steady-state production, the purifications goal is to treat large amounts of racemate (> 25 tons per year) with total process costs well under the targeted kg drug product price. Moreover, the purifications process must be robust and easy to operate. 

As a general rule, the reaction of a chiral reactant with an achiral reactant leads to unequal amounts of diastereomeric products. If the chiral reactant is optically active because only one enantiomer is used rather than a racemic mixture, then the products are also optically active. 

What products are formed from acid-catalyzed hydration of racemic ( )-4-methyl-1-hexene What can you say about the relative amounts of the products Is the product mixture optically active ... 

---