Pyridine hydrogenation, selective

Other poisons (modifiers) used to create such selective Pd catalysts may be metals 23 Zn, Cd, Zr, Ru, Au, Cu, Fe, Hg, Ag, Pb, Sb, and Sn or solvents (organic modifiers) 24 pyridine, quinoline, piperidine, aniline, diethylamine, other amines, chlorobenzene, and sulfur compounds. Hydroxides have also been used to increase the half-hydrogenation selectivity of Pd. 

Despite their snccess, N-heterocyclic amides are not sufficiently versatile to make them ideal SRs. First, they can form self-complementary amide amide and amide- -pyridine hydrogen bonds, which makes it inherently difBcult to combine any of them with molecules that lack moieties that can compete successfully with such synthons. Second, if the two binding sites are attached to the same backbone (as is the case with isonicotinamide), it is not possible to tune the charges on individual atoms of the two sites independently, which reduces versatility. Thus, there is a need for second-generation SRs that can be refined such that they offer more opportunities for modular supramolecular synthesis through enhanced structural selectivity and specificity. 

Acid-cataly2ed hydroxylation of naphthalene with 90% hydrogen peroxide gives either 1-naphthol or 2-naphthiol at a 98% yield, depending on the acidity of the system and the solvent used. In anhydrous hydrogen fluoride or 70% HF—30% pyridine solution at — 10 to + 20°C, 1-naphthol is the product formed in > 98% selectivity. In contrast, 2-naphthol is obtained in hydroxylation in super acid (HF—BF, HF—SbF, HF—TaF, FSO H—SbF ) solution at — 60 to — 78°C in > 98% selectivity (57). Of the three commercial methods of manufacture, the pressure hydrolysis of 1-naphthaleneamine with aqueous sulfuric acid at 180°C has been abandoned, at least in the United States. The caustic fusion of sodium 1-naphthalenesulfonate with 50 wt % aqueous sodium hydroxide at ca 290°C followed by the neutralization gives 1-naphthalenol in a ca 90% yield. 

Selectivity of propylene oxide from propylene has been reported as high as 97% (222). Use of a gas cathode where oxygen is the gas, reduces required voltage and eliminates the formation of hydrogen (223). Addition of carbonate and bicarbonate salts to the electrolyte enhances ceU performance and product selectivity (224). Reference 225 shows that use of alternating current results in reduced current efficiencies, especiaHy as the frequency is increased. Electrochemical epoxidation of propylene is also accompHshed by using anolyte-containing silver—pyridine complexes (226) or thallium acetate complexes (227,228). 

Cyanide compounds are classified as either simple or complex. It is usually necessary to decompose complex cyanides by an acid reflux. The cyanide is then distilled into sodium hydroxide to remove compounds that would interfere in analysis. Extreme care should be taken during the distillation as toxic hydrogen cyanide is generated. The cyanide in the alkaline distillate can then be measured potentiometricaHy with an ion-selective electrode. Alternatively, the cyanide can be determined colorimetricaHy. It is converted to cyanogen chloride by reaction with chloramine-T at pH <8. The CNCl then reacts with a pyridine barbituric acid reagent to form a red-blue dye. 

Oxidations usually proceed in the dark at or below room temperature in a variety of solvents ranging from aqueous bicarbonate to anhydrous benzene-pyridine. Base is quite commonly used to consume the hydrogen halide produced in the reaction, as this prevents the formation of high concentrations of bromine (or chlorine) by a secondary process. The reaction time varies from a few minutes to 24 hours or more depending on the nature of the reagent and the substrate. Thus one finds that NBS or NBA when used in aqueous acetone or dioxane are very mild, selective reagents. The rate of these oxidations is noticeably enhanced when Fbutyl alcohol is used as a solvent. In general, saturated, primary alcohols are inert and methanol is often used as a solvent. 

Selective fluonnation in polar solvents has proved commercially successful in the synthesis of 5 fluorouracil and its pyrimidine relatives, an extensive subject that will be discussed in another section Selective fluonnation of enolates [47], enols [48], and silyl enol ethers [49] resulted in preparation of a/phn-fluoro ketones, fieto-diketones, heta-ketoesters, and aldehydes The reactions of fluorine with these functionalities is most probably an addition to the ene followed by elimination of fluonde ion or hydrogen fluoride rather than a simple substitution In a similar vein, selective fluonnation of pyridmes to give 2-fluoropyridines was shown to proceed through pyridine difluondes [50]... 

Bhattacharjee et al. [79] introduced another new catalyst based on a Pd complex containing both acetate and benzoyl pyridine ligands (Table 6). This was developed to hydrogenate liquid carboxylated nitrile rubber (L-XNBR) [80]. Selective hydrogenation of C=C in L-... 

The use of molybdenum catalysts in combination with hydrogen peroxide is not so common. Nevertheless, there are a number of systems in which molybdates have been employed for the activation of hydrogen peroxide. A catalytic amount of sodium molybdate in combination with monodentate ligands (e.g., hexaalkyl phosphorus triamides or pyridine-N-oxides), and sulfuric acid allowed the epoxidation of simple linear or cyclic olefins [46]. The selectivity obtained by this method was quite low, and significant amounts of diol were formed, even though highly concentrated hydrogen peroxide (>70%) was employed. 

The observation that addition of imidazoles and carboxylic acids significantly improved the epoxidation reaction resulted in the development of Mn-porphyrin complexes containing these groups covalently linked to the porphyrin platform as attached pendant arms (11) [63]. When these catalysts were employed in the epoxidation of simple olefins with hydrogen peroxide, enhanced oxidation rates were obtained in combination with perfect product selectivity (Table 6.6, Entry 3). In contrast with epoxidations catalyzed by other metals, the Mn-porphyrin system yields products with scrambled stereochemistry the epoxidation of cis-stilbene with Mn(TPP)Cl (TPP = tetraphenylporphyrin) and iodosylbenzene, for example, generated cis- and trans-stilbene oxide in a ratio of 35 65. The low stereospecificity was improved by use of heterocyclic additives such as pyridines or imidazoles. The epoxidation system, with hydrogen peroxide as terminal oxidant, was reported to be stereospecific for ris-olefins, whereas trans-olefins are poor substrates with these catalysts. 

Sulfonic esters are most frequently prepared by treatment of the corresponding halides with alcohols in the presence of a base. The method is much used for the conversion of alcohols to tosylates, brosylates, and similar sulfonic esters. Both R and R may be alkyl or aryl. The base is often pyridine, which functions as a nucleophilic catalyst, as in the similar alcoholysis of carboxylic acyl halides (10-21). Primary alcohols react the most rapidly, and it is often possible to sulfonate selectively a primary OH group in a molecule that also contains secondary or tertiary OH groups. The reaction with sulfonamides has been much less frequently used and is limited to N,N-disubstituted sulfonamides that is, R" may not be hydrogen. However, within these limits it is a useful reaction. The nucleophile in this case is actually R 0 . However, R" may be hydrogen (as well as alkyl) if the nucleophile is a phenol, so that the product is RS020Ar. Acidic catalysts are used in this case. Sulfonic acids have been converted directly to sulfonates by treatment with triethyl or trimethyl orthoformate HC(OR)3, without catalyst or solvent and with a trialkyl phosphite P(OR)3. ... 

Much rarer than the inclusion of phenols is complex formation between alcohols and pyridinomacrocycles. In some combinations (selected macro-cycles and alcohols) complexes could be isolated (Weber and Vogtle, 1980). TTie hydrogen bond formation between pyridines and alcohols is the basis for an application, the additions of alcohols to ketenes catalysed by concave pyridines [13] (Liining et al., 1991b Schyja, 1995). 

---